IBM 8271 User's Manual
Contents
1. MODULE USER S GUIDE Introduction gt With the 8271 Nways Matrix Stacking Switch Module 02L0882 installed into your 8271 Nways Switch you can connect up to four Switches over high speed links in a single stack This stack can then be managed as a single unit with one IP address The Matrix Module can be installed into the following models of 8271 Nways Ethernet LAN Switches m 8271 Nways Ethernet LAN Switch Models E12 and E24 m 8271 Nways Ethernet LAN Switch Models F12 and F24 A stack can consist of any combination of Switch Model E12 E24 and Switch Model F12 F24 units You do not need a Matrix Module if you are connecting two Switches back to back You can connect two units using the Matrix port located on the rear of the Switch and a Switch Matrix Cable You can find more information on stacking units in the user s guide that accompanies your Switch Before Installation p ATTENTION Before installing the Matrix Module into a Switch you must disconnect the Switch from the mains power supply For full safety instructions refer to the appropriate Switch User s Guide 8271 Nways MATRIX STACKING SWITCH f DANGER us SD21 0030 Handling the Matrix Module The Matrix Module can be easily damaged by electrostatic discharge To prevent damage please observe the follow ing m Do not remove the Matrix Module from its packaging until you are ready to install it m Do not touch any of the conne2. 15 Subpart B Class A ICES 003 Class A AS NZS 3548 Class B VCCI Class B EN50082 1 EN60068 IEC 68 This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to part 15 of the FCC Rules These limits are designed to provide reason able protection against harmful interference when the equipment is operated in a commercial environment This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instruction manual may cause harmful interference to radio communications Operation of this equipment in a residen tial area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense Properly shielded and grounded cables and connectors IBM P N 02L0883 or its equivalent must be used in order to meet FCC emission limits IBM is not responsible for any radio or television interference caused by using other than recommended cables and connectors or by unauthorized changes or modifications to this equipment Unauthorized changes or modifications could void the user s authority to operate the equipment This device complies with Part 15 of the FCC Rules Opera tion is subject to the following two conditions 1 this device may not cause harmful interference and 2 this device must accept any interference received including interference that may cause undesi
3. B Taiwanese Class A Warning Statement SERME RPA KRA oo E EAE Ag RSE ZU gt T ALPE RAT HE A EHRT RA A PRE RAR BRIE HAR Korean Communications Statement Please note that this device has been approved for business purpose with regard to electromagnetic interference If you find this is not suitable for your use you may exchange it for a non business purpose one DRES BR a phe green YE plaz xO Se ae ol a Satay abel Be pR iiag mhie FLE a ee aiL Statement of Limited Warranty International Business Machines Corporation Armonk NY 10504 The warranties provided by IBM in this Statement of Limited Warranty apply only to Machines you originally purchase for your use and not for resale from IBM or your reseller The term Machine means an IBM machine its features conversions upgrades elements or accessories or any combination of them Unless IBM specifies otherwise the following warranties apply only in the country where you acquire the Machine If you have any questions contact IBM or your reseller Machine IBM 8271 Nways Matrix Stacking Switch Module Warranty Period 1 year Contact your place of purchase for warranty service information Production Status Each Machine is manufactured from new parts or new and used parts In some cases the Machine may not be new and may have been previously installed Regardless of the Machine s production status IBM s warranty terms app
4. also agree to ensure that the Machine is free of any legal obligations or restric tions that prevent its exchange You agree to 1 obtain authorization from the owner to have IBM or your reseller service a Machine that you do not own and 2 where applicable before service is provided a follow the problem determination problem analysis and ser vice request procedures that IBM or your reseller provide b secure all programs data and funds contained in a Machine and c inform IBM or your reseller of changes in a Machine s location IBM is responsible for loss of or damage to a Machine while it is 1 in IBM s possession or 2 in transit in those cases where IBM is responsible for the transportation charges Extent of Warranty IBM does not warrant uninterrupted or error free operation of a Machine The warranties may be voided by misuse accident modification unsuitable physical or operating environment improper maintenance by you removal or alteration of Machine or parts identification labels or failure caused by a product for which IBM is not responsible THESE WARRANTIES REPLACE ALL OTHER WARRANTIES OR CONDITIONS EXPRESS OR IMPLIED INCLUDING BUT NOT LIMITED TO THE IMPLIED WAR RANTIES OR CONDITIONS OF MERCHANTABILITY AND FITNESS FOR A PAR TICULAR PURPOSE THESE WARRANTIES GIVE YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM JURISDIC TION TO JURISDICTION SOME JURISDICTIONS D
