Haier XPB135-LA User's Manual
Contents
1. OFF OFF then T back 15 5 DRAIN u 4 2 SPIN TIMER 12 f WASH TIMER s WASH SELECTOR DRAIN SELECTOR 3 Wash 1 Inlet selector A 1 Set inlet selector to Wash side Figure 1 7 2 Adjust water level rod to a position as needed ke ISE 2 Fill water and add solved powder detergent until water reaches a suitable level It begin to wash to dispense detergent uniformly Figure 2 Page 7 STANDARD 3 Put in the wash load and supplement water Figure 3 as necessary f 4 Select intensity Select soft or standard water flow intensity according to wash load Figure 3 WASHTIMER 5 Select wash time Select wash time according to wash load Figure 4 IN DRAIN tey 6 After completion of wash please set drain switch at Drain position Figure 5 Figure 5 DRAIN SELECTOR Figure 4 Midway spinning 1 Put the laundries into the spin tub evenly and smoothly 2 Spin 1 Put the gland in properly e Please put in the gland properly even if the laundries quantity is small Push Gland 4 Push O e Proper The laundries Proper No gland are slanting 2 Close the inner and outer cover of the spin tub Outer cover of The spin tub Inner cover of 3 Spin for 1 2 minutes The spin tub 3 Run the foam removing spinning 1 Set the inlet selector handle on spin side and Water inlet fill water for about 1 min Inlet selector handle e Incase water flows o2. operate in strict conformity to the contents otherwise it may cause damage of the machine or injure the personal safety of the user Warning sign Contents marked with that symbol are actions forbidden to perform Performing of those actions may result in damage of the machine or injure the personal safety of he user Please check if the power receptacle has good earthing condition before using to guarantee your safety Forbidding sign Safety precautions Please insert the power cord into special receptacle with rated vol tage Be sure to use single phase three pins receptacle The earthing terminal of the receptacle must be earthed reliably If possible please adopt electric leakage protector When the machine is normally using please put the power plug at the location easily to be insert ed and extracted by hand Be sure to pull the plug off when there s power failure or the machine is being moved cleaned or when it DY If the power cord is bad to avoid risk technicians of our special shop or the Keep the pin of the power plug clean Do not put the machine at damp place like the bathroom Never wash it with water Do not place wet laundries on the control panel it is required to replace it by the customer care department 2 YY AS a Do not use water hotter than 50 C In case the washing machine is installed on ground with carpet do not block the Do not wash water pr
3. the order of 1 3 heading for the side of the spin tub See to Figure 3 Embed the drain hose into the i l POTH groove with hands Take care not Extendtothe Figure3 to damage the drain hose in spin tub side Embed into the fastening the fixing clamp groove in turn Install the water inlet hose Select the water level e Insert the water inlet hose into the water filling entrance on the control panel To dismantle the water inlet pipe Water inlet hose just push the control handle as indicated in the ences figure and pull it out indicator ater inlet Maximum Max gt Select water level according to the quantity of the laundries Medium 24 Set the water level adjusting lever minimum to needed line Preparation before washing Preparation before washing 1 Connect the water inlet hose 2 Confirm that the washing machine is earthed reliably Then insert the power plug into the receptacle Do not connect the earth terminal to the gas pipe and tap water pipe 3 Put down the drain hose 4 Slanting or uneven ground may result in unstable working or abnormal noise Please make the machine stand horizontally The quantity of the laundries shall not be too large Stretch Check if _ Clear the the laundries pocket Take strips fasten has special out the coins the buttons Tie the long is running but
4. It is suggested not to use high sudsing detergent Usage of the detergent How to use the whitener How to use the washing powder Fill water to decided level Dilute Direct dissolved in the machine the whitener with container 1 Fill small quantity of water Pour it slowly into thewashing tub 2 Add the powder Run for 30 seconds to dissolve it completely e Avoid using whitener on laun 3 Put it in the laundries Select suitable dries with color or pattern as they water level are prone to lose color The instant dissolving of the washing The whitener shall not touch powder the laundries directly 1 Prepare warm water of 30 C and a Refer to the user s manual for container l _ the usage and quantity of the 2 Add the powder while stirring to fully whitener dissolve it The powder is more prone to pollute the For powder whitener please laundries than the detergent Therefore dissolve it before using please use it with proper quantity Dosage of different washing powder is different Please refer to the instruction of the washing powder for the detail dosage Washing sequence Wash timer Intensity selection Drain switch Spin timer If to set less than 2 min Intensity can be Normal Do not set drain switch CIf to set less than 1 min in you should first surpass 6 min Intense iA Jeans on Drain position durin rder to ensurelong Service life p 9 please first surpass 2 min and and then turn back a
