Hans Grohe Metris 31100XX1 User's Manual
Contents
1. packed and insured to Hansgrohe Inc 1492 Bluegrass Lakes Parkway Alpharetta Georgia 30004 Attention Technical Service if required by Hansgrohe When warranty service is completed any repaired or replacement product or part will be returned to you postage prepaid EXCLUSIONS AND LIMITATIONS REPAIR OR REPLACEMENT OR IN LIMITED CIRCUMSTANCES REFUND OF THE PURCHASE PRICE AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE PURCHASER HANSGROHE NEITHER ASSUMES NOR AUTHORIZES ANY PERSON TO CREATE FOR IT ANY OBLIGATION OR LIABILITY IN CONNECTION WITH THIS PRODUCT HANSGROHE SHALL NOT BE LIABLE TO PURCHASER OR ANY PERSON FOR ANY INCIDENTAL SPECIAL OR CONSE QUENTIAL DAMAGES ARISING OUT OF BREACH OF THIS WARRANTY OR ANY IMPLIED WARRANTY INCLUDING MERCHANTABILITY 10 Some States do not allow the exclusion or limitation of incidental or consequential damages so the above limitation or exclu sion may not apply to you This warranty gives you specific legal rights and you may have other rights which vary from State to State You may be required by law to give us a reasonable opportunity to correct or cure any failure to comply before you can bring any action in court against us under the Magnuson Moss Warranty Act PRODUCT INSTRUCTIONS AND QUESTIONS Upon purchase or prior to installation please carefully inspect your Hansgrohe product for any damage or visible defect Prior to installing always carefully study the enclosed i2. Hansgrohe products which are purchased by a consumer in the United States after March 1 1996 and installed in either the United States or Canada WHO IS COVERED BY THE WARRANTY This warranty extends to the original consumer purchaser only This warranty is non transferable WHAT IS COVERED BY THE WARRANTY This warranty covers only your Hansgrohe manufactured product Hansgrohe warrants this product against defects in material or workmanship as follows Hansgrohe will repair at no charge for parts only or at its option replace any product or part of the product that proves defective because of improper workmanship and or material under normal installation use service and maintenance If Hansgrohe is unable to provide a replacement and repair is not practical or cannot be timely made Hansgrohe may elect to refund the purchase price in exchange for the return of the product LENGTH OF WARRANTY Replacement or repaired parts of products will be covered for the term of this oy as stated in the following two sentenc es If you are a consumer who purchased the product for use primarily for personal family or household purposes this war ranty extends for as long as you own the product and the home in which the product is originally installed If you purchased the product for use primarily for any other purpose including without limitation a commercial purpose this warranty extends only i for 1 year with respect to Hansgrohe and Commercial pro
3. Metris 31100XX1 Metris 31101XX1 ansgrone Metris Electronic Lavatory Faucet with Temperature Control 31100XX1 Metris Electronic Lavatory Faucet 31101XX1 Technical Data Max water pressure 116 psi Recommended pressure 14 5 72 psi Max hot water temp 158 F Recommended hot water temp 120 F 140 F Flow rate 1 5 gpm 44 psi Automatic shutoff after 35 uni Hole size in mounting surface 11 4 Max mounting surface thickness 1 1 8 e For best results Hansgrohe recommends that this unit be installed by a licensed professional plumber e This faucet is listed by IAPMO and is approved for use in Massachusetts e This faucet cannot be used with a continuous flow water heater Please know and follow all applicable local plumbing codes when setting the temperature on the water heater Caution Do not bend or twist the supply hoses Installation Flush the hot and cold supplies thoroughly before install ing this faucet Place the faucet in the hole on the mounting surface 1 Tighten the mounting nut 2 Install the adapters and filters on the stops 3 Install the supply lines 4 Be careful not to twist the supply lines or they may become loose from the faucet causing a leak Turn the water on to the faucet 1 Peel the protective film from the sensor 2 Wait 15 seconds the place a hand in front of the sensor 3 The water should turn on automatically M
4. cid as they cause considerable damage e Never mix one cleaning material with another e Never use cleaning materials or appliances with an abrasive effect such as unsuitable cleaning powders sponge pads or micro fiber cloths Cleaning Instructions for Faucets and Showers Please follow the cleaning material manufacturer s instructions In addition pay attention to the following points e Clean the faucets and showers as and when required e Use the amount of cleaning product and the amount of time recommended by the manufacturer Do not leave the cleaner on the fixture longer than necessary e Regular cleaning can prevent calcification e When using spray cleaners spray first onto a soft cloth or sponge Never spray directly onto the faucet as droplets can enter openings and gaps and cause damage e After cleaning rinse thoroughly with clean water to remove any cleaner residue Important Residues of liquid soaps shampoos and shower foams can also cause damage so rinse with clean water after using Please note if the surface is already damaged the effect of cleaning materials will cause further damage Components with damaged surfaces must be replaced or injury could result Damage caused by improper treatment is not covered under the warranty Limited Lifetime Consumer Warranty This product has been manufactured and tested to the highest quality standards by Hansgrohe Inc Hansgrohe This warranty is limited to
