Kompernass PAS 7 Instruction Manual
Contents
1. Removing the Rechargeable Battery Pack c Press the side release buttons simultaneously and remove the rechargeable battery pack Torque Pre selection The rotary force can be adjusted by means of the torque pre selector 2 The torque levels go up to approximately 9 Nm Once the rotary force that has been set markings 1 15 is reached the clutch disconnects the drive 8 GB IE PARKSIDE Select a low level for small screws and soft ma terials Select a high level for large screws hard materials and when loosening screws If level 16 is selected the clutch does not disconnect the drive The drive chain is locked in place Select this level if you require maximum rotary force Angular Position Illustration A c Press and hold the angular position switch see illustration A Move the device into the angular position no intermediate setting Release the angular position switch Check whether the screwdriver has locked in place in the angular position Changing the Tool Inserting Insert the bit into the tool holder CD Removing Remove the bit from the tool holder CD Switching on off Notice If the rotation direction switch 4 is located in the central neutral position the ON OFF switch 8 is blocked Therefore select a rotation direction before switching on in that the rotation direction switch is pushed through completely switch the screwdr2. 4 J r y d M R PAS 7 2V Operation and Safety Notes Operation and Safety Notes Komperna GmbH Burgstra e 21 D 44867 Bochum Germany Last Information Update 10 2006 Ident No PAS 7 2V 102006 1 UK IE Table Content Before reading unfold the page containing the illustrations and familiarise yourself with all functions of the device The following icons symbols are used in this instruction manual Read instruction manual Direct current of current and voltage Observe caution and safety notes N m Newtonmeter Torque Caution electric shock Rated idle running speed Dangerous electric current danger to life Protection category II gt Amp hours Battery capacity Proper procedure and handling V Voltage Introduction FOP VOURSATOLY EEE E ie b RI EA OA A 6 Intended Use 6 Equipment 6 Scope of Supply 6 Data ann 6 Safety Safety Information Specific to this Device sse Page 7 Initial Use Charging the Battery Page 7 Inserting and Removing the Rechargeable Battery Pack from the Device Page 8 Torque Pre selection seen Page 8 Angular Position 8 Changing the Tool 8 Swi
3. The screwdriver should be stored in a dry closed room to which children do not have access Ww Please keep children away from this Avoid the Danger of Death by Electric Shock A Avoid the Danger of Injury and Fire and Harmful Effects on Health 4 Damaged devices mains leads or mains plugs may cause death by gt electric shock You should therefore check the condition of the screwdriver the fast charging device mains lead mains plug and rechargeable battery pack 9 at regular intervals Any parts that are damaged must not be used In case of danger disconnect the mains plug from the socket immediately The screwdriver should never be opened Al repairs or parts replacements may only be carried out by the service centre or a special ist electrician Please protect the fast charging device 9 rechargeable battery pack 6 and the screwdriver itself against moisture Warning Only the fast charging device rechargeable battery pack 6 supplied may be used Warning The rechargeable battery pack 6 must not be short circuited otherwise overheating fire or bursting of the rechargeable battery pack may result For this reason do NOT connect cables to the poles of the battery pack 6 ensure that the rechargeable battery connectors cannot be short circuited by other metal parts nails screws etc Caution The rechargeable battery pack must never be thrown into a fire or water Da
4. We Komperna GmbH Burgstr 21 D 44867 Bochum Germany declare that this product complies with the following EU directives EG Low Voltage Directive 73 23 EEC Electromagnetic compatibility 89 336 92 31 Applicable harmonised standards EN 60335 1 2002 A1 A11 EN 60335 2 29 EN 50366 EN 55014 1 2000 1 2 EN 55014 2 1997 1 EN 61000 3 2 EN 61000 3 3 1995 1 Description of the product Rechargeable Cordless Screwdriver PAS 7 2V Bochum 31 10 2006 Hans Komperna Managing Director We reserve the right to make technical modifications in the course of further development 10 GB IE PARKSIDE PARKSIDE EN PARKSIDE
5. and bits in particular may be damaged if the selected torque and or speed of the device is too high Maintenance and Cleaning The rechargeable screwdriver is maintenance free The screwdriver should be cleaned regularly immediately upon completion of the work Adry cloth should be used to clean the housing under no circumstances should petrol solvent or other cleaning agents be used B Disposal The packaging is made entirely of recyclable materials which you may dispose of at local recycling facilities Do not dispose of electrical appliances in household waste Es In accordance with European Directive 2002 96 EC on used electrical and electronic appliances and its implementation in national law used power tools must be collected separately and recycled in an eco logically compatible manner Faulty or used rechargeable batteries must be recycled in accordance with Directive 91 157 Please refer to the special safety advice in relation to the charger and battery pack Return the appliance with integrated rechargeable battery via the available collection facilities Information on options for disposing of electrical ap pliances after their useful life can be obtained from your local or city council Information Servicing The service centre for your country is shown in the guarantee documentation PARKSIDE GB E 9 Information Manufacturer s declaration of conformity
