Harbor Freight Tools Solar House Address Number Plaque Product manual
Contents
1. C 4 Be sure you have positioned every 2 Replace the Battery 4 and make part except the removable Tab sure it makes proper contact with just as the Solar House Address the terminal See Figure D Panel was originally assembled Tab 5 Battery 4 Figure D Page 4 For technical questions please call 1 800 444 3353 Item 92650 Choosing a Location i An outdoor location with full direct sunlight is the best position for the Solar Address Panel Shadowy locations will not allow the battery to charge fully and will reduce the hours of lighting at night Do not place near a night time light source such as a porch light or street light This could cause the Solar Address Panel to turn off automatically 3 If choosing a front gate as a location attach the Panel on a wall near the gate or on a Ground Stake that receives sunlight at least 6 8 hours a day Check periodically to make sure panel does not come loose over time Attaching the Solar Address Panel to a Wall 1 Mark the holes on the Wall Holder 9 to the desired surface with a pencil WARNING Verify that installation surface has no hidden utility lines before drilling or driving screws 2 Item 92650 The distance between the mounting holes is 1 7 8 apart center to center Be sure the holes you drill are level Use the orange Wall Anchors provided for anchoring into dry wall or plaster Leave Screw heads sticking out 3 8 from the wall to h2. E PARTS LIST AND INSTALLATION DIAGRAM IN THIS DOCUMENT AS A REFERENCE TOOL ONLY NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT IN FACT THE MANUFACTURER AND OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO Page 6 For technical questions please call 1 800 444 3353 Item 92650 Parts List and Diagram Part Description Part Description ___ Qty AA NiCd Batter 6 NumberBoard _ Record Serial Number Here Note If product has no serial number record month and year of purchase instead Note Some parts are listed and shown for illustration purposes only and are not available individually as replacement parts Item 92650 For technical questions please call 1 800 444 3353 Page 7 Limited 90 Day Warranty Harbor Freight Tools Co makes every effort to assure that its products meet high quality and durability standards and warrants to the original purchaser that this product is free from defects in materials and w
3. Owner s Manual amp Safety Instructions Save This Manual Keep this manual for the safety warnings and precautions assembly operating inspection maintenance and cleaning procedures Write the product s serial number in the back of the manual near the assembly diagram or month and year of purchase if product has no number Keep this manual and the receipt in a safe and dry place for future reference one stop Solar House Visit our website at http www harborfreight com ITEM 92650 Email our technical support at tech harborfreight com When unpacking make sure that the product is intact and undamaged If any parts are missing or broken please call 1 800 444 3353 as soon as possible AWARNING Copyright 2005 by Harbor Freight Tools All rights reserved No portion of this manual or any artwork contained herein may be reproduced in Read this material before using this product any shape or form without the express written consent of Harbor Freight Tools Failure to do so can result in serious injury Diagrams within this manual may not be drawn proportionally Due to continuing SAVE THIS MANUAL improvements actual product may differ slightly from the product described herein Tools required for assembly and service may not be included Specifications Wall Bracket Dimensions 3 62 Lx 1 W Battery Type One AA NiCd Solar Panel 2 12 Lx 0 75 W 3 Solar Panels Important Safety Information Installation Pr
4. ang the back of the Solar Address Panel onto 4 Hang the attached Solar Address Panel Wall Holder 9 on the exposed Screws 5 The Solar Address Panel will automatically light up at dusk and turn off at dawn Note If the light does not turn on after a day of charging check the battery to ensure that it is making secure contact with the terminal Also check that the Solar Address Panel is in a bright sunny location and not in the shade Recharging time should be at least 6 8 hours in sunlight For technical questions please call 1 800 444 3353 Page 5 Maintenance To remove dust use a damp cloth To remove grease or oil use a detergent based cleaning solvent rinse with damp cloth and dry Replacing the Battery 1 NiCd BATTERY MUST BE RECYCLED 5 OR DISPOSED OF PROPERLY Do not short incinerate or open battery 2 Remove the Solar Address Panel from the wall or ground stake 3 Use a screwdriver to remove the Screws 10 on the Back Board 8 4 Remove the old Battery 4 Replace it with a new AA NiCd battery Reconnect exactly as it was connected being careful not to stretch or strain wiring See Figure G Attach the Back Board 8 with the Screws 10 and replace on your wall Screw 10 2 a J op e _____ Back 77 Board 8 Housing 1 Battery 4 A a Figure F PLEASE READ THE FOLLOWING CAREFULLY THE MANUFACTURER AND OR DISTRIBUTOR HAS PROVIDED TH
