Kambrook KCE520 User's Manual
Contents
1. KAMBROOK THE SMARTER CHOICE Heater Instruction Booklet KCE520 Important Please retain your instruction book for future use In the event that you need some assistance with your Kambrook appliance please contact our Customer Service Department on 13800 139 798 Australia or 09 271 3980 New Zealand Alternatively visit us on our website at www kambrook com au Contents Kambrook Recommends safety First Your Ceramic Heater Quick Start Guide Using Your Ceramic Heater Care and Cleaning Warranty Details o4 010 O p8 pll p012 Kambrook Recommends Safety First IMPORTANT Please retain your instruction book for future use At Kambrook we believe that safe performance is the first priority in any consumer product so that you our valued customer can confidently use and trust our products We ask that any electrical appliance that you use be operated in a sensible fashion with due care and attention placed on the following important operating instructions Important Safeguards For Your Kambrook Ceramic Heater Avoid touching heater body while it is on some parts of the heater are hot When moving the unit switch off and hold the heater by the handles where provided Keep combustible materials such as drapes and other furnishings at least 1 7 metres from the front sides and rear of the heater Do not use heater to dry your laundry WARNING In order to i0 0 Kol dal 1o Li laro mele2. mode Turning the heater on Plug the cord Switch on the Press the The heater will Press the MODE into a 230V or unit using the POWER SWING start operating button to 240V power ON OFF switch button to at the LOW heat select the HIGH point and activate setting heat setting switch on and retain a comfortable temperature for your room Setting the variable temperature Setting the Turning the oscillation heater off Press the Press the Press the Press and hold Press the ON MODE button VARIABLE POWER SWING the POWER OFF switch to to select AUTO TEMPERATURE button to SWING button turn the heater setting button to activate the to place the off increase the oscillation Press heater in temperature again to stop standby mode or press the the oscillation VARIABLE TEMPERATURE button to decrease the temperature Hints Tips to Retain Heat in doors and only heat the main living areas e Fit window coverings like curtains to halve Your Home winter heot loss i e Don t overheat your home The Put draft stoppers such as a rolled up towel temperature of a heated room in winter at the bottom of outside doorways to keep should be 18 21 C out cold air e Your heater will work more efficiently if Keep the heat in and the cold out by you stick to Kambrook s recommended installing wall and ceiling insulation clearance spaces e Avoid placing items too close to the heater e Choose the
3. not cover the heater A Extreme caution and supervision is necessary when this heater is used by or near children invalids or animals This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do not play with the appliance Important this heater is intended for floor use only Do not mount on ceiling or walls Do not leave heater unattended Always switch off the heater at the controls and at the power outlet then unplug heater from the power outlet when not in use Do not operate heater whilst asleep Do not operate any heater with a damaged cord or plug or if heater has been dropped or damaged in any manner Return heater to your nearest service centre for examination electrical or mechanical adjustment or repair Do not use outdoors This heater is not intended for commercial use such as construction sites Do not locate the heater immediately below a socket outlet when in use Do not use this heater with a programmer timer or any other device that switches the heater on automatically Since a fire risk may exist if the heater is covered or positioned incorrectly This heater is not intended for use in wet or mo
4. please contact our Customer Service Department on 1300 139 798 Australia or 09 271 3980 New Zealand Alternatively visit us on the website at www kambrook com au Your Purchase Record Please Complete Date Of Purchase Model Number Serial Number Kambrook 12 Month Replacement Warranty Attach a copy of the purchase receipt here Please don t return purchase record until you are making a claim Register your warranty at www kambrook com au service asp Kambrook Australia Building 2 Port Air Industrial Estate 1A Hale Street Botany NSW 2019 Australia Customer Service Line 1300 139 798 Customer Service Fax 1800 621 337 Kambrook New Zealand Private Bag 94411 Botany Manukau Auckland 2141 New Zealand Customer Service Line Spare Parts 0800 273 845 or 09 271 3980 Customer Service Fax 0800 288 513 Due to continual improvement in design or otherwise the product you purchase may differ slightly from the illustration in this book Issue 1 10 KAMBROO THE SMARTER CHOICE
