Ives 7227/27F User's Manual
Contents
1. QZ Installation Instructions 7212 7215 15F 7222 7226 26F and 7227 27F 3 4 Offset Top Pivot S Bearing leaf _ Ow Pin leaf lt ogi L 3 32 Allen wrench Bearing s Set screw gt leaf F Pin leaf LESS E 1 4 20 tapped hole for Left hand A pin removal both ends Right hand ae oe ee Bienes e Tus A 5 32 Allen wrench __ 1 Prepare and mortise top of door and head jamb to receive pivot set Determine pivot location using dimensions on reverse side The pivots are non handed To determine hand of door and proper pivot position see diagrams above 2 Locate drill and tap 1 4 20 mounting holes for metal door or metal frame Locate and drill pilot holes for 14 wood screws for wood door or wood frame Install pivot leafs with 1 4 20 x 3 4 FHMS or 14 FHWS screws provided 3 Loosen set screw in pin leaf with 3 32 Allen wrench provided and remove pivot pin 4 Use 5 32 Allen wrench to remove pivot cap from door leaf allowing for pivot pin re insertion 5 With door in open position about 90 to jamb carefully fit door onto bottom pivot at a slight angle Tip door into vertical position aligning top pivot leafs in door and jamb With pivot leafs aligned insert pivot pin into pivot set Vertically align groove in pivot pin with set screw in pivot leaf Tighten set screw securely with 3 32 Allen wrench Re install pivot cap 6 To remove door from jamb Re2. move pivot cap Thread a 1 4 20 machine screw into end of pivot pin Pull pivot pin out of pivots Door can now be removed from opening CAUTION Improper pivot set installation can lead to personal injury or property damage Follow all instructions carefully For questions contact Technical Support at 1 888 371 7331 Li Ingersoll Rand 26672 Rev 4 2006 Ingersoll Rand Company Limited Security Technologies It is very important for installer to verify that center line of top pivot point lines up with center line of bottom pivot point before final installation Heel edge of door must be beveled 1 8 in 2 as shown below The bottom pivot set should be mounted first in most installations A NOTE Mortise depth for pivot leafs is 1 4 lt a 3 4 11e _ lt 1 8 19mm 24mm 3mm typ a X A y ji ojl A Frame Leaf at 1 16 These dimensions apply to industry standard 2mm 1 3 4 door in a 1 15 16 rabbeted frame For typ other frame conditions locate frame leaf of pivot identical to door leaf as shown below lt a 11 16 7 8 17 mm 22 mm Bevel heel edge of door 1 8 in2 with ON 3 16 rad t yp d X AN o o AN Door Leaf 26672 00 26672 Rev 4 a f
Download Pdf Manuals
Related Search