5. ecautions 1 Install only according to these 6 This product is not a toy Do not allow instructions Improper installation children to play with or near this item can create hazards 7 Inspect before every use do not use 2 Wear ANSI approved safety goggles if parts are loose or damaged and heavy duty work gloves 8 Verify that installation surface during installation has no hidden utility lines before 3 Keep installation area clean and well lit drilling or driving screws Keep bystanders out of the 9 The brass components of this product area during installation contain lead a chemical known to the State of California to cause birth defects or other reproductive harm California Health amp Safety Code 25249 5 et seq 5 Do not install when tired or when under the influence of alcohol drugs or medication Maintenance Precautions 1 Wipe away snow or debris on the 3 Position battery in proper polarity Solar Address Panel regularly 4 Remove the battery before storage 2 Use only Batteries of the type recommended AA NiCd Page 2 For technical questions please call 1 800 444 3353 Item 92650 Installation Instructions 1 Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document including all text under subheadings therein before set up or use of this product Assembly of House Numbers 1 Note Be careful to not stretch the wiring when setting the Circuit
6. o have other rights which vary from state to state 3491 Mission Oaks Blvd PO Box 6009 Camarillo CA 93011 800 444 3353
7. orkmanship for the period of 90 days from the date of purchase This warranty does not apply to damage due directly or indirectly to misuse abuse negligence or accidents repairs or alterations outside our facilities criminal activity improper installation normal wear and tear or to lack of maintenance We shall in no event be liable for death injuries to persons or property or for incidental contingent special or consequential damages arising from the use of our product Some states do not allow the exclusion or limitation of incidental or consequential damages so the above limitation of exclusion may not apply to you THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES EXPRESS OR IMPLIED INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS To take advantage of this warranty the product or part must be returned to us with transportation charges prepaid Proof of purchase date and an explanation of the complaint must accompany the merchandise If our inspection verifies the defect we will either repair or replace the product at our election or we may elect to refund the purchase price if we cannot readily and quickly provide you with a replacement We will return repaired products at our expense but if we determine there is no defect or that the defect resulted from causes not within the scope of our warranty then you must bear the cost of returning the product This warranty gives you specific legal rights and you may als
8. ry aside T Remove the Screws 10 4 With the Number Board 6 out from the Back Board 8 select the numbers from the Remove the small screw on the Number Labels 12 side center of the Housing 1 5 Peel backing from numbers and place Remove the Back Board the Reflector them carefully on the Number Board 6 Box 7 with the Circuitry 3 and the 6 If placing on inside of the panel Number Board 6 See Figure A be sure you reverse the number so the address reads correctly when placed back in frame Back Board 8 Screw 10 aM m Housing 1 Reflector Box 7 Circuitry 3 Figure A Replace the Number Board 6 and the Reflector Box 7 including Circuitry 3 positioning as before being careful not to stretch or crimp wires See Figure B Housing 1 Number Board 6 Figure B Item 92650 For technical questions please call 1 800 444 3353 Page 3 Removing the Tab to Activate Battery There is a pull off Tab 5 around the connection of the Battery 4 which blocks battery operation This Tab disconnects the battery to protect it from draining during shipment 1 Remove the Battery 4 and Tab 5 3 Replace the Back Board 8 and Save this Tab for future use secure with the Screws 10 See Figure C Be careful not to stretch or strain wires Make sure you have returned the side center screw into place See Figure E Tab 5 Screw 10 Back Board 8 Figure E Figure
Download Pdf Manuals
Related Search