InFocus SP-LAMP-084 User's Manual
Contents
1. 10 11 Lamp Module Replacement Instructions sp LAMP 084 NOTES Always use the InFocus lamp module designed for your projector model Using the wrong lamp module may cause premature lamp failure and possible damage to the projector SP LAMP 084 Used in IN134UST IN136UST You can order new lamps from www infocus com in select areas your retailer or your dealer Only genuine InFocus lamps are tested for use in this projector Use of non InFocus lamps may cause electrical shock and fire and may void the projector warranty InFocus is not liable for the performance safety or certification of any other lamps WARNINGS The projector uses a high pressure mercury glass lamp The lamp may fail prematurely or it may rupture with a popping sound if jolted scratched or handled while hot The risk of lamp failure or rupture also increases as the lamp age increases please replace the lamp when you see the Replace Lamp message To avoid burns allow the projector to cool for at least 60 minutes before you replace the lamp Unplug the power cord before replacing the lamp Do not drop the lamp module The glass may shatter and cause injury Do not touch the glass surface of the lamp module Fingerprints can obscure projection sharpness and may cause the glass to shatter Be extremely careful when removing the lamp module In the unlikely event that the lamp ruptures small glass fragments may be generated The lamp module is designe2. d to contain most of these fragments but use caution when removing it Before replacing a ruptured lamp clean the lamp compartment and dispose of cleaning materials Wash hands after lamp replacement When replacing the lamp while the projector is ceiling mounted wear protective eyewear to prevent eye injury Hg Lamp contains mercury Manage with accordance with local disposal laws See www lamprecycle org Turn off the projector and unplug the power cord Wait 30 minutes to allow the projector and lamp to cool thoroughly Remove the screw on the lamp door Remove the lamp door Loosen the two captive screws that attach the lamp housing to the projector NOTE If the projector is installed on a ceiling mount be careful not to drop the lamp module once the captive screws are loosened Using the handle carefully lift the lamp straight up off of the alignment pins being careful not to pinch the lamp connector Dispose of the lamp in an environmentally proper manner Install the new lamp module aligning the pins properly Be careful not to pinch the lamp connector Tighten the screws NOTE If the pins have not been aligned properly the screws will not tighten securely Replace the lamp door by putting the lamp door down the hinges should be aligned and sliding it back into place Replace the lamp door screw and tighten securely Plug in the power cord and press th
3. e Power button to turn the projector back on Lamp Module Replacement Instructions sP LAMP 084 12 To reset the lamp hour timer navigate to the Installation Il gt Advanced menu and select Lamp S Hour Reset E ef Installation Il Advanced OSD Menu Setting Peripheral Test Low Power Mode 3D Network 13 Press the gt or Enter button The Please See User Manual message displays Eat Installation Il 14 Press the arrow keys in the following order VA lt gt Advanced Lamp Hour Reset 15 Press the Menu button to return to the Installation II menu Please See User Manual 5012704300 InFocus ATTA A A The New Way to Collaborate
Download Pdf Manuals
Related Search