Huffy RC3200 User's Manual
Contents
1. backboard Adjust basketball backboard height to lowest position Rotate basketball system forward while holding pole until wheels engage with ground Move basketball system to desired location Carefully rotate basketball system upright Reattach ground restraint and check system for stability 201254 2 99 Remove all parts from packing material and separate tanks from the shipping position Carefully position front tank 1 upside down Secure wheel 2 into place from bottom side illust A making sure the wheel bracket 5 seeds into base as in illust B Repeat procedure for opposite wheel Finger tighten then upright assembly Correctly identify each pole section and mark tape as shown IMPORTANT Bounce pole top 7 and middle section 8 together as shown until they no longer move toward taped reference mark Upright assembly NOTE Pole sections should have a 3 3 4 9 5 cm minimum overlap NIS BOTTOM 35 1 2 90 2 cm IMPORTANT Holes in top 7 and bottom pole 9 sections MUST ALIGN to correctly position elevator system toward playing surface Add bottom pole section 9 to assembly as shown and bounce until completely tight NOTE Pole sections should have a 3 3 4 9 5 cm minimum overlap 04 03 IMPORTANT WRITE DOWN MODEL NUMBER FROM BOX ON PAGE 1 OF THIS OWNERS MANUAL P N 211657B Spread collar 10 open and carefully raise co2. P N 211657B 04 03 12 NOT LEAVE ASSEMBLY UNATTENDED WHEN EMPTY IT MAY TIP OVER Roll assembly to desired playing area Secure assembly to ground using rope 21 and tie down stake 22 Fill larger tank 1 with water approx 24 gallons 91 liters or sand approx 300 16 136 kg and smaller tank 17 with approx 10 gallons 78 9 liters or sand approx 120 Ibs 54 4 kg and snap fill caps 23 in place IMPORTANT Two Gallons 7 6 Liter of Non Toxic Antifreeze Required Add one gallon 3 8 liters to each tank to prevent freezing in sub freezing climates Make final adjustments to level the rim If backboard and rim are tipped back raise collar 10 until level and tighten If backboard and rim are tipped forward lower collar until level and tighten Maximum adjustment travel is 33 to 37 84 94 cm from bottom of pole to top of collar 13 04 03 P N 211657B 25 Apply height adjustment label 30 to front of pole as shown U zy H ANVI Vd OQ OU 10 feet Regulation Rim Height is 10 feet 3 05 m Height Adjustment Position looped end of height adjustment crank 34 onto hook as shown Rotate crank handle to raise or lower backboard View label 28 to determine approximate backboard height NOTE If height adjustment is difficult to operate you may have over tightened the areas indicated WARNING STORE CRANK OUT OF REACH OF CHILDREN D
3. please contact our Toll Free Customer Service Number listed below Service will be quicker if you have your Model Number found on carton and assembly instructions ready when calling PLEASE WRITE YOUR MODEL NUMBER IN THE SPACE PROVIDED ABOVE Toll Free Customer Service Number for U S 1 800 558 5234 Canada Only 1 800 284 8339 Internet Address http www huffysports com COPYRIGHT 2002 by HUFFY SPORTS 1 04 03 P N 211657B FAILURE TO FOLLOW THESE WARNINGS MAY RESULT IN SERIOUS INJURY AND OR PROPERTY DAMAGE Owner must ensure that all players know and follow these rules for safe operation of the system DO NOT HANG on the rim or any part of the system including backboard support braces or net During play especially when performing dunk type activities keep player s face away from the backboard rim and net Serious injury could occur if teeth face come in contact with backboard rim or net Do not slide climb shake or play on base and or pole After assembly is complete fill system completely with water or sand and stake to the ground Never leave system in an upright position without filling base with weight as system may tip over causing injuries When adjusting height or moving system keep hands and fingers away from moving parts Do allow children to move or adjust system During play do not wear jewelry rings watches necklaces etc Objects may entangle in net Surface beneath the base must be smooth a
