Honeywell MS-5UD User's Manual
Contents
1. In the event of trouble contact the local Fire Lite Service Representative Company Address THIS SHEET SHALL BE FRAMED ADJACENT TO Telephone Number THE CONTROL PANEL Document 52805 Rev A 10 05 06 ECN 05 7652. MS 5UD amp MS 10UD Series Fire Alarm Control Panel Operating Instructions NORMAL Only AC POWER is illuminated green PANEL KEY The key to open the panel can be found at the All other indicators are off LCD display will read SYSTEM following location ALL NORMAL WHEN AUDIBLE DEVICES ARE SOUNDING FORANALARM 1 Evacuate the protected area 2 Notify the monitoring service and or the Fire Department immediately Tell them briefly what happened and what your current status is Phones Fire Department Monitoring Service 3 If the Fire Department is responding be prepared to provide directions to arriving firefighters FOR TROUBLE ONLY 1 Notify the monitoring service and or Fire department if this panel is connected to either one and tell them what is happening 2 Silence audible devices by unlocking and opening the panel and pressing the ACKNOWLEDGE STEP button The TROUBLE indicator will remain illuminated yellow Contact authorized service personnel immediately See Below WARNING DO NOT ALLOW TROUBLE CONDITIONS TO REMAIN LOGGED IN THE SYSTEM THE PROTECTION THE SYSTEM OFFERS HAS BEEN COMPROMISED OR ELIMINATED WHEN A TROUBLE CONDITION EXISTS To return to normal after an alarm Manual activation Fire Drill or otherwise 1 Do not enter the protected area until safe to do so Notification Appliance Circuits NACs can be activated by 2 Clear all initiating devices Smoke detectors will not reset pressin
3. g and holding the DRILL button for at least two if there is still smoke in the area seconds 3 Reset the control panel PRESS the RESET button NOTE You may want to disconnect municipal box by sliding DISCONNECT switch located on 4XTMF module to its Power failure or brownout disconnect position to the right If a DACT is con If AC power drops too low or fails AC POWER indicator will nected notify the monitoring service before conducting extinguish the system TROUBLE indicator will turn on yellow and any fire drills or tests the panel buzzer and any other audible trouble devices will sound Alarm Silencing Contact authorized service personnel immediately See below Notification Appliance Circuits may be silenced by pressing the ALARM SILENCE button ALARM SILENCED will turn on yellow Subsequent alarms will reactivate circuits Press the RESET button to clear the silenced condition NOTE Notification Appliance Circuits may be programmed as nonsilenceable Also Signal Silence Inhibit if enabled will prevent silencing of NACs for one minute after an alarm see manual To test the indicators LCD display and piezo Press and release the RESET button and check all indicators LEDs Every indicator LED should be on LCD shows all pixels Name on piezo sounder beeps For more information refer to the MS 5UD amp MS 10UD Series Manual Document 52626 It is kept in the following location Fire Lite ALarms by Honeywell
Download Pdf Manuals
Related Search