Hans Grohe Uno 38020XX1 User's Manual
Contents
1. 0455 In requesting warranty service you will need to provide 1 _ The sales receipt or other evidence of the date and place of purchase 2 A description of the problem 3 Delivery of the product or the defective part postage prepaid and carefully packed and insured to Hansgrohe Inc 1492 Bluegrass Lakes Parkway Alpharetta Georgia 30004 Attention Technical Service if required by Hansgrohe When warranty service is completed any repaired or replacement product or part will be returned to you postage prepaid EXCLUSIONS AND LIMITATIONS REPAIR OR REPLACEMENT OR IN LIMITED CIRCUMSTANCES REFUND OF THE PURCHASE PRICE AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE PURCHASER HANSGROHE NEITHER ASSUMES NOR AUTHORIZES ANY PERSON TO CREATE FOR IT ANY OBLIGATION OR LIABILITY IN CONNECTION WITH THIS PRODUCT HANSGROHE SHALL NOT BE LIABLE TO PURCHASER OR ANY PERSON FOR ANY INCIDENTAL SPECIAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF BREACH OF THIS WARRANTY OR ANY IMPLIED WARRANTY INCLUDING MERCHANTABILITY Some States do not allow the exclusion or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you This warranty gives you specific legal rights and you may have other rights which vary from State to State You may be required by law to give us a reasonable opportunity to correct or cure any failure to comply before you can bring any action in court against us u2. stated in the following two sentences If you are a consumer who purchased the product for use primarily for personal family or household purposes this warranty extends for as long as you own the product and the home in which the product is installed If you purchased the product for use primarily for any other purpose including without limitation a commercial purpose this warranty extends only i for 1 year with respect to Interaktiv and Retroaktiv products and ii for 5 years with respect to AXOR ShowerPower and Pharo products j AXOR ansgrohe THIS WARRANTY DOES NOT COVER AND HANSGROHE WILL NOT PAY FOR A Conditions malfunctions or damage not resulting from defects in material or workmanship B Conditions malfunctions or damage resulting from 1 improper installation improper maintenance misuse abuse negligence accident or alteration or 2 the use of abrasive or caustic cleaning agents or no rinse cleaning products or the use of the product in any manner contrary to the product instructions Labor or other expenses for the disconnection or return of the product for warranty service or for installation or reinstallation of the product D Accessories or related products not manufactured by Hansgrohe TO OBTAIN WARRANTY SERVICE Contact your Hansgrohe retailer or write to Technical Service at Hansgrohe Inc 1492 Bluegrass Lakes Parkway Alpharetta 30004 Or call Hansgrohe toll free at 800 334
3. T Uno 38020XX1 38025XX1 38210XX1 ansgrohe 2 2005 90540401 Uno single control lavatory faucet 38020 1 Uno tall single control lavatory faucet 38025 1 Uno single control bidet faucet 38210XX1 14 133 9 Technical Specification Maximum water pressure 145 psi Recommended water pressure 14 5 72 psi Maximum hot water temp 1769 Recommended hot water temp 120 1409 gt Max flow rate 45 psi 2 2 gpm Max deck thickness 1 3 8 Hole size in deck 1 3 8 Many municipalities require that the water heater be set no higher than 120 Please know and follow all applicable plumbing codes when setting the temperature on the water heater Installation considerations 7y This unit should be installed by a licensed professional plumber l mox 15 amp gt 4 6 The supply hoses installed on this unit connect to the supply stops with i standard 3 8 compression fittings Supply stops and 3 8 compression fittings are not included Bidet faucet 38210XX1 is not for use on a bidet with a vertical spray _ 8 2 XOR Installation Instructions e Sit the faucet with black sealing ring in the faucet hole on top of the mounting surface e From beneath install the friction washer metal washer and mounting nut Tighten the mounting nut taking care not to overtig
4. he retainer nut Sit the plunger assembly in the drain Install the horizontal rod so that the end goes through the loop in the bottom of the height adjuster Install and hand tighten the pivot ball nut Attach the swivel connector to the end of the horizontal rod Attach the swivel connector to the end of the vertical rod Position as desired and tighten with a small flathead screwdriver plunger height adjuster a vertical rod plunger assembly O drain outlet flange sealing gasket mack gasket gt _ lt _ friction ring retainer nut SSS retainer nut pivot horizontal rod swivel connector pivot ball gasket tailpiece AXOR jansgrohe User Instructions e the handle back to turn the water on and forward to turn the water off e Pivot the handle to the left to make the water warmer to the right to make the water cooler Re set the high temperature limit stop optional This step should be taken if the faucet is to be used by small children or others who should be protected from scalding e Pull out the screw cover located on the back of the handle e Use a 4 mm allen wrench to loosen the set screw e off the nut cover and the green high temperature limit stop ring e Reinstall the high temperature limit stop ring so that the black positioning pin is in the notch cor