5. LOW Low heat setting 1100 watts AUTO for use with the electronic thermostat FAN for fan only operation To switch the heater into standby mode press and hold the POWER SWING amp button until a beep sound is heard Turn the heater off by switching the Power switch located on the right hand side of the base to the off position NOTE This heater features a tip over switch If the heater tips over it will automatically switch off Once placed back into the upright position the heater will be in standby mode and the settings will need to be selected again Setting the Variable Temperature The variable temperature can be used to maintain your desired temperature NOTE The variable temperature only operates when the heater is being used in the Auto mode Press the MODE button until the heater is set to AUTO mode The LCD screen will display the default temperature of 25 C and will flash When the temperature is flashing you may set the desired temperature pressing the VARIABLE TEMPERATURE buttons on the control panel To adjust the set temperature press the VARIABLE TEMPERATURE button to increase the desired temperature or press the VARIABLE TEMPERATURE button to decrease the desired temperature The temperature can be set between 15 C and 35 C When the air temperature reaches 2 3 C above the set temperature the heater will automatically cut out although the fan wi
6. atutory warranties may still apply This Warranty card and the purchase receipt for this product are to be retained as proof of purchase and must be presented if making a claim under the Kambrook Replacement Warranty Please note that under any applicable statutory warranty you are not required to produce these documents but may be required to provide a proof of purchase Kambrook warrants the purchaser against defects in workmanship and material for a period of 12 months domestic use from the date of purchase or 3 months commercial use The Kambrook Replacement Warranty does not apply to any defect deterioration loss injury or damage occasioned by or as a result of misuse or abuse negligent handling or if the product has been used other than in accordance with the instructions The Kambrook Replacement Warranty excludes breakables such as glass and ceramic items consumable items and normal wear and tear This Kambrook Replacement Warranty is void if there is evidence of the product being tampered with by unauthorised persons If the product includes one or a number of accessories only the defective accessory or product will be replaced Subject to your statutory rights in the event of Kambrook choosing to replace the appliance the Kambrook Replacement Warranty will expire at the original date i e 12 months from the original date of purchase In the event that you need some assistance with your Kambrook appliance
7. e heater and inspect the air inlet and outlet for blockages Wait for the heater to cool for the protection system to reset before attempting to restart the heater 10 Care and Cleaning Ensure that the heater is switched off and disconnected from the power point before cleaning Use a clean dry cloth to clean the external surfaces of the heater If the heater has collected dust or dirt inside the unit or around the elements have the unit cleaned by a qualified service agent Do not operate the heater in this condition Do not attempt to open the case of the heater at any time as there are no customer serviceable parts inside When not in use store the heater preferably in its original box in a cool clean and dry location 11 Kambrook 12 Month Replacement Warranty In Australia this Kambrook Replacement Warranty does not affect the mandatory statutory rights implied under the Trade Practices Act 1974 and other similar State and Territory legislation relating to the appliance It applies in addition to the conditions and warranties implied by that legislation In New Zealand this Kambrook Replacement Warranty does not affect your mandatory statutory rights implied under the Consumer Guarantees Act 1993 in relation to the appliance It applies in addition to the conditions and guarantees implied by that legislation This Kambrook Replacement Warranty is valid only in the country of purchase but other st
8. ed in any way Return the entire appliance to the nearest authorised Kambrook service Centre for examination and or repair or contact Customer Service on 1300 139 798 Any maintenance other than cleaning should be performed at an authorised Kambrook Service Centre This appliance is for household use only Do not use this appliance for anything other than its intended use Do not use in moving vehicles or boats Do not use outdoors Misuse may cause injury The installation of a residual current device safety switch is recommended to provide additional safety protection when using electrical appliances It is advisable that a safety switch with a rated residual operating current not exceeding 30mA be installed in the electrical circuit supplying the appliance See your electrician for professional advice Your Ceramic Heater m 1800 watt ceramic heating element for efficient heating LCD screen ThermoGuard protection for peace of mind Control Panel Convenient 8hr auto off timer 2 heat setting plus auto mode and fan only setting Power Swing button to turn the heater on and off and activate the 90 degree oscillation for warmth throughout the room Variable temperature buttons to maintain your desired temperature setting Power on indicator Not Shown Convenient carry handle safety tip over cut out switch On Off switch THERMO amp GUARD PROTECTED Quick Start Guide Setting the heating
