Home
Jwin JX-CD7000 User's Manual
Contents
1. 1 POWER BUTTON 12 AM FM FM ST SWITCH 2 STANDBY 13 CD RADIO SWITCH 3 IR SENSOR 14 CD DOOR OPEN BUTTON 4 POWER INDICATOR MUTE INDICATOR 15 HEADPHONE JACK 5 CD DISPLAY BUTTON 16 DISPLAY WINDOW 6 SKIP SEARCH BUTTON 17 TUNING KNOB 7 REPEAT BUTTON 18 SPEAKER TERMINAL 8 STOP BUTTON 19 AC POWER CORD 9 PLAY PAUSE BUTTON 20 FM ANTENNA 10 VOLUME UDOWN amp UP BUTTON 21 MOUNTING HOLE 11 BASS ON OFF SWITCH A REMOTE CONTROL 1 POWER BUTTON 2 PLAY PAUSE BUTTON 3 STOP BUTTON 4 SKIP SEARCH BUTTON 5 REPEAT BUTTON 6 CD DISPLAY BUTTON 7 MUTE BUTTON 8 VOLUME DOWN UP BUTTON PUTTING THE BATTERIE INTO THE REMOTE CONTROL UNIT gt BATTERY NOT INCEUDENSE Press down of the compartment cover and slide the cover off open the compartment Place the two accessory UM3 AA R6 batteries in the remote control according to the polarity markings and inside the compartment and on the batteries Place the cover over the compartment press down lightly and push it upward until it snaps on UK 2 FM ANTENNA FM antenna wire for better FM reception ADJUSTING THE SOUND Press the volume buttons to set the sound level For increased bass at all volume levels switch the BASS SWITCH on to boost the low frequency sound To mute the sound press MUTE button on the remote control the POWER ON indicator will flash To resume the sound press the MUTE but
2. Do not touch the lens UK 4 CD DISPLAY WINDOW PLAY INDICATOR O gt REPEAT INDICATOR REPEAT PLAY TRACK NUMBER DISPLAY When playing CD if you desire to repeat the same track only press REPEAT button once and the REPEAT display will light up and flash If repeat all press the REPEAT button twice and the REPEAT display will light up and not flash To cancel repeat play press the STOP button twice until the repeat indicator disappeared SPECIFICATION POWER SUPPLY OUTPUT POWER UNIT DIMENSION SPEAKER DIMENSION N W RADIO SECTION FREQUENCY RANGE CASSETTE SECTION TAPE SPEED FREQUENCY RESPONSE COMPACT DISC SECTION OPTAICAL PICKUP FREQUENCY RESPONSE AC 230V 50Hz DC 12V 1 8 WATTS RMS x 2 291 L X 201 W X 77 H mm 110 L X162 W X 205 H mm 2 85KG FM 87 5 108 MHz MW 530 1600 kHz 4 76 CM SEC 125Hz 8 KHz 8 BEAM LASER 100Hz 16 KHz REVISED 1
3. Press SKIP FORWARD BACKWARD button on the unit or remote the required track number appears in the display 2 Press PLAY PAUSE button to starting playing Starting again with the track that is currently playing 3 Press SKIP F R button once 4 The track will be started again from the beginning Starting Again With The Track That Is Currently Playing 1 Press SKIP F R once 2 The track will be started again from the beginning Stopping Play 1 Press STOP if you wish to stop play The disc and track number which can be played will now appear in the display 2 Open the CD door on the unit to remove the CD UK 3 COMPACT DISC 1 Always use a compact discs bearing the mark as shown ISE DIGITAL AUDIO 2 Notes on handling discs Removing the disc from its storage case and loading it Do not touch the reflective recorded surface Do not stick paper or write anything on the surface Do not bend the disc 3 Storage Store the disc in its case Do not expose discs to direct sunlight or high temperatures high humidity or dusty places 4 Cleaning a disc Should the disc become soiled wipe off dust dirt and fingerprints with a soft cloth The disc should be cleaned from the center to the edge FROM THE CENTRE TO THE EDGE CORRECT INCORRECT Never use benzene thinners record cleaner fluid or anti static spray Be sure to close the CD door so the lens is not contaminated by dust
4. J X CD7000 jWIN INSTRUCTION MANUAL LL 2018 21 19 O SSs Aa N O To achieve the utmost in enjoyment and performance please read this manually carefully before attempting to operate the unit in order to became familiar with its features and assure you years of faithful trouble free performance and listening pleasure Important Notes Keep instructions the safety and operating instructions should be retained for future reference Avoid installing the unit in locations described below Please exposed to direct sunlight or close to heat radiating appliances such as electric heaters On top of other stereo equipment that radiate too much heat Places locking ventilation or dusty places Places subject to constant vibration Humid or moist places ake sure not to obstruct the ventilation opening Operate turning controls and switches as instructed in the manual Before turning on the power for the first time make cert
5. ain the power cord is properly installed Store your tapes or CD in a cool area to avoid damage from heat For safety reasons do not remove any covers or attempt to gain access to the inside of the product Refer any servicing to qualified personal Do not attempt to remove any screws or open the casing of the unit there are no user serviceable parts inside refer all servicing to qualified service personal CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER OR BACK NO USER SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONAL DANGEROUS VOLTAGE Conductor dangerous voltage that may be of sufficient magnitude to constitute a risk of electric shock to persons is present within this product s enclosure The owner s manual contains important operating and maintenance instructions for your safety it is necessary to refer to the manual ATTENTION WARNING TO PREVENT FIRE OR SHOCK HAZARD DO NOT EXPOSE THIS APPLIANCE TO DRIPPING OR SPLASHING Note This unit will become warm when used for a long period of time This is normal and does not indicate a problem with the unit This CD player includes micro processors which may malfunction as s result of external electrical interference or noise If the CD player is not working properly discount the power source and then reconnect it UK 1 FEATURES AND CONTROLS
6. ton again or just press the volume button to disable the MUTE function RADIO OPERATION Set the FUNCTION switch to RADIO FM Select FM mode band selector switch Turn the TUNING control to select the required station The FM stereo indicator light will show a stereo broadcast is being received Fully extend the FM antenna and adjust its direction for best FM reception MW Select MW on band selector switch Turn the TUNING control to select the required station For operation on AM the set control a built in ferrite aerial which is directional Therefore the set should be positioned for the best signal strength FM STEREO RECEPTION For reception of a FM stereo broadcast station set the MW FM FM ST switch to FM ST position The FM ST will indicator on the LCD display when a FM STEREO broadcast is being received LISTENING TO COMPACT DISC CD The LCD indicator always shown the tracks of a disc or program which are still to be played It works in all modes in stop modes all tracks of the disc or the program are shown Playing The Entire Disc 1 Playback will start by pressing PLAY PAUSE the indicator then appears Playback starts with the first track The display shown the current track number and its elapsed time 2 To interrupt playback press PLAY PAUSE The time elapse indicator will flash 3 To resume playback press PLAY PAUSE again 4 To stop playback press STOP Selection A Different Track During Play 1
Download Pdf Manuals
Related Search
Related Contents
ICY BOX IB-122CL-U3 Bosch NIT8066SUC Product Information 取扱説明書/1.7MB Samsung S821 Manuel de l'utilisateur - Frank`s Hospital Workshop BIRDY BEAM/2 Spatz HDMI-X24 video splitter Clarke 9060610010 Use and Care Manual Copyright © All rights reserved.
Failed to retrieve file