5. ducts and ii for 5 years with respect to AXOR products THIS WARRANTY DOES NOT COVER AND HANSGROHE WILL NOT PAY FOR A Conditions malfunctions or damage not resulting from defects in material or workmanship B Conditions malfunctions or damage resulting from 1 normal wear and tear improper installation improper mainte nance misuse abuse negligence accident or alteration or 2 the use of abrasive or caustic cleaning agents or no rinse cleaning products or the use of the product in any manner contrary to the product instructions 3 Conditions in the home such as excessive water pressure or corrosion C Labor or other expenses for the disconnection deinstallation or return of the product for warranty service or for installa tion or reinstallation of the product including but not limited to proper packaging and shipping costs or for installation or reinstallation of the product D Accessories connected materials and products or related products not manufactured by Hansgrohe TO OBTAIN WARRANTY PARTS OR INFORMATION Contact your Hansgrohe retailer or contact Technical Service at Hansgrohe Inc 1492 Bluegrass Lakes Parkway Alpharetta GA 30004 Tollfree 800 334 0455 In requesting warranty service you will need to provide 1 The sales receipt or other evidence of the date and place of purchase 2 A description of the problem 3 Delivery of the product or the defective part postage prepaid and carefully
6. nstructions on the proper installation and the care and maintenance of the product If you have questions at any time about the use installation or performance of your Hansgrohe product or this warranty please call or write to us or call us toll free at 800 334 0455 11 ansgrohe Hansgrohe Inc e 1490 Bluegrass Lakes Parkway e Alpharetta GA 30004 Tel 770 360 9880 Fax 770 360 9887 www hansgrohe USA com US Installation Instructions e Part No 90590021 e Revised 05 2008
7. odel 31100 only Pivot the temperature control lever forward to make the water cooler 4 Model 31101 only Set the temperature Turn the water off at the stops Remove the set screw on the back of the faucet Pull the faucet housing off 1 Use a screwdriver to set the water temperature 2 Turn the screw to the rear to make the water warmer to the front to make it cooler Replace the faucet housing Tighten the set screw Cleaning Block the sensor for 5 seconds 1 This will turn the water off for approximately 90 seconds so that the sink may be cleaned 2 Faucet Maintenance Replace the battery When the battery is low the sensor will flash Remove the set screw from the back of the faucet 1 Remove the handle screw and handle model 31100 only 2 Remove the faucet housing 3 Remove the old battery 4 Install a new Lithium CR P2 6V battery 5 VA Lithium CR P2 6V Reset the faucet Remove the set screw with a 2 5 mm Allen wrench Block the sensor for 2 seconds Wait 10 seconds 1 then replace the set screw 2 Wait 15 seconds 3 Place a hand in front of the sensor 4 The water should turn on Clean the filters and aerator If the flow of water is reduced the aerator and or the fil
8. ters must be cleaned To clean the aerator Block the sensor for 5 seconds to temporarily shut off the water 1 Unscrew and remove the vandal resistant aerator using the enclosed key 2 Flush any debris from the aerator at another faucet Replace the aerator To clean the filters Turn the water off at the stops Disconnect the supply hoses from the adapters Remove and clean the filters Note Remove and inspect the check valves yearly Replacement Parts 1 aerator 98612000 2 solenoid valve 96904000 3 fixation set 97812000 4 connection hose 98809000 5 check valve 96456000 6 electronics 96905000 7 battery 97399000 Important note the check valves should be removed and inspected yearly Cleaning Recommendation for Hansgrohe Products Modern lavatory faucets kitchen faucets and showers consist of very different materials to comply with the needs of the market with regard to design and functionality To avoid damage and returns it is necessary to consider certain criteria when cleaning Cleaning Materials for Faucets and Showers Acids are a necessary ingredient of cleaning materials for removing lime however please pay attention to the following points when cleaning faucets and showers e Only use cleaning materials which are explicitly intended for this type of application e Never use cleaning materials which contain hydrochloric formic phosphoric or acetic a
Download Pdf Manuals
Related Search