Harbor Freight Tools 4 Pc Caster Set for SKU 90154 Product manual
Contents
1. CASTER REPLACEMENT KIT FOR SKU 90154 TRAILER Kexel 318 7616 Distributed exclusively by Harbor Freight Tools 3491 Mission Oaks Blvd Camarillo CA 93011 Visit our website at http www harborfreight com SAVE THESE INSTRUCTIONS READ ALL PRE CAUTIONS AND INSTRUCTIONS Copyright 2008 by Harbor Freight Tools All rights reserved No portion of this document or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools Diagrams within this document may not be drawn proportionally Due to continuing improvements actual product may differ slightly from the product described herein Tools required for assembly and service may not be included For technical questions or replacement parts please call 1 800 444 3353 SPECIFICATIONS Part Quantity 3 Diameter Casters 1 2 x20 TPI Nylock Nuts 1 2 Flat Washers Tools Required 12 mm wrench 13 mm socket 13 16 in wrench 3 4 in socket e 1 pc 3 8 in drive ratchet 1 pc 12 in Groove joint pliers e 1 pc Step drill or 1 2 in diameter drill bit for drilling metal e 1 pc 1 2 in chuck capacity drill e 1 pe 1 pe e 1 pe e 1 pe xw y y a a a UNPACKING When unpacking check to make sure that the item is intact and undamaged If any parts are miss ing or broken please call Harbor Freight Tools at the number shown on the cover of this document as soon as poss2. ible Assembly Precautions 1 Assemble only according to these instructions Improper assembly can create hazards 2 Wear ANSI approved safety goggles and heavy duty work gloves during assembly 3 Keep assembly area clean and well lit 4 1 Keep bystanders out of the area during assem bly Do not assemble when tired or when under the influence of drugs or medication Use Precautions This product is not a toy Do not allow children to play with or near this item Use for intended purpose s only Inspect before use do not use if parts loose or damaged Maintain product labels and nameplates These carry important safety information If unreadable or missing contact Harbor Freight Tools for a replacement Assembly Instructions Assembly In order to avoid property ACAUTION damage or injury this procedure must be performed with the trailer in the transport position resting horizontally on the tongue and street tires and the street tires chocked Remove the old casters from the caster base 30L amp 30R using a 13 mm socket with ratchet and a 12 mm wrench See figures below 2 5 Ratchet Using step drill and 1 2 drill bit not included enlarge the old caster mounting holes to 4 See figures below 1 2 in diameter drill bit 1 2 in capacity drill chuck a Insert the new casters into the enlarged mounting holes then secure them using the flat washer
3. s and nylock nuts included with the kit See figure below Using a socket with ratchet and a 13 16 in wrench tighten the nylock nuts installed onto the casters in step number 3 See figure above l ms P 2 Ratchet N S 4 in Socket NEW CASTER INCLUBED If the 13 16 wrench gets wedged between the caster and caster base while tightening the nylock nut loosen the nylock nut just enough to remove the wrench Then use a pair of groove joint pliers to grip the bearing apron on the caster in order to tighten the nylock nut See figure above SKU 87616 For technical questions please call 1 800 444 3353 Page 2
Download Pdf Manuals
Related Search