Harbor Freight Tools Solar Decorative LED Lights _ 3 Pc Product manual
Contents
1. Do not put too much pressure on the Light Solar Panel or accessories while cleaning Dry thoroughly 2 WARNING Make sure the Power Switch is in its Off position a Unscrew the screws holding the Battery Cover 9 in place and remove the Battery Cover from the Solar Panel 1 b Remove the old battery before performing any inspection c NiCd BATTERY MUST BE maintenance or cleaning procedures RECYCLED OR DISPOSED OF PROPERLY 3 BEFORE EACH USE inspect the general condition of the tool Check for e leaking swollen or cracked battery Do not short incinerate or open battery d Install a new NiCd AA 300mAh loose hardware battery into the Battery e misalignment or binding of parts Compartment Check that the battery is placed according e cracked or broken parts and to the correct polarity e any other condition that may affect its safe operation 4 AFTER USE wipe external surfaces of the tool with clean cloth e Replace the cover and secure in place with the Screws Troubleshooting Light will 1 Power Switch 7 not set to On 1 Check position of Power Switch not turn on Battery not allowed time for recharging Check that Solar Panel has direct via Solar Panel access to sunlight Allow one to two days for a full charge Solar Light is set near nighttime Move Solar Light or change light Sources such as porch Solar Panel position lights or street lights Solar Pan2. full charge the Solar Garden Light may not achieve the full hours of operating time It will catch up on its own after two to three days of full sun 2 Make certain that the path of the Stake 5 is clear of lines cables and conduits 3 Push the Stake 5 directly into the ground Charging 1 The Solar Light Set will need to charge for at least twelve hours before using it for the first time 2 Set the Power Switch to ON 3 Allow to charge for two sunny days before use General Operating Instructions Move the Power Switch to ON to activate the Solar Light 2 The Light will automatically turn ON during the night After the initial charge is set check to see that the Light 2 is on by viewing the light at night or in a dark location If the Light 2 is not lit check the position of the Power Switch and check that the Solar Panel has had full sunlight for 6 to 12 hours Page 4 For technical questions please call 1 800 444 3353 Item 69462 Maintenance Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document including all text under subheadings therein before set up or use of this product A TO PREVENT SERIOUS INJURY FROM TOOL FAILURE Do not use damaged equipment If abnormal noise or vibration occurs have the problem corrected before further use 1 Clean regularly with a damp towel Do 5 Replace the battery every 12 months not use any type of solvent for cleaning
3. 0 Day Warranty Harbor Freight Tools Co makes every effort to assure that its products meet high quality and durability standards and warrants to the original purchaser that this product is free from defects in materials and workmanship for the period of 90 days from the date of purchase This warranty does not apply to damage due directly or indirectly to misuse abuse negligence or accidents repairs or alterations outside our facilities criminal activity improper installation normal wear and tear or to lack of maintenance We shall in no event be liable for death injuries to persons or property or for incidental contingent special or consequential damages arising from the use of our product Some states do not allow the exclusion or limitation of incidental or consequential damages so the above limitation of exclusion may not apply to you THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES EXPRESS OR IMPLIED INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS To take advantage of this warranty the product or part must be returned to us with transportation charges prepaid Proof of purchase date and an explanation of the complaint must accompany the merchandise If our inspection verifies the defect we will either repair or replace the product at our election or we may elect to refund the purchase price if we cannot readily and quickly provide you with a replacement We will return repaired products at our expense bu
