Kompernass KH 2199 User's Manual
Contents
1. 1 ainsuq gt 4 6 8919 4 82 0480 1 4 SN ppu aspajd gt ZZ 9 Z8Z 0Z80 19 oad 4 4502 3 661 7 861 7 AJUD LIDAA 53JJJ2AJ 5 i 21A P PUD 144 Description of fault2. pressed down 1 Press several times consecutively or press and hold the button HOUR to set the hours 2 Release the button HOUR as soon as the desired hours setting is shown in the display 3 Press several times consecutively or press and hold the button MIN to set the minutes 4 Release the button MIN as soon as the desired minutes setting is shown in the display The adjusted alarm time will be automatically accepted as soon as the button ALARM is released Radio alarm call When the clock is set correctly as described above 1 Adjust the tuning regulator to select the desired radio station 2 Using the sound volume controller OFF BUZZ VOLUME now set the desired sound volume level 3 To activate an alarm call with radio place the switch ALARM ON OFF AUTO at AUTO The symbol for the alarm function 4 and Zz appear in the display At the programmed time the radio switches itself on If you do not touch any other buttons while the alarm is sounding after about a minute the radio switches itself off The radio gives its next alarm call on the following day at the programmed time Snooze Function Pressing the SNOOZE button interrupts the alarm tone for approx 8 minutes For as long as the snooze function is activated the indicator Zz blinks in the display After these 8 minutes the alarm tone is repeated Place the switch ALARM ON OFF AUTO at OFF to switch the alarm fun
3. ALARM ON OFF AUTO into the position OFF Note The radio is only switched off when the switch ALARM ON OFF AUTO is at the positions OFF or AUTO To simply turn the sound volume regulator to very quiet until a Click is heard is not sufficient Setting up the telescope aerial Remove the telescope aerial from its retainer and set it up Extend the telescope aerial completely To improve reception in the FM frequency range slowly turn the end of the telescope aerial in various directions As soon as you have found a position with good reception from your desired radio station leave the telescope aerial in this position For the reception of AM transmissions an antenna is built into the device For improved reception alter the position of the device in radio mode Setting the time Whilst holding the button TIME pressed down 1 Press several times consecutively or press and hold the button HOUR to set the hours 2 Release the bution HOUR as soon as the desired hours setting is shown in the display 3 Press several times consecutively or press and hold the button MIN to set the minutes 4 Release the button MIN as soon as the desired minutes setting is shown in the display The programmed time will be accepted automatically as soon as the button TIME is released Setting the alarm time If the clock is set correctly as described above Whilst holding the button ALARM
4. KOMPERNASS GMBH BURGSTRASSE 21 D 44867 BOCHUM www kompernass com ID Nr KH2198_99 1 1 08 V2 PROJECTION ALARM CLOCK PROJECTION ALARM CLOCK Operating instructions KH 2198 KH 2199 00000 0000 DODDO 0720000 000000 071006006 00000900 INDEX PAGE Safety information 2 Intended Use 4 Items supplied 5 Operating Elements 5 Technical Data 6 Inserting the batteries 7 Placing 8 Operation 8 Cleaning and care 12 Disposal 13 Warranty and Service 13 Read these operating instructions carefully before using the device for first time and preserve this manual for future reference Pass this manual on to whoever might acquire the device at a future date siis PROJECTION ALARM CLOCK KH2198 99 Safety information To avoid potentially fatal injury through electric shock Only use the device in dry rooms Never allow fluids or objects to penetrate into the device Do not place objects containing fluids e g flower vases on the device To avoid burn and other injuries Place the device in an open and well ventilated area so that heat pockets cannot be created within it Never cover the ventilation slits Do not place open fire sources e g candles on the device Avoid close proximity to heat sources e g direct solar radiation h
5. agng materials and the protective foil from the display Operating Elements Projection lens Telescopic antenna Switch ALARM ON OFF AUTO Button SNOOZE Waveband selector FM AM Button PROJECTION LIGHT Display illumination Switch PROJECTION ON OFF Display Sound volume regulator OFF BUZZ VOLUME Connection for 3V power adapter Frequency scale TUNING regulator Button TIME Button ALARM Button MIN Minute Button HOUR Stunde Battery compartment Projection focus FOCUS Technical Data This device has been tested and approved in accordance with the basic require ments and other relevent regulations of the EMC guidelines 2004 108 EC as well as the guidelines for low voltage devices 2006 95 EC Battery operation KH2198 3 x 1 5 V Type Micro AAA LRO3 not supplied for radio operation display illumination and projection KH2199 3 1 5 V Type Mignon AA LRO6 not supplied for radio operation display illumination and projection Operating voltage 3 V Radio operation Projection 1 5 V hour Frequency range FM USW 87 5 108 0 MHz AM MW 530 1600 kHz Mains adapter Mains adapter not supplied Input voltage 230 V 50 Hz Output voltage DC 3V 5 Rated current min 300 mA Polarity eee Even when using 3 V mains adapter a battery must be inserted Otherwise the clock will not function For Model KH2198 Insert the single b
