Human Touch HT-5005 User's Manual
Contents
1. 3 Oct 17 08 j Quman touch C I o tne REPLACING THE REMOTE CONTROL HT 5005 To ensure that Human Touch products are repaired in a manner that is fully consistent with the practices used during the manufacturing process Human Touch requires that all o SERVICE LEVEL 2 product repairs are performed using only factory new parts and in accordance with these product repair instructions J Tools Required Phillips head screwdriver NOTE SAVE ALL SCREWS FOR USE DURING REASSEMBLY lt CD REMOVING THE REMOTE CONTROL T Remote control Power off the chair and unplug it Open the backrest pad zippers then remove the backrest pad Press the backrest release lever on the back of the chair to release the backrest from the actuator then tip the backrest forward onto the chair seat Fig 1 Using a Phillips head screwdriver remove the two screws that secure the remote control bracket to the power panel Fig 2 Pull the remote control bracket and cables gently out of the backrest as far as they will go Do one of the following ak Wn A If you can see the cable connectors then disconnect the connectors B If you cannot see the cable connectors use your fingers to locate the two screws beneath the power panel label then use a Phillips head screwdriver to punch through the label and remove the two screws Fig 3 Pull the power panel out of the backrest then disconnect the remote con2. trol connector 6 Remove the remote control from the power panel t Power panel Pe Power panel Fig 1 Fig 2 Fig 3 INSTALLING THE NEW REMOTE CONTROL NOTE If the remote control cable harness falls into the backrest you will need to remove the backrest cover to retrieve it To do this open the nylon backrest cover zippers then push the cover up over the headrest Using a Phillips head screwdriver remove the four screws that secure the backrest cover Remove the cover enough to feed the remote control cable harness through the backrest cover then connect it to the new remote control connector Reconnect the remote control connectors to the corresponding backrest connector then push all connectors into the backrest If you removed the power panel position the power panel flush with the backrest then replace the two screws to secure it Secure the remote control bracket to the power panel using the two screws Pull up on the backrest to return it to the upright position Replace the backrest pad Aa fF Wn Plug in the chair power it on and verify that the chair is now receiving power Please send any questions or comments regarding these instructions to doctumentation humantouch com E 2008 Human Touch LLC human touch
Download Pdf Manuals
Related Search