5. O NOT ALLOW THE EXCLU SION OF EXPRESS OR IMPLIED WARRANTIES SO THE ABOVE EXCLUSION OR LIMITATION MAY NOT APPLY TO YOU IN THAT EVENT SUCH WARRANTIES ARE LIMITED IN DURATION TO THE WARRANTY PERIOD NO WARRANTIES APPLY AFTER THAT PERIOD Limitation of Liability Circumstances may arise where because of a default on IBM s part or other liability including negligence and misrepresentation you are entitled to recover damages from IBM In each such instance regardless of the basis on which you are entitled to claim damages from IBM including fundamental breach negligence misrepresentation or other contract or tort claim IBM is liable only for Damages for bodily injury including death and damage to real property and tangible personal property and The amount of any other actual direct damages or loss up to the greater of US 100 000 or the charges if recurring 12 months charges apply for the Machine that is the subject of the claim Under no circumstances is IBM liable for any of the following 1 Third party claims against you for losses or damages other than those under the first item listed above 2 Loss of or damage to your records or data or 3 Spe cial incidental or indirect damages or for any economic consequential dam ages including lost profits or savings even if IBM or your reseller is informed of their possibility Some jurisdictions do not allow the exclusion or limitation of incidental
6. apanese Voluntary Control Council for Interference product including the fitting of non IBM option cards VCCI Statement Class B for Shielded Cables WARNING This is a Class B product In a domestic environ ment this product may cause radio interference in which case the user may be required to take adequate measures This product is a Class B Information Technology Equipment and conforms to the standards set by the Voluntary Control Council for Interference by Technology Equipment VCCI This product is aimed to be used in a domestic environment When used near a radio or TV receiver it may become the cause of radio interference Read the Instructions for cor rect handling Zulassungsbesheinigung laut dem Deutshen Gesetz Uber die elektromagnetische Vetr glichkeit von Ger ten EMVG vom 30 August 1995 bzw der EMC EG Richlinie 89 336 Dieses Ger t ist berechtigt in bereinstimmung mit dem TORE BRNELRESERMTEFHEHEL VCC DUEI a it i EI lt CAGTABERB KEETT CORE ZERHTEAFTSZLETOEN Deutschen EMVG das EG Konformit tszeichen CE zu ELTUSTA OED S STP LESY REIHE CER SAD f hren Es ZEnne een FCEMBVEF Hu iat HASHES CIE LLY Y RUS LTR SLY Verantworlich f r die Konformit tserkl rung nach Para graph 5 des EMVG ist die IBM Corporation Deutschland Informationssysteme GmbH 70547 Stuttgart Informationen in Hinsicht EMVG Paragraph 3 Abs 2 2 Das Ger t erf llt die Schutzanforderungen nach EN 50082 1 und EN 55022 Klasse
7. correct number of Matrix Cables for your con figuration We recommend that the bottom unit in your stack is the one that contains the Matrix Module Working first with the Switch that contains the Matrix Mod ule attach a Matrix Cable to one of the ports on the Matrix Module Connect the other end of that cable to the matrix port on the same unit For your stack to operate as one unit you must do this Connect each of the remaining cables between the ports on the Matrix Module and the matrix port on each unit Connect your power cord and power up the stack Obtaining Support For further information on obtaining support refer to the Technical Support information in the User s Guide that accompanies the switch or visit our World Wide Web site by entering the following URL into your web browser http www networking ibm com support Electronic Emission Notices Federal Communications Commission FCC Statement Ordering Matrix Cables Matrix Cables are available from your supplier Product Title Part Number IBM 8271 Nways Matrix Cable 02L0883 Technical Specification Operating Temperature Storage Temperature Operating Humidity Power Consumption Standards Safety EMC Emissions Immunity Environmental 0 to 50 C 32 to 122 F 10 to 70 C 14 to 158 F 10 to 95 non condensing 5V DC 800mA maximum 4W maxi mum UL 1950 EN60950 CSA22 2 950 EN55022 Class B FCC Part
8. ctors or components on the Matrix Module m Handle the Matrix Module only by its edges and front panel m Always wear an anti static wristband connected to a suitable earth point m Always transport or store the Module in appropriate anti static packaging Cabling Installing the Module With the Matrix Module installed you can connect up to We recommend that you install the Matrix Module into the four Switches in a stack A typical configuration is shown in unit that will be at the bottom of your stack Figure 2 1 Remove the blanking plate from the rear of the Switch You should store it carefully for future use oe _ 2 Hold the Matrix Module so that the text on the front panel reads correctly and guide it into the slot ensuring it is located in the rails See Figure 1 Ensure that the connector on the Matrix Module engages with the board inside the Switch Press the Module fully into the Switch 3 Tighten the two captive screws to secure the Matrix Module into the unit Figure 1 Inserting the Matrix Module into the Switch Figure 2 A typical stack of switches gt You only need one Matrix Module for each stack The way in which units in the stack are numbered for man agement purposes is determined by the order of port con nections to the Matrix Module The units are numbered 1 to 4 from the bottom unit up Ensure that your Switches are correctly installed and that you have the