6. eable battery pack 6 reaches its full capacity after approx 3 5 charging cycles 1 Insert the mains plug into the socket The green charging control LED lights up PARKSIDE GB E 7 Initial Use 2 Place the battery pack in the fast charging device 9 The green charging control LED ex tinquishes and the red charging control LED 7 now glowing indicates the start of the charging process The red charging control LED extin guishes as soon as the battery pack is fully charged 3 The green charging control LED indicates that charging is complete and the rechargeable battery pack is ready for use 4 Disconnect the mains plug of the fast charging device 9 from the socket Remove the rechargeable battery pack 9 A rechargeable battery pack 6 must never be charged up a second time immediately after the fast charging procedure Otherwise there is a danger that the rechargeable battery pack 6 will be overcharged thus reducing the lifetime of the rechargeable battery pack 6 and the fast charging device G The charging device should be switched off for at least 15 minutes between charging Please remove the mains plug Inserting and Removing the Rechargeable Battery Pack from the Device Inserting the Rechargeable Battery Pack Please move the direction of rotation switch 2 to the lock position and allow the rechargeable battery pack 5 to lock into place in the handle
7. iver on press the ON OFF switch and keep it pressed switch the screwdriver off release the ON OFF switch Setting the Speed The ON OFF switch has a variable speed control Increasing the Speed Increase the pressure on the ON OFF switch Initial Use Maintenance and Cleaning Disposal Information Reducing the Speed Reduce the pressure on the ON OFF switch Reversing the Direction of Rotation Notice If the rotation direction switch 2 is located in the central neutral position the ON OFF switch is blocked The rotation direction is only to be switched when the appliance is at standstill Reverse the direction of rotation by pressing the direction of rotation switch to the right or left Tips and Tricks By simply changing from the angled to the straight position you can work effortlessly in any position see illustration C Particularly when assembling furniture you can reach difficult to access places more easily with the slender device see illustration D When screwing into wood metal and other materials please note the following Before operation check that the scewdriver bit is sitting properly i e is correctly centred in the tool holding fixture CD o Screw bits are marked with their size and type If you are unsure always test first to see if the bit sits firmly and without free play in the tool hold ing fixture CD Torque Small screws
8. nger of Safety Initial Use explosion Handle the rechargeable battery pack 6 carefully and protect it against knocks and jolts Warning If you should come into contact with acid from the rechargeable battery pack the acid must be washed off thoroughly with water without delay If acid should enter your eyes rinse it out immediately with water and seek medical advice immediately m Caution Detection devices should be used to deter mine the position of supply lines so that you do not damage any electrical wiring or gas or water pipes Stay Safe Always disconnect the mains plug before cleaning or maintaining the fast charging device 9 or rechargeable battery pack Never charge the battery pack if the surround ing temperature is below 10 C or above 40 C ventilation holes of the fast charging device should never become blocked Whenever the screwdriver is being adjusted transported or stored please move the direction of rotation switch 2 to the middle position lock in order to prevent the screwdriver switching on accidentally High torques occur when hard surfaces are being screwed into You should therefore hold the screwdriver very tight in order to avoid injury Initial Use Charging the Battery Pack Illustration B Notice A rechargeable battery pack 6 is new or has not been used for a long time has to be charged up before initial renewed use The recharg
9. proper use of this device Not intended for professional use Equipment Tool holder hexagonal 6 35 mm 2 Torque pre selector 3 Switch for angular position 4 Direction of rotation switch lock 5 Bit storage 6 Rechargeable battery pack Button for releasing the battery ON OFF switch speed regulation 9 Fast charging device Green charging control LED Red charging control LED 6 GB IE PARKSIDE Scope of Supply 1 rechargeable cordless screwdriver with rechargeable battery pack 1 quick charging device 3 screw bits hexagonal shaft 6 35 mm 1 carrying case 1 rechargeable battery pack ordering card 1 set of operating instructions 1 General Safety Instructions booklet 1 Guarantee and Service booklet Technical Data Rechargeable Screwdriver Parkside PAS 7 2 V Rated voltage 7 2V DC Rated speed n 0 500 min Tool holder hexagonal 6 35mm Torque levels 16 Max torque 9Nm Sound pressure level lt 70dB Noise level 86 dB A Vibration value lt 2 5m s Rechargeable Battery Pack PAS 7 2V 1 Rated voltage 7 2VDC Nominal capacity 1 3Ah Energy content 9 4Wh Battery Fast Charging Device PAS 7 2V 2 Primary Nominal voltage 230V 50Hz Power consumption 30W Secondary Nominal voltage 7 2VDC Charging current 2000 mA Charging period ca 60 min Protection class I1 E Safety Safety Information Specific to this Device device
10. tching on off 8 SENNO oDBBQ 8 Reversing the Direction of Rotation Page 9 Tips and 9 Maintenance and Page 9 Disposal ee 9 Information T Page 9 Manufacturer s declaration Of Page 10 PARKSIDE GB E 5 Introduction Rechargeable Cordless Screwdriver 57 2 Introduction For your safety Please make sure you familiarise yourself i fully with the way the device works before you use it for the first time and that you understand how to handle electrical power tools cor rectly Further details can be found in the operating instructions In addition to the above you must also observe the general safety advice contained in the accompanying booklet Keep these instructions in a safe place If you pass the device on to anyone else please ensure that you also pass on all the documentation Intended Use This device is intended to be used for screwing into wood plastic and metal It should only be used as described and for the stated fields of application Any other use or modification to this device is deemed contrary to its intended use and harbours a consid erable risk of accidents The manufacturer accepts no liability for damage caused through im
Download Pdf Manuals
Related Search