InFocus SP-LAMP-077 User's Manual
Contents
1. Lamp Module Replacement Instructions sp LAMP 077 NOTES Always use the InFocus lamp module designed for your projector model Using the wrong lamp module may cause premature lamp failure and possible damage to the projector You can order new lamps from www infocus com in select areas your retailer or your dealer Only genuine InFocus lamps are tested for use in this projector Use of non InFocus lamps may cause electrical shock and fire and may void the projector warranty InFocus is not liable for the performance safety or certification of any other lamps WARNINGS The projector uses a high pressure mercury glass lamp The lamp may fail prematurely or it may rupture with a popping sound if jolted scratched or handled while hot The risk of lamp failure or rupture also increases as the lamp age increases please replace the lamp when you see the Replace Lamp message To avoid burns allow the projector to cool for at least 60 minutes before you replace the lamp Unplug the power cord before replacing the lamp Do not drop the lamp module The glass may shatter and cause injury Do not touch the glass surface of the lamp module Fingerprints can obscure projection sharpness and may cause the glass to shatter Be extremely careful when removing the lamp module In the unlikely event that the lamp ruptures small glass fragments may be generated The lamp module is designed to contain most of these fragments but use caution when r2. emoving it Before replacing a ruptured lamp clean the lamp compartment and dispose of cleaning materials Wash hands after lamp replacement When replacing the lamp while the projector is ceiling mounted wear protective eyewear to prevent eye injury Hg Lamp contains mercury Manage with accordance with local disposal laws See www lamprecycle org Turn off the projector and unplug the power cord 2 Wait 60 minutes to allow the projector and lamp to cool ma thoroughly Infocus E 3 Remove the lamp door located on top of the projector by removing the screw on the side of the lamp door sliding the door to the left and lifting the lamp door off 4 Loosen the captive screws that attach the lamp housing to the projector NOTE If the projector is installed on a ceiling mount be careful not to drop the lamp module once the captive screws are loosened 5 Carefully lift the lamp straight up off of the alignment pins being careful not to pinch the lamp connector Dispose of the lamp in an environmentally proper manner 6 Install the new lamp module aligning the pins properly Be careful not to pinch the lamp connector 7 Tighten the screws NOTE If the pins have not been aligned properly the screws will not tighten securely 8 Replace the lamp door by reversing step 3 and locking it back into place 9 Replace the lamp door screw and tigh
3. ten securely 10 Plug in the power cord and press the Power button to turn the projector back on 11 To reset the lamp hour timer navigate to the Advanced Menu gt Status Service menu and select Reset Lamp Hours Advanced Menu MDL IN3924 FW 1 02 Image Source Info Setup Projector Info Status Service Reset Lamp Hours Factory Reset Basic Menu Service Code Network Info PL739 4800 00 NO DA T ON N N T InFocus Bright Ideas Made Brilliant
Download Pdf Manuals
Related Search