Insignia NS-L7HTV-10A User's Manual
Contents
1. Quick Setup Guide Step 1 Getting to know your TV and connecting your devices Check out the front side and back panels to familiarize yourself with button controls and connection options Connect your devices using the diagram below as a guide Press INPUT on your remote control to switch between devices Antenna jack In TV mode connect an antenna cable TV or satellite TV to this jack In radio mode connect the supplied antenna to scan for radio stations Note The supplied antenna will be attached with the portable TV when you receive the product The antenna is detachable If you want to connect an external antenna you can detach the antenna and connect other external antenna INSIGNIA AC adapter MENU Z CH TV FM O VIDEO SCAN YF CH Actual product may vary from image shown RECALL INSIGNIA Volume B Adjust the volume i Remote control Service port a Do not use JE DEON FOR lt J m O Z AV cable o o AAO YAMOd NO Connect a standard video device to this jack 1 PHONE 2 PHONE1 and 2 jacks N Connect a pair of headphones to these jacks Vehicle adapter Frame Stand Open up the frame stand and use it for supporting your TV DC IN 9V jack Connect the AC adapter to this jack Power switch Power On Charge indicator Displays the power status When the TV is on the indicator is green Wh2. en the battery is charging the indicator is orange SHO NO Y3MOd Step 2 Install the remote control battery Step 4 Charging the built in battery Remove the battery holder from the back of the remote control by inserting a fingernail into the groove and Note There is no standby mode for this TV because it runs on a rechargeable battery pulling out the holder Place a CR2025 battery with the side up on the holder Insert the holder into the Turn off your TV before charging the battery Connect the supplied AC adapter Charging starts and the POWER remote control ON CHG indicator is red When the charging is completed the indicator turns off Note On initial use of the TV charge the battery for 6 hours Step 5 Establish a signal Make sure that the included rod antenna or a stronger HDTV antenna not included is attached to the input at the top of the TV Extend the antenna rod and move the TV to a location where it can receive the strongest signal free of obstructions and interference from other devices Press TV on your remote control to ensure you are in TV mode Step 6 Scan for channels Note The coin shaped battery is already in the remote control The first time you use the remote Note See your User Guide for more information on connecting your TV control remove the plastic sheet from the bottom of the battery to activate the remote directly to cable or satellite service and for scanning for radio stations To scan for chan
3. nels when the TV signal source is Antenna Antenna Cable Antenna Auto Channel Search highlight K Add Skip Channels OK ENTER or V to enter the Channel menu Press the W A buttons Gewelics to select Auto Channel Search then press OK ENTER or B to enter Doiii Step 3 Connect the AC adapter Connect the AC adapter into the DCIN jack on the right side of your unit then connect the AC adapter to a 100 240V power outlet 80 3 the Auto Channel Search menu Start to Scan is highlighted Press apna E OK ENTER or gt to start the scan If the Automatic Channel Search does not locate the channels you were expecting try moving the TV to a location where you can pick up a stronger signal then try rerunning the search 2009 Best Buy Enterprise Services Inc All rights reserved INSIGNIA is a trademark of Best Buy Enterprise Services Inc Registered in some countries All other products and brand names are trademarks of their respective owners ENGLISH 09 0339
Download Pdf Manuals
Related Search