4. Owner s Manual amp Safety Instructions Save This Manual Keep this manual for the safety warnings and precautions assembly operating inspection maintenance and cleaning procedures Write the product s serial number in the back of the manual near the assembly diagram or month and year of purchase if product has no number Keep this manual and the receipt in a safe and dry place for future reference one stop d oC Solar Light Set Visit our website at http www harborfreight com Email our technical support at tech harborfreight com ITEM 69462 When unpacking make sure that the product is intact and undamaged If any parts are missing or broken please call 1 800 444 3353 as soon as possible AWARN I NG Copyright 2012 by Harbor Freight Tools All rights reserved No portion of this manual or any artwork contained herein may be reproduced in Read this material before using this product any shape or form without the express written consent of Harbor Freight Tools Failure to do so can result in serious injury Diagrams within this manual may not be drawn proportionally Due to continuing SAVE THIS MANUAL improvements actual product may differ slightly from the product described herein Tools required for assembly and service may not be included Specifications Battery Type AA NiCd rechargeable Battery Rating 300mAh Running time when 8 hours fully charged Important Safety Information 1 Assemble only accordi
5. cover and remove the battery cover 2 Insert the AA battery into the battery housing paying attention to the polarity 3 Replace the Battery cover and secure with the screws 4 Set one of the Decorative LED Shapes 2 onto the Top Tube 3 Slide the Top Tube 3 into the Bottom Tube 4 Slide the Stake 5 onto the Bottom Tube 4 5 Repeat steps 1 3 for the other two light sets Functions Top Tube 3 Battery Cover 9 On back of Solar Panel gt lt Solar Panel 1 I Power Switch 7 On back of Solar Panel lt Bottom Tube 4 lt Stake 5 Figure A Item 69462 For technical questions please call 1 800 444 3353 Page 3 Operating Instructions A Tool Set Up 1 Decide where you want to place the Solar Light Set Choose a location that receives full direct sunlight a minimum of six hours a day The location should not be near nighttime light sources such as porch lights or streetlights as this will cause the Solar Light Set to remain off Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before set up or use of this product Note During the day the Solar Panel converts sunlight into electricity recharging the battery The amount of light the Solar Panel receives depends on placement of the Solar Light geographic location and weather If the weather is cloudy and the panel did not receive a
6. el is dirty and Clean Solar Panel with a soft cloth covered with dirt or dust Item 69462 For technical questions please call 1 800 444 3353 Page 5 PLEASE READ THE FOLLOWING CAREFULLY THE MANUFACTURER AND OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS DOCUMENT AS A REFERENCE TOOL ONLY NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT IN FACT THE MANUFACTURER AND OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER THE BUYERASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO Page 6 For technical questions please call 1 800 444 3353 Item 69462 Parts List and Diagram Description Part Description __ Qty 6 Battery 3 8 Screw 9 9 Battery Cover 3 Record Serial Number Here Note If product has no serial number record month and year of purchase instead Note Some parts are listed and shown for illustration purposes only and are not available individually as replacement parts Item 69462 For technical questions please call 1 800 444 3353 Page 7 Limited 9
7. ng to these 7 WARNING The brass components of instructions Improper assembly this product contain lead a chemical can create hazards known to the State of California to cause birth defects or other reproductive harm California Health amp Safety code 25249 5 et seq This product is not a toy Do not allow Keep bystanders out of the children to play with or near this item area during assembly 2 Wear ANSI approved safety goggles during assembly Keep assembly area clean and well lit 9 Use as intended only 5 Do not assemble when tired or when under the influence of drugs or medication 10 Inspect before every use do not use if parts are loose or damaged 11 Maintain product labels and nameplates These carry important safety information If unreadable or missing contact Harbor Freight Tools for a replacement 6 Position battery in proper polarity and do not install batteries of different types charge levels or capacities together Page 2 For technical questions please call 1 800 444 3353 Item 69462 Assembly Instructions Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document including all text under subheadings therein Note For additional information regarding the parts listed in the following before set up or use of this product pages refer to the Assembly Diagram near the end of this manual Assembly 1 Unthread the two screws on the battery
8. t if we determine there is no defect or that the defect resulted from causes not within the scope of our warranty then you must bear the cost of returning the product This warranty gives you specific legal rights and you may also have other rights which vary from state to state one stop ard 3491 Mission Oaks Blvd PO Box 6009 Camarillo CA 93011 800 444 3353
Download Pdf Manuals
Related Search