Lennox Hearth SHADOWDANCETM LSVFSD-24 User's Manual
Contents
1. Figure 9 Completed Installation 8 gas Log Set 24 gas Log Set 30 gas Log Set 4 Printed in U S A 2007 by Lennox Hearth Products P n 750 239M REV B 2007 Lennox reserves the right to make changes at any time without notice in design materials specifications prices and also to discontinue colors styles and products Consult your local distributor for fireplace code information 0 West taft avenue orange ca 928652. NOTE DIAGRAMS amp ILLUSTRATIONS ARE NOT TO SCALE Middle Log Left Top Twig Left Top Log Right Top Log Rear Log Left Front Log Front Ember Bed Right Front Log Rear Ember Bed Center Top Log 750 239M REV B 2007 Log PLacEMEnt InStRUctIonS FoR SHaDoWDancE SERIES gaS LogS SEtS HEARTH PRODUCTS KITS AND ACCESSORIES cat no Model Description H537 LSVFSD 8 Shadowdance 8 Log Set H538 LSVFSD 24 Shadowdance 24 Log Set H539 LSVFSD 30 Shadowdance 30 Log Set WaRnIngS Do not attempt to install the logs until the ap pliance installation has been completed the gas line connected and tested for leaks and the initial burner operation has been checked out If logs are not installed according to the log installa tion instructions flame impingement and improper combustion could occur and result in soot and or excessive production of carbon monoxide co a colorless odorless toxic gas the size and position of the log set was engi neered to give the appliance a safe reliable and attractive flame pattern any attempt to use a different log set with the Shadowdance series gas train models LSVFSD ng oR LSVFSD LP will void the warranty and will result in incomplete combustion sooting and poor flame quality Do not add extra logs or ornaments such as pine cones vermiculite or rock wool Using these added items can cause sooting Do not place any lava rock on logs or bu
3. rners this may cause sooting only place lava rock on floor of fireplace all warnings and precautions in the installation and operation manual provided with the appli ance apply to these instructions gEnERaL InFoRMatIon This log placement instructions addendum has been prepared to assist in the placement of new or replacement log sets The information provided here is to be used in conjunction with the Installation and Operation manual Please read the Care and Operation Instructions completely before completing the procedures detailed in this placement guide If you encounter any problems need clarification of these instructions or are not qualified to properly install this log set contact you local distributor or dealer Read this instruction sheet in its entirety before beginning the installation REtaIn tHESE InStRUctIonS FoR FUtURE REFEREncE REaD IMPoRtant WaRnIngS BEFoRE PRocEEDIng TM The twig indicated is included in the 24 and 30 log sets only The 30 log set also includes 2 ember chunks shown in Figure 9 Log SEt NOTE DIAGRAMS amp ILLUSTRATIONS ARE NOT TO SCALE 2 Log PLacEMEnt InStRUctIonS 1 Place rear ember bed as shown in Figure 1 Figure 1 Install Rear Ember Bed Install Ember bed from behind top burner top Burner Rear Ember Bed 2 Place rear log onto the two rear grate locating pins as shown in Figure 2 the locating pins are outlined in Figure 1 Loca
4. ting Pins Rear Log Rear Locating Pins on grate assembly 3 Place middle log onto left middle grate locating pin and the rear ember bed locating pin as shown in Figure 3 Middle Log Locating Pins 4 Place left and right front logs onto front grate locating pins as shown in Figure 4 Locating Pins Indicated by arrows Right Front Log Left Front Log 5 Place left top log onto rear log and middle log locating pins as shown in Figure 5 6 Place the center top log onto the rear log locating pin and middle log locating pin as shown in Figure 6 Left top Log Locating Pins center top Log Locating Pins Figure 2 Install Rear Log Figure 3 Install Middle Log Figure 4 Install Left and Right Front Logs Figure 5 Install Left Top Log Figure 6 Install Center Top Log Position Ember Bed All the Way Forward in Gas Train Assembly NOTE DIAGRAMS amp ILLUSTRATIONS ARE NOT TO SCALE 3 7 Place the right top log onto rear log locating pin and the right front log locating pin as shown in Figure 7 Right top Log Locating Pins 8 Place Left Top Twig 24 and 30 models only onto corre sponding notch on rear log as shown in Figure 8 The front of the Left Top Twig should be up against and behind the left top log Left top twig Front Ember Bed Figure 7 Install Right Top Log Figure 8 Install Left Top Twig Left top Log 9 Place the front ember bed log as shown in Figure 8
Download Pdf Manuals
Related Search