6. attery into the upper part of the battery compartment The two other batteries one above the other power radio operation and the projection For Model 2 199 Insert the single battery into the compartment marked CLOCK USE Important Ensure that you have the correct polarities with the batteries and the power adapter False polarity will damage the device The device can be operated as follows only with batteries with a mains power adapter and a battery for the clock Inserting the batteries KH2198 You require three 1 5 V batteries of the type Micro AAA LRO3 1 Open the cover of the battery compartment on the underside 2 Insert the three batteries into the battery compartment paying heed to the polarity markings shown in the battery compartment Ensure that the black textile strip is positioned under the batteries this will make future battery exchanges easier 3 Close the cover ensuring that it engages KH2199 You require three 1 5 batteries of the type Mignon LRO6 1 Open the cover of the battery compartment on the underside 2 Insert the three batteries into the battery compartment paying heed to the polarity markings shown in the battery compartment 3 Close the cover ensuring that it engages Placing Place the projection clock onto a level surface Position the projection clock such that the projection lens is directed onto an emp
7. ction off com pletely Wakening with the alarm tone When the clock is set correctly as described above 1 Place the sound volume controller OFF BUZZ VOLUME at OFF BUZZ Click will be heard 2 To activate a wake up call with the alarm tone place the ALARM ON OFF AUTO at AUTO The symbol for the alarm function 4 and Zz appear in the display The alarm tone sounds at the programmed time If you do not touch any other buttons while the alarm is sounding after about a minute the alarm tone switches itself off The radio gives its next alarm call on the following day at the programmed time Projection Attention When used properly the radiation from the projection of the display is not at all dangerous However avoid looking directly into the light beam and do not aim the beam at other persons or at animals To display the time correctly on a wall or the ceiling the hinged projection element needs to be swivelled into the correct position and the room must be appropriately darkened 1 Place the PROJECTION ON OFF switch at ON 2 Adjust the projection element as desired The time is projected onto the required position The projection distance is approx 40cm 3m 3 Adjust the clarity of the projection with the projection focus Background lighting for the display and projection A one time pressing of the button PROJECTION LIGHT activates the display illumination and the time projection for appro
8. eaters and other devices etc This device is not intended for use by individuals including children with restricted physical physiological or intellectual abilities or deficiences in experience and or knowledge unless they are supervised by a person responsible for their safety or receive from this person instruction in how the device is to be used Children should be supervised to ensure that they do not play with the device Note Only for KH2199 This device is equipped with non slip rubber pads As floor and furniture upper surfaces comprise of various materials and are cleaned with various types of polishes and or cleaning agents it cannot be completely excluded that some of these substances contain components that could attack the rubber pads and soften them If possible place an anti slip material under the pads of the device Note In certain countries there could be exceptional regulations for the allocated radio frequency ranges Take note that you may not exploit irregularly received radio services pass them on to third parties or improperly misuse them A Information regarding the handling of batteries The device uses batteries When handling batteries please observe the following Explosion Hazard Do not throw batteries into a fire Do not recharge the batteries Never open batteries never solder or weld batteries The risk of explosions and injuries exists Regularly check the condition o