4. x 4 201124 Locknut Hex 3 8 16 906410 Strut 1 1 4 O D x 43 o 1000 05 2D You may have extra parts with this model HARDWARE IDENTIFIER Item 3 2 Item 4 24 Item 6 13 Item 11 4 Item 12 12 Item 13 10 OD Item 14 2 Item 15 1 YOU MAY HAVE EXTRA PARTS WITH THIS MODEL HARDWARE IDENTIFIER CONTINUED 15 04 03 P N 211657B HARDWARE IDENTIFIER Item 40 5 OF vO Item 19 3 Item 18 1 24 2 Item 25 4 Item 33 2 Item 35 2 Item 36 2 Item 39 4 Item 41 1 YOU MAY HAVE EXTRA PARTS WITH THIS MODEL HARDWARE IDENTIFIER CONTINUED P N 211657B 04 03 16
5. 657B P N 211657B 04 03 FRONT VIEW OF ASSEMBLY Attach height decal 28 on screw jack 29 Align lower edge of decal with bottom of black indicator tube AWARNING TWO PERSON MINIMUM REQUIRED FOR THIS PROCEDURE NOT FOLLOWING RECOMMENDATION MAY RESULT IN SERIOUS BODILY INJURY AND OR PROPERTY DAMAGE Center screw jack 29 between support plates 26 amp 27 and secure as shown below Finger tighten Place cover over screw jack 29 Install pole cap 32 IMPORTANT DO NOT OVER TIGHTEN NOTE Be sure to use proper bracket as shown 9 04 03 P N 211657B Finger tighten Refer To Instructions Included With Rim Hardware For Rim Assembly P N 211657B 04 03 10 gt D p iL P N 211657B 04 03 11 21 Secure board and elevator tube assembly to pole assembly as shown Finger tighten IMPORTANT DO NOT OVER TIGHTEN AWARNING TWO PERSON MINIMUM REQUIRED FOR THIS PROCEDURE NOT FOLLOWING RECOMMENDATION MAY RESULT IN SERIOUS BODILY INJURY AND OR PROPERTY DAMAG Insert spacer 41 through top holes of height indicator cover 31 and screw jack assembly as shown Align spacer and screw jack assembly between elevator tubes 34 and secure NOTE NOW COMPLETELY TIGHTEN ALL BOLTS FROM STEPS 13 22 IMPORTANT WHEN SECURING SCREW JACK 20 TO TOP ELEVATOR TUBES 34 USE SCREW JACK SPACER 41 BETWEEN ELEVATOR ASSEMBLY TUBES AS SHOWN
6. Customer Service N53 W24700 South Corporate Circle Sussex WI 53089 U S A A Huffy Company WRITE IN YOUR MODEL NUMBER Portable Basketball System Owners Manual SAFETY INSTRUCTIONS FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY RESULT IN SERIOUS INJURY PROPERTY DAMAGE AND WILL VOID WARRANTY Owner must ensure that all players know and follow these rules for safe operation of the system To ensure safety do not attempt to assemble this system without following the instructions carefully Proper and complete assembly use and supervision is essential for proper operation and to reduce the risk of accident or injury A high probability of serious injury exists if this system is not installed maintained and operated properly Check entire box and inside all packing material for parts and or additional instructional material Before beginning assembly read the instructions and identify parts using the hardware identifier and parts list in this document If using a ladder during assembly use extreme caution Two 2 people are recommended for this operation Check base regularly for leakage Slow leaks could cause system to tip over unexpectedly Seat the pole sections properly if applicable Failure to do so could allow the pole sections to separate during play and or transport of the system Climate corrosion or misuse could result in system failure Minimum operational height is 6 6 1 98 m to the bottom of bac
7. O NOT ALLOW CHILDREN TO ADJUST HEIGHT WITHOUT ADULT SUPERVISION COULD RESULT IN SERIOUS BODILY HARM AND OR PROPERTY DAMAGE P N 211657B 04 03 14 PARTS LIST PartNo Description PartNo Description 202438 Black Nylon Rope 203124 Stake Tie Down 206219 Fill Cap 206273 Bolt Hex Head 1 2 13 x 4 1 2 Long 201651 Spacer 906277 Plate Jack Support Left 906276 Plate Jack Support Right 205229 Label Height Indicator 805231 Screw Jack 201254 Label Height Adjustment amp Moving 206234 Cover Height Indicator 206913 Pole 3 1 2 Round 206249 Bolt Hex Flange 1 2 13 x 1 1 4 806259 Crank Height Adjustment 206360 Bolt Hex Head 3 8 16 x 2 625 Long 200874 Spacer 900964 Board Bracket 904807 Tube 25 5 x 1 5 4 Holes 202862 Spacer Black Plastic 1 19 Long 206244 Bolt Hex Head 1 2 13 x 8 Zinc Plated 206269 Spacer 4 Long x 500 ID x 750 OD 226350 Tank Front Section 226403 Wheel 206245 Bolt Hex Head 1 2 13 x 5 1 2 Long 203474 Washer 1 2 I D 1 5 64 O D 206341 Bracket Wheel 206340 Locknut Hex 1 2 13 918812 Top Pole Section 990062 Middle Pole Section 908407 Bottom Pole Section 906343 Collar Pole Strut 203113 Bolt Hex Head Flange 5 16 18 x 2 1 2 Long 203232 Washer Flat 3 4 O D 203100 Nut Hex Flange 5 16 18 200516 Bolt Cover Vinyl Black 206347 Rod Steel 1 2 O D x 4 3 4 Long 206352 Eyebolt 3 8 x 6 Long 226351 Tank Rear Section 206346 Washer Rectangle 1 7 8