9. ly The IBM Warranty for Machines BM warrants that each Machine 1 is free from defects in materials and workmanship and 2 conforms to IBM s Official Published Specifications The warranty period for a Machine is a specified fixed period commencing on its Date of Installation The date on your receipt is the Date of Installation unless IBM or your reseller informs you otherwise During the warranty period IBM or your reseller if authorized by IBM will provide warranty service under the type of service designated for the Machine and will manage and install engineering changes that apply to the Machine For IBM or your reseller to provide warranty service for a feature conversion or upgrade IBM or your reseller may require that the Machine on which it is installed be 1 for certain Machines the designated serial numbered Machine and 2 at an engineering change level compatible with the feature conversion or upgrade Many of these transactions involve the removal of parts and their return to IBM that are provided on an exchange basis You represent that all removed parts are genuine and unaltered A part that replaces a removed part will assume the warranty service status of the replaced part If aMachine does not function as warranted during the warranty period IBM or your reseller will repair or replace it with one that is at least functionally equivalent without charge The replacement may not be new but it will be in good w
10. or consequential damages so the above exclusion or limitation may not apply to you This warranty gives you specific legal rights and you may also have other rights which vary from jurisdiction to jurisdiction COPYRIGHT INTERNATIONAL BUSINESS MACHINES CORPORATION 1998 ALL RIGHTS RESERVED Note to US Government Users Documentation released to restricted rights Use duplication or disclosure is subject to restrictions set forth in GSA ADP Schedule Contract with IBM Corporation Part No 02L0893 Published July 1998
11. orking order If IBM or your reseller is unable to repair or replace the Machine you may return it to your place of purchase and your money will be refunded If you transfer a Machine to another user warranty service is available to that user for the remainder of the warranty period You should give your proof of purchase and this Statement to that user However for machines which have a life time warranty this warranty is not transferable Warranty Service To obtain warranty service for the Machine you should contact your reseller or call IBM In the United States and Canada call IBM at 1 800 IBM SERV 426 7378 You may be required to present proof of purchase IBM or your reseller will provide certain types of repair and exchange service either at your location or at IBM s or your reseller s service center to restore a Machine to good working order When a type of service involves the exchange of a Machine or part the item IBM or your reseller replaces becomes its property and the replacement becomes yours You represent that all removed items are genuine and unal tered The replacement may not be new but will be in good working order and at least functionally equivalent to the item replaced The replacement assumes the warranty service status of the replaced item Before IBM or your reseller exchanges a Machine or part you agree to remove all features parts options alterations and attachments not under warranty service You
12. red operation Canadian Department of Communications DOC EN 55022 Klasse B Ger te m ssen mit folgendem Warhin Compliance Statement weis versehen werden Industry Canada Class A Emission Compliance Statement Warnung dies ist eine Einrichtung der Klasse B Diese Ein richtung kann im Wohnbereich Funkstorungen verursa This Class A digital apparatus complies with Canadian chen in diesem Fall kann vom Betreiber verlangt werden ICES 003 angemessene Magbnahmen durchzufuhren und dafur auf zukommen Avis de conformite aux normes du ministere des EN 50082 1 Hinweis Communications du Canada Wird dieses Ger te in eine Umgebung betrieben wie in EN 50082 2 festgelegt dann kann es dabei eventuell gest rt werden In solch einem Fall ist der Abstand bzw die Abschirmung zu der industriellen St rquelle zu ver ern Cet appareil num rique de la classe A est conform a la norme NMB 003 du Canada European Union EU Statement for Shielded Cable Anmerkung This product is in conformity with the protection require ments of EU Council Directive 89 336 EEC on the approxi Um die Einhaltung des EMVG sicherzusellen sind die mation of the laws of the Member States relating to Ger te wie in den IBM Hand chern angegeben zu install electromagnetic compatibility IBM cannot accept responsi ieren und zu betreiben bility for any failure to satisfy the protection requirements resulting from a non recommended modification of the J
Download Pdf Manuals
Related Search