9. f the batteries Leaking batteries can cause damage to the device e If you do not intend use the device for an extended period remove the batteries In the event of the batteries leaking acids put on a pair of protective gloves e Clean the battery compartment and the battery contacts with a dry cloth Keep batteries away from children Children could put batteries into their mouths and swallow them If a battery is swallowed medical assistance must be sought IMMEDIATELY A Important No liability warranty claims will be considered for damage to the device caused by the effects of moisture water penetration or overheating Intended Use This device is designed to wake you by means of an alarm tone or radio and also for the reception of radio transmissions Any other usage of or modifi cation to the device is deemed to be improper usage and carries the risk of serious personal injury The manufacturer accepts no liability for damages that result from an improper use of the device or that are caused by an in correct operation of it It is not intended for commercial use Items supplied 1 Projection alarm clock with radio 1 Operating manual The batteries and a 3V mains adaptor accessories required for operation are not included in the supply After unpacking the device immediately check to determine that all listed items are present and that the device is in a faultless condition Remove all pack
10. omplaint please contact our Service Hotline In the event that processing of your complaint is not possible by telephone you will receive e a processing number RMA number as well as e an address to which you can send your product for warranty processing In the case of a mail in shipment please enclose a copy of the purchase re ceipt sales slip The device must be securely packed and the RMA number clearly visible Products sent in without the RMA number cannot be processed Note The warranty provisions cover only material or factory defects The warranty is not valid e for worn out parts for damages to breakable parts such as switches and batteries This product is for private use only and is not intended for commercial use The warranty is void in the case of abusive and improper handling use of force and internal modifications not carried out by our authorized Service Centre Your statutory warranty claims are not restricted by this warranty Importer KOMPERNASS GMBH BURGSTRASSE 21 D 44867 BOCHUM WWW kompernass com MMM 96086581 6500 04 10 Z9 66 Z8 0 5800 191 ysu GD ainyouBis aj0q 1 1511 SWDU 150 sp jd Apupy dijs 0 5
11. ty surface The distance from the projection lens to the projection area ceiling or wall must lie between 0 4 m and 3 m With KH2198 Projection of the time must be directed to an area lying behind the projection alarm clock Otherwise the time will be shown back to front With KH2199 Projection of the time must be directed to an area lying in front of the projection alarm clock Otherwise the time will be shown back to front Operation Connect the external mains adaptor This device can be operated with an external mains adaptor Please use only mains adaptors that meet these specifications Input voltage 230 V 50 Hz Output voltage DC 3V 5 Rated current min 300 mA Polarity eee Attention Make certain that the polarity is correct both for the batteries as well as for the mains adaptor Take note of the markings on the 3V direct current connection False polarity will damage the device Radio operation 1 Slide the switch ALARM ON OFF AUTO into the position ON 2 To switch on turn the volume controller OFF BUZZ VOLUME until an audible Click is heard 3 Using the volume controller OFF BUZZ VOLUME now set the desired sound volume level 4 Place the waveband selector switch at the desired frequency range FM AM 5 Adjust the tuning regulator to select the desired radio station The frequencies can be read off from the frequency scale 6 To switch off slide the switch
12. x 10 seconds Cleaning and care Attention Never permit fluids to permeate inside the device The device could also be irreparably damaged Keep the device and the ventilation openings clean at all times Use a soft cloth to clean the device housing Never use detergents or solvents that could damage plastics Check the state and charge condition of the inserted batteries at least once a year Disposal Do not dispose of the device in your normal domestic waste This product is subject to the provisions of European Directive m 2002 96 Dispose of the device through an approved disposal centre or at your community waste facility Observe the currently applicable regulations In case of doubt please contact your waste disposal centre Disposal of batteries accumulators Used batteries rechargeable batteries may not be disposed of in household waste All consumers are statutorily obliged to dispose of batteries at a collection site of their community city district or at a retail store The purpose of this obligation is to ensure that batteries are disposed of in non polluting manner Only dispose of batteries when they are fully dis charged Dispose of all packaging materials in an environmentally friendly manner Warranty and Service You receive a 3 year warranty for this device as of the purchase date Should you in spite of our high quality standards have grounds for c
Download Pdf Manuals
Related Search