8. kboard This equipment is intended for home recreational use only and NOT excessive competitive play Read and understand the warning label affixed to pole Label is shown on page 2 The life of your basketball pole depends on many conditions The climate REQUIRED TOOLS AND placement of the pole the location of the pole exposure to corrosives such as MATERIALS pesticides herbicides or salts are all important Two People If technical assistance is required contact Huffy Sports Tape Measure Adult supervision is recommended when adjusting height Tape Wood Board Scrap Wrenches Two 1 2 9 16 3 4 Two Large and Small Adjustable Wrenches 9 16 Deep Socket w Ext Recommended Garden Hose or Sand 420 Ib 191 kg 2 Gallons 7 6 Liters of Non Toxic Antifreeze For more information on assembly placement proper use and maintenance visit Sawhorse or Support Table The American Basketball Council website at http www smarthoops com Two Step Ladders 8 ft 2 4 m Most injuries are caused by misuse and or not following instructions Use caution when using this system In U S and Canada only Have questions don t go back to the store We appreciate your purchasing one of our many fine products We are sure that you will be very satisfied with your selection Although great care and effort have been taken occasionally problems may occur To ensure prompt and correct handling of any problems or to answer any questions
9. llar 10 to 35 1 2 90 2 cm taped mark Finger tighten hardware to prevent collar 10 7 from moving and scratching pole Install rod 15 through holes in bottom pole section 9 and eyebolt 16 NOTE Avoid scratching pole Set rear tank 17 onto front tank 1 and insert pole assembly into tank assembly as shown P N211657B 04 03 4 IMPORTANT Carefully position system on its side and secure DO NOT bottom of pole to tank as shown a deep socket OVER TIGHTEN is recommended Upright system NOTE Keep unnecessary pressure off of the pole assembly when in this position Two people recommended for this step BOTTOM VIEW Loosen hardware on collar 10 and secure struts 20 to collar 10 as shown and tighten NOTE Final adjustments to collar may need to be made Refer to Step 32 5 04 03 P N 211657B 1 Once again carefully position system in the side position and secure strut 20 to tank 1 as shown Repeat for opposite side Completely tighten including bolts from step 2 then carefully upright system NI P N 211657B 04 03 6 ELEVATOR INSTALLATION 13 Install left screw jack support plate 26 and right screw jack support plate 27 to pole Finger tighten AWARNING TWO PERSON MINIMUM REQUIRED FOR THIS PROCEDURE NOT FOLLOWING RECOMMENDATION MAY RESULT IN SERIOUS BODILY INJURY AND OR PROPERTY DAMAGE AWARNING See Text Page 7 04 03 P N 211
10. nd free of gravel or other sharp objects Punctures cause leakage and could cause system to tip over Keep organic material away from pole base Grass litter etc could cause corrosion and or deterioration Check pole system for signs of corrosion rust pitting chipping and repaint with exterior enamel paint If rust has penetrated through the steel anywhere replace pole immediately Check system before each use for proper ballast loose hardware excessive wear and signs corrosion and repair before use Check system before each use for instability Do not use system during windy and or severe weather conditions system may tip over Place system in the storage position and or in an area protected from the wind and free from personal property and or overhead wires Never play on damaged equipment See instruction manual for proper installation and maintenance When moving system use caution to keep mechanism from shifting Keep pole top covered with cap at all times Do not allow water in tank to freeze During sub freezing weather add non toxic antifreeze sand or empty tank completely and store Do not use salt Use extreme caution if placing system on sloped surface System may tip over more easily HUFFY SPORTS In the U S 1 800 558 5234 and Canada 1 800 284 8339 201241 2199 P N 211657B 04 03 TO ADJUST BACKBOARD Position looped end of crank indicator onto hook as shown Rotate crank handle to raise or lower
Download Pdf Manuals
Related Search