JVC SP-PW3000 User's Manual
Contents
1. 6 To avoid accidents do not remove screws to disassemble the unit and do not touch anything inside the unit 7 Do not insert any metallic objects into the unit 8 Unplug the power cord when there is a possibility of lightning 9 If water gets inside the unit unplug the power cord from the outlet and consult your dealer 10 Do not block the unit s ventilation holes that allow heat to escape 11 Do not install the unit in a badly ventilated place 12 Do not place the unit upside down 13 Be sure to unplug the power cord from the outlet when going out or when the unit is not in use for an extended period of time Caution Proper Ventilation To avoid risk of electric shock and fire and to prevent damage locate the apparatus as follows 1 Front No obstructions and open spacing 2 Sides Top Back No obstructions should be placed in the areas shown by the dimensions below 3 Bottom Place on the level surface Maintain an adequate air path for ventilation by placing on a stand witha height of 10 cm or more HANDLING PRECAUTIONS Do not use this unit in direct sunlight where it would be exposed to high temperatures above 40 C 104 F 1 Avoid installing in the following places e Where it could be subject to vibrations e Where it is excessively humid such as in a bathroom e Where it could be magnetized by a magnet or speaker 2 Condensation In the following cases condensation may occur in th2. JVC sp pw3000 VNN9330 691C 0997MNMMDWJSC B E G EN w EN GE FR NL SP IT SW FI DA POWERED SUBWOOFER SUBWOOFER MIT EINGEBAUTEM VERSTARKER SUPER WOOFER AMPLIFIE SUBWOOFER MET VERSTERKING Connecting cord supplied AnschluBkabel im Lieferumfang enthalten MONO Cordon de connexion fourni Verbindingskabel bijgeleverd R eas UX 1000 1500R 2000R j srwanee ar LOW LEVEL INPUT Connect the speaker cords in parallel to the speaker terminals on the Micro Component System e Schlie en Sie die Lautsprecherkabel parallel an die Lautsprecheranschlusse am Mikrokomponentensystem an e Connecter les cordons d enceinte en parall le aux prises d enceinte de la microchaine Sluit de luidsprekerkabels parallel aan op de luidsprekeraansluitpunfen op het Mikrokomponentensysteem UX T100 T200R SPEAKERS LEFT Speaker cords not supplied Lautsprecherkabel nicht im Lieferumfang enthalten Cordons d enceinte non fournis Luidsprekerkabels niet bijgeleverd a oo SP PW3000 O SP PW3000 f v LOW LEVEL INPUT OUTPUT RIGHT LEFT Connecting cord not supplied Anschlu kabel nicht im Lieferumfang enthalten Cordon de connexion non fourni Verbindingskabel niet bijgeleverd ET D POWER mm ON m OFF VOLUME m OPERATE eccceser1t1 AIOE Lprttsiee
3. OPERATIONS By Presetting the Volume You need to preset the volume level of this speaker to match those of the other speakers Once you preset the volume level it is stored as your reference level and the volume level of this speaker will be able to automatically change as the volume level of the stereo system changes 1 Turn on the power The POWER indicator lights up 2 Set the volume to MIN 3 Adjust the volume of the connected stereo system to your listening level 4 Adjust the volume to balance it with those of the other speakers f To turn off this speaker press the POWER button again so that the POWER indicator goes off The indicator may not go off imediately About the OPERATE Indicator a The OPERATE indicator lights up while sound signals are coming into this speaker Adding the Richness to the Bass PHASE b Normally set the PHASE button in the I position If you want to add the richness more to the bass press the PHASE button to set it either in the position or the ll position whichever can add the richness to the bass Cutting Off the Higher Frequencies CUT OFF c Set the CUT OFF selector to the position giving you the preferable sound according to the other speaker system used and to the played back music Automatic Operating Status On Off To save energy this speaker enters the standby mode the OPERA
4. TE indicator goes off if no or very weak sound signals come into this unit for a while When sound signals come in again the OPERATE indicator comes on this speaker enters the operating mode and reproduces the sounds Specifications Model Powered subwoofer Speaker unit Woofer 10cm 4 Q x2 Rated impedance 4 Q Frequency response 40 100 Hz Output sound pressure level 81 dB Wem Input terminals LOW LEVEL 12 mV 56 kQ HIGH LEVEL 230 mV 430 Output power 25 W 25 W Max 20 W 20 W 10 THD Power requirements AC 230 V L 50 Hz Power consumptions 30 W Dimensions Approx 258 x 158 x 294 mm W H D Mass Approx 5 8 kg THD Total Harmonic Distortion Design and specifications are subject to change without prior notice
5. e unit in which case the unit may not operate correctly e In a room where a heater has just been switched on e Ina place where there is smoke or high humidity e When the unit is moved directly from a cold toa warm room In these cases set the POWER button to OFF and wait 1 or 2 hours before use 3 Volume setting CDs MDs produce very little noise compared with analogue sources If the volume level is adjusted for these sources the speakers may be damaged by the sudden increase of output level Therefore lower the volume before operation and adjust it as required during play 4 Keep this unit away from your TV When this unit is used near a TV the TV picture could be distorted If this happens move this unit away from the TV If this does not correct the situation avoid using this unit when the TV is turned on 5 Cleaning the cabinet If the cabinet gets dirty wipe it with a soft dry cloth Never use benzine or thinner as these could damage the surface finish CONNECTIONS Plug the AC power cord after all connections are complete When connecting JVC Ultra Micro Component System UX 1000 1500R 2000R EJ When connecting JVC Micro Component System UX T100 T200R etc Note No sound comes out of this speaker if you connect the headphones to your Micro Component System fel When connecting a Preamplifier of any manufacturers CAUTION DO NOT use the REC OUT jacks of the preamplifier to connect this speaker
6. oloured blue must be connected to the terminal which is marked with the letter N or coloured black The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red IF IN DOUBT CONSULT A COMPETENT ELECTRICIAN WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER OR BACK NO USER SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance servicing instructions in the o literature accompanying the appliance SAFETY PRECAUTIONS Prevention of Electric Shocks Fire Hazards and Damage 1 Do not handle the power cord with wet hands 2 When unplugging from the wall outlet always grasp and pull the plug not the power cord 3 Consult your nearest dealer when damage disconnection or contact failure affects the cord 4 Do not bend the cord severely or pull or twist it 5 Do not modify the power cord in any manner
7. sestatietneseseictettest AODAN ANS SnO eased venison NANEN ONIN N ION ASNS ASNES i f POWER mO f a E RIGERE SUBWOOFER SP PW3000 VOLUME ENGLISH Thank you for purchasing this JVC product Please read these instructions carefully before starting operation to be sure to obtain optimum performance and a longer service life from the unit IMPORTANT In the United Kingdom Mains Supply AC 230V L 50 Hz only DO NOT cut off the mains plug from this equipment If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point then obtain an appropriate safety approved extension lead or consult your dealer BE SURE to replace the fuse only with an identical approved type as originally fitted and to replace the fuse cover If nonetheless the mains plug is cut off ensure to remove the fuse and dispose of the plug immediately to avoid a possible shock hazard by inadvertant connection to the mains supply IMPORTANT DO NOT make any connection to the terminal which is marked with the letter E or by the safety earth symbol or coloured green or green and yellow The wires in the mains lead on this product are coloured in accordance with the following code Lo Biue to N Neutral or Black Brown to L Live or Red As these colours may not correspond with the coloured markings identifying the terminals in your plug proceed as follows The wire which is c
Download Pdf Manuals
Related Search