Hans Grohe Metris 31261XX1 User's Manual
Contents
1. Metris 31060XX1 31020XX1 31261XX1 ansgrohe Metris Single Control Lavatory Mixer 31060XX1 Tall Lavatory Mixer 31020XX 1 Single Control Bidet Mixer 31261XX1 Th 63 max 154 slw 31060XX1 31020XX1 31261XX1 Technical Specification Recommended incoming water pressure 22 72 PSI Recommended incoming hot water temperature 120 140 F Hole size in mounting surface 1 3 8 Maximum mounting surface thickness 1 5 8 Flow rate 2 2 gpm max Supply hoses require stops with 3 8 compression fittings not included Bidet mixer 31261XX1 is not intended for use on a bidet with a vertical spray some municipalities have codes limiting the maximum temperature of the water heater to 120 F or less Please know and follow all applicable local codes when setting the temperature on the water heater User Instructions Pivot the handle up to turn the water on Pivot it down to turn the water off Pivot the handle to the right to obtain cooler water to the left to obtain warmer water 2 Installation Place the faucet and the sealing ring on the countertop From below install the fiber washer friction washer and mounting nut Tighten the mounting nut and the tension ing screws sealing ring H fiber washer A LD friction washer AL mounting nut AD tensioning screws AHH Quo Attach the hoses to the supply stops with 3 8 compres si2. or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you This warranty gives you specific legal rights and you may have other rights which vary from State to State You may be required by law to give us a reasonable opportunity to correct or cure any failure to comply before you can bring any action in court against us under the Magnuson Moss Warranty Act PRODUCT INSTRUCTIONS AND QUESTIONS Upon purchase or prior to installation please carefully inspect your Hansgrohe product for any damage or visible defect Prior to installing always carefully study the enclosed instructions on the proper installation and the care and maintenance of the product If you have questions at any time about the use installation or performance of your Hansgrohe product or this warranty please call or write to us or call us toll free at 800 334 0455 fo a Exo ce a Hansgrohe Inc e 1490 Bluegrass Lakes Parkway e Alpharetta GA 30004 Tel 770 360 9880 e Fax 770 360 9887 US Installation Instructions e Part No 90597201 e Revised 10 2006 www hansgrohe USA com
3. Close the drain OR cover it with a wash cloth Use the included 4 mm Allen wrench to push the screw cover into the handle Retrieve the screw cover when the handle is removed Use the 4mm Allen wrench to loosen the handle screw 4 complete revolutions Remove the handle and put it in a safe place Remove the decorative nut cover and put it in a safe place Remove the handle screw from the stem of the cartridge Remove the high temperature limit stop Replace the high temperature limit stop so that the pin on the cartridge is in the desired slot on the limit stop Note the temperatures given in the diagram assume a water heater temperature of 1409 F a cold water temperature of 509 F and a water pressure of 45 PSI Replace the decorative nut cover Replace the handle screw Use the Allen wrench to turn the screw 4 revolutions Replace the handle Finish tightening the handle screw Turn on the water and test the faucet Replacement Parts 1 handle 31093 XXX 1 1 screw cover 96338000 2 flange 97 A06XXX 3 nut 97209000 4 cartridge 927 30000 5 seal 95008000 6 aerator 13912XXX 7 fixing set 13961000 8 connection hose 96321001 9 pull rod 96657XXX 10 handle screw 96059000 11 o ring 30x 2 98186000 12 o ring 35 x 2 92604000 13 ball joint 97362XXX 14 aerator 97 360XXX 15 connection hose 96316001 XXX color 000 chrome 820 brushed nickel Cleaning Recommendation for Hansgrohe Products M
4. er cleaning rinse thoroughly with clean water to remove any cleaner residue Important Residues of liquid soaps shampoos and shower foams can also cause damage so rinse with clean water after using Please note if the surface is already damaged the effect of cleaning materials will cause further damage Components with damaged surfaces must be replaced or injury could result Damage caused by improper treatment is not covered under the warranty Limited Lifetime Consumer Warranty This product has been manufactured and tested to the highest quality standards by Hansgrohe Inc Hansgrohe This warranty is limited to Hansgrohe products which are purchased by a consumer in the United States after March 1 1996 and installed in either the United States or Canada WHO IS COVERED BY THE WARRANTY This warranty extends to the original consumer purchaser only This warranty is non transferable WHAT IS COVERED BY THE WARRANTY This warranty covers only your Hansgrohe manufactured product Hansgrohe warrants this product against defects in material or workmanship as follows Hansgrohe will repair at no charge for parts only or at its option replace any product or part of the product that proves defective because of improper workmanship and or material under normal installation use service and maintenance If Hansgrohe is unable to provide a replacement and repair is not practical or cannot be timely made Hansgrohe may elect to refund the p