9. ist locations Do not use this heater in the immediate surroundings of a bath a shower or a swimming pool Do not immerse or allow liquids to be spilt on heater This heater has hot and arcing or sparking parts inside Do not use in areas where petrol paints aerosols or other inflammable substances are used or stored Do not operate the heater with the power cord damaged frayed or split wound around any part of the heater or in contact with heated surfaces of the heater Do not allow materials that have been in contact with oil petroleum based products or drying fluids to come in contact with the heater Do not run the cord under carpeting or cover the cord with rugs runners or the like Arrange cord away from traffic areas and where it will not be tripped over To disconnect heater turn the power to OFF then turn the control switch to off Turn off at the power outlet then remove the plug from its outlet Do not insert or allow foreign objects to pass through the inlet or outlet openings This may cause an electric shock fire or damage the heater To prevent a possible fire or heat damage allow ample space around the heater 1 7m at front and 0 5m at the rear top and sides and do not totally or partially block the air inlet or outlets in any manner Check the openings from time to time for accumulated dust Ensure long shag carpet does not obstruct airflow under the unit Do not touch hot surfaces
10. ll continue to run for approximately 20 seconds to cool the heater When the air temperature drops below the set temperature the unit will begin heating again Setting the Oscillation The oscillation function works in all operating modes Press the POWER SWING amp button once to activate the oscillation The heater will begin to oscillate from side to side Press the POWER SWING amp button again to stop the heater from oscillating Setting the Auto Off Timer The timer function works in all operating modes and switches the unit off affer a preset number of hours Press the TIMER button to activate the timer settings A timer symbol will appear on the LCD screen displaying 1 hour Press the TIMER button to cycle through the one hour increments up to 8 hours The unit will then switch itself to standby mode after the selected number of hours has passed Safety Features This heater includes an audible alarm to warn that parts of the heater are overheating If the alarm sounds immediately turn the heater off and insoect for any objects on or adjacent to the heater that may cause high temperature DO NOT OPERATE THE HEATER WITH THE ALARM SOUNDING Using Your Ceramic Tower Heater continued ThermoGuard Overheating Safety Device THERMO GUARD PROTECTED Your heater is fitted with a safety device that switches off the heater in the event of overheating Should this heater stop working turn off th
11. right size heater for the room both at the front and back for optimal type you want to heat air flow e Zone off unoccupied rooms by closing Using Your Ceramic Heater Before First Use Remove any promotional material or packaging from the heater Unwind the cord fo its full length and place the heater on a firm level surface in a stable upright position Visually inspect the air inlet and outlets to ensure there are no blockages Turning Your Heater On Plug the cord into a 230V or 240V power point and switch on NOTE To avoid an electrical circuit overload it is recommended that no other appliances are plugged into the same circuit as your heater when it is in use Turn the heater on by switching the On Off switch located on the left hand side of the base to the on position An audible beep will sound and the red power indicator light will illuminate The heater is now in standby mode Setting the Heating Mode To activate the heater press the POWER SWING amp button The heater will start operating on the LOW heat setting 1100 watts and the LCD screen will illuminate displaying the ambient room temperature and heat setting NOTE After several seconds the LCD screen will fade but the heater settings will remain visible Use the MODE button to select the desired heat setting Ihe mode button allows you to scroll through the various heating modes HIGH High heat setting 1800 watts
12. switch off at the control switch and power outlet then unplug and allow heater to cool down before cleaning or storing Use this heater only as described in this instruction manual Any other use not recommended by the manufacturer may cause fire electric shock or injury and voids all warranties Regularly inspect the supply cord plug control settings air inlets and outlets and main housing for any damage If found damaged in any way immediately cease use of the heater and return to Kambrook or an authorised service agent for inspection or repair NOTE This Kambrook Ceramic Heater is electronically controlled and will not operate until the heater is plugged into a 230V or 240V power point and switched on Important Safeguards For All Electrical Appliances Fully unwind the power cord before use Do not let the power cord hang over the edge of a bench or table touch hot surfaces or become knotted The appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do not play with the appliance It is recommended to regularly inspect the appliance To avoid a hazard do not use the appliance if power cord power plug or appliance becomes damag
Download Pdf Manuals
Related Search