5. hten e Check the position of the faucet When satisfied use a slotheaded screwdriver to tighten the tensioning screws e Feed the pull rod through the hole in the back of the faucet body e Attach the supply lines to the supply stops with standard 3 8 compression fittings not included Push the compression nut and ferrule over the hose shank Push the hose shank into the supply stop Tighten the compression nut wrench tight Replacement Parts 1 handle 38094XXX 1 1 screw cover 96762000 1 2 set screw 96029000 2 flange 96763XXX 3 nut 97209000 4 cartridge 96764000 5 seal 95008000 6 aerator 9737 0XXX 7 fixing set 13961000 8 pull rod 96657000 9 ball joint 96050XXX aerator 94005 ep sealing ring friction washer metal washer 2 mounting CRC nut tensioning screws Install the pop up drain Remove the plunger assembly Unscrew the drain outlet flange from the tee Unscrew the tailpiece from the tee Wrap the threads with plumbers thread tape and replace Install the white flexible sealing gasket to the flange Sit it in the sink outlet From under the sink install the black mack gasket white friction ring and retainer nut to the flange Do not tighten the nut against the bottom of the sink at this time Thread the tee and tailpiece to the flange The pivot must face the faucet If necessary turn the drain assembly Tighten t
6. irectly onto the product e After cleaning rinse thoroughly with clear water to remove any cleaner residue Important e Soap and shampoo residue can also cause damage to the product Rinse well with clean water after use e Ifthe surface is already damaged harsh cleaning materials will cause further damage Limited Lifetime Consumer Warranty his product has been manufactured and tested to the highest quality standards by Hansgrohe Inc Hansgrohe This warranty is limited to Hansgrohe products which are purchased by a consumer in the United States after March 1 996 and installed in either the United States or Canada WHO IS COVERED BY THE WARRANTY his warranty extends to the original consumer purchaser only WHAT IS COVERED BY THE WARRANTY his warranty covers only your Hansgrohe manufactured product Hansgrohe warrants this product against defects in material or workmanship as follows Hansgrohe will repair at no charge for parts only or at its option replace any product or part of the product which proves defective because of improper workmanship and or material under normal installation use service and maintenance If Hansgrohe is unable to provide a replacement and repair is not practical or cannot be timely made Hansgrohe may elect to refund the purchase price in exchange for the return of the product LENGTH OF WARRANTY Replacement or repaired parts of products will be covered for the term of this warranty as
7. nder the Magnuson Moss Warranty Act PRODUCT INSTRUCTIONS AND QUESTIONS Upon purchase or prior to installation please carefully inspect your Hansgrohe product for any damage or visible defect Prior to installing always carefully study the enclosed instructions on the proper installation and the care and maintenance of the product If you have questions at any time about the use installation or performance of your Hansgrohe product or this warranty please call or write to us at the toll free number and address printed above AXOR 7 ansgrohe ansgrone Hansgrohe Inc e 1490 Bluegrass Lakes Parkway e Alpharetta GA 30004 Tel 770 360 9880 e Fax 770 360 9887 www hansgrohe USA com
8. responding to the desired high temperature The temperatures shown in the diagram assume an incoming cold water temperature of 50 F and an incoming hot water temperature of 140 Center and replace the nut cover e Replace the handle e Tighten the set screw XOR 9 Cleaning Recommendation for Hansgrohe Products Modern faucetry and shower products utilize a combination of materials to comply with the needs of the market with regard to design and functionality To avoid damage it is necessary to use some caution when cleaning Damage caused by improper treatment is not covered under the Hansgrohe warranty Cleaning Materials for Faucets and Showers e To remove lime scale use only products made specifically for that purpose Always follow the manufacturer s instructions when using Do not use cleaners that contain hydrochloric formic acetic or phosphoric acids as these will cause considerable damage to finishes and to plastic components e Never mix cleaning materials e Never use cleaners containing abrasives Do not use abrasive cleaning cloths pads or sponges Cleaning Procedures e Clean your faucets and shower products as and when required Regular cleaning will prevent scale buildup and water spotting e Follow the label instructions Do not allow any cleaner to remain on the product for longer than necessary e When using spray cleaners spray first onto a sponge or cloth do not spray d
Download Pdf Manuals
Related Search