5. odern lavatory faucets kitchen faucets and showers consist of very different materials to comply with the needs of the market with regard to design and functionality To avoid damage and returns it is necessary to consider certain criteria when cleaning Cleaning Materials for Faucets and Showers Acids are a necessary ingredient of cleaning materials for removing lime however please pay attention to the following points when cleaning faucets and showers e Only use cleaning materials which are explicitly intended for this type of application e Never use cleaning materials which contain hydrochloric formic phosphoric or acetic acid as they cause considerable damage e Never mix one cleaning material with another e Never use cleaning materials or appliances with an abrasive effect such as unsuitable cleaning powders sponge pads or micro fiber cloths Cleaning Instructions for Faucets and Showers Please follow the cleaning material manufacturer s instructions In addition pay attention to the following points e Clean the faucets and showers as and when required e Use the amount of cleaning product and the amount of time recommended by the manufacturer Do not leave the cleaner on the fixture longer than necessary e Regular cleaning can prevent calcification e When using spray cleaners spray first onto a soft cloth or sponge Never spray directly onto the faucet as droplets can enter openings and gaps and cause damage e Aft
6. on fittings not included Use two wrenches as shown to prevent the hoses from twisting or from becoming loose Install the pop up drain see page 4 Turn on the water and check all connections for leaks Install the Pop up Drain plunger Remove the plunger assembly height adjust Unscrew the drain outlet flange from the EE EE tee flange Unscrew the tailpiece from the tee Wrap the threads with plumbers thread tape and replace Install the white flexible sealing gasket to the flange Place it in the sink outlet sealing gasket From under the sink install the black mack gasket white friction ring and retainer nut pull rod mack gasket amp Sm to the flange Do not tighten the nut against ee the bottom of the sink at this time friction ring Thread the tee and tailpiece to the flange retainer nut The pivot must face the faucet If neces sary turn the drain assembly tee Tighten the retainer nut pivot ball nut Place the plunger assembly in the drain Install the horizontal rod so that the end a goes through the loop in the bottom of the tailpiece height adjuster horizontal rod Install and hand tighten the pivot ball nut EEP swivel connector Attach the swivel connector to the end of the horizontal rod Attach the swivel connector to the end of the pull rod Position as desired and tighten with a small flathead screwdriver Reset the High Temperature Limit Stop optional
7. oper packaging and shipping costs or for installation or reinstallation of the product D Accessories connected materials and products or related products not manufactured by Hansgrohe TO OBTAIN WARRANTY PARTS OR INFORMATION Contact your Hansgrohe retailer or contact Technical Service at Hansgrohe Inc 1492 Bluegrass Lakes Parkway Alpharetta GA 30004 Toll free 800 334 0455 In requesting warranty service you will need to provide 1 The sales receipt or other evidence of the date and place of purchase 2 A description of the problem 3 Delivery of the product or the defective part postage prepaid and carefully packed and insured to Hansgrohe Inc 1492 Bluegrass Lakes Parkway Alpharetta Georgia 30004 Attention Technical Service if required by Hansgrohe When warranty service is completed any repaired or replacement product or part will be returned to you postage prepaid EXCLUSIONS AND LIMITATIONS REPAIR OR REPLACEMENT OR IN LIMITED CIRCUMSTANCES REFUND OF THE PURCHASE PRICE AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE PURCHASER HANSGROHE NEITHER ASSUMES NOR AUTHORIZES ANY PERSON TO CREATE FOR IT ANY OBLIGATION OR LIABILITY IN CONNECTION WITH THIS PRODUCT HANSGROHE SHALL NOT BE LIABLE TO PURCHASER OR ANY PERSON FOR ANY INCIDENTAL SPECIAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF BREACH OF THIS WARRANTY OR ANY IMPLIED WARRANTY INCLUDING MERCHANTABILITY Some States do not allow the exclusion
8. urchase price in exchange for the return of the product LENGTH OF WARRANTY Replacement or repaired parts of products will be covered for the term of this warranty as stated in the following two sentences If you are a consumer who purchased the product for use primarily for personal family or household purposes this warranty extends for as long as you own the product and the home in which the product is originally installed If you purchased the product for use primarily for any other purpose including without limitation a commercial purpose this warranty extends only i for 1 year with respect to Hansgrohe and Commercial products and ii for 5 years with respect to AXOR products THIS WARRANTY DOES NOT COVER AND HANSGROHE WILL NOT PAY FOR A Conditions malfunctions or damage not resulting from defects in material or workmanship B Conditions malfunctions or damage resulting from 1 normal wear and tear improper installation improper maintenance misuse abuse negligence accident or alteration or 2 the use of abrasive or caustic cleaning agents or no rinse cleaning products or the use of the product in any manner contrary to the product instructions 3 Conditions in the home such as excessive water pressure or corrosion C Labor or other expenses for the disconnection deinstallation or return of the product for warranty service or for installation or reinstallation of the product including but not limited to pr
Download Pdf Manuals
Related Search