5. Twin tub Washing Machine User s manual This manual is for XPB135 LA e Please read this manual Retain it for future reference Haier carefully before using Contents Foe of the parts EAE RR YarlastarvorterYai arta fartartortariorvartntardacte e b Safety precautions E E E EE EA 2 Installation and adjustment s s sssssss 4 Preparation before washing lt s sss 6 The musts in washing Pui hg a Bin cae gas antenna a aia 7 J Usage of the detergent AAEE E TE Iana aa Ea A a E E a 7 Washing SEQUENCE s treet ete 8 e Disposal after washing eae Sew pe apace pe ape age oe Se 12 Trouble Shooting Answers to question 14 Packing list Specification ttt 16 NS J Names of the parts Drain switch Outer cover of the spin tub Wash selecto Inner cover of the spin tub Wash timer Spin timer Water filling entrance water filling translatio Control pane Bypass channe Spin tub frame Spin tub Cabinet Water level adjusting leve Overflow filter Lint filter Drain hose Pulsator Cabinet handle Wash tub Base frame Notes All illustrations in this Manual are given for reference only Your products and accessories may show differences from these illustrations due to our continuous improvement Meaning and description of the symbols Contents marked with that symbol are related to the safety of the product and the personal safety of the users Please
6. astic fixing claw and pull it to the direction of the arrow to take it off 12 Cleaning the overflow filter Take off the corrugation pipe Dismantle the upper part of the corrugation pipe inside the overflow filter as indicated in Corrugation Figure 1 i Water level adjusting lever Cleaning the overflow filter Clean the lint around the filter and flush with tap water Install the overflow filter 1 Install the corrugation pipe 2 Insert the mounting plate at the bottom of the filter into the valve cover 3 Hang up the hook at the left upper side 4 Push the upper part in as Figure 2 indicated in Figure 2 Disposal of the complete unit e After washing dismount the water inlet Wipe the complete unit with soft hose cloth twisted dry e Do not store water in the tub for long Wipe with neutral detergent if too dirty ee a he water immediately Do not wash it directly by water Pull off the power plug and hang up the power cord Hang up the drain hose Wipe off the water drops on the surface and inside the tub with clean soft cloth Open the cover of the wash tub and the inner outer cover of the spin tub for some time about one hour then close them 13 Trouble shooting Answers to question If the laundries fall to the outer side of the spin tub If the laundries fall to the outer side of the spin tub Please come to the special maintenance department or customer car
7. ause the work if you open the outer cover of the spin tub Close it to resume the spinning To do spinning and draining or rinsing with water filling H together please first do spinning for around 1 minute lt i then do draining or rinsing with water filling Otherwise the spinning will stop owing to too much water stored in the spin tub 11 Disposal after washing After using please clean the lint and foreign materials of the lint filter and overflow filter in time Otherwise it may influence your using the machine Please first pull off the power plug from the receptacle before cleaning Cleaning the lint filter The lint filter must be used during washing It must be cleaned in time after each using 1 Press the elastic piece at upper end of lint filter to release the tab from the filter cover and pull the lint filter outward to remove it See Figure 1 Figure 1 2 Remove lint Pull the lower end of lint filter rear cover outward to disassemble it from the lint filter front cover Lint filter rear cover Remove lint completely with clear water See a gt Figure 2 Disassemble a 3 Install lint filter Lint filter frontcover Figure 2 Cleaning the overflow filter Too much lint on the overflow filter will influence the normal usage of the machine Please clean it every two months 1 Take off the overflow filter As indicated in the figure nip the el
8. e depa rtment of our company Do not repair it by yourself When the remained water is frozen Prevent the freezing be sure to discharge the water completely after using After complete draining set the DRAIN SELECTOR at OFF If it is set at DRAIN it will be rather difficult for the frozen water to melt When the water is frozen Pour hot water below 50 C into the wash tub to soak it completely Then turn the pulsator with hands gently Please confirm the drainage can work normally before next using 14 Trouble shooting Answer to question If there s breakdown please pull off the power plug before checking The following phenomena are not breakdowns sometimes Please confirm again before sending it to repair If there are real breakdowns please come to the special maintenance department or after sale service department of our company Do not repair it by yourself Phenomena The reason Is there power failure The machine does Is the power plug loose not act Is the pulsator twisted by foreign materials Is the drain hose put down The draining does Is the drain hose frozen not work Is the drain hose blocked by foreign material Are there laundries falling to the outer side of the spin tub There s abnormal sound during washing Are there hair pin coins or metal items brought inside the tub There s abnormal e Is the machine slanting sound and violent Is the gland pre
9. f the manual It is very important to your security and correct operating the machine Install the lint filter Put the underside of the lint filter into overflow filter p Overflow filter then push the upside into overflow filter qu A e After installation please refer that the lint filter installed to the right station otherwise the lint filter may be falled off when washing influencing your use 1 The height of the drain hose shall be less than 10cm or the drainage will not be smooth enough and cause incomplete drainage 2 Do not tramp or press the drain hose To make smooth drainage cut the front end of the hose slantingly AA OC Q ZZ 4 lf extra drain hose is needed please make separate purchase The inner diameter of the extra hose shall not less than 40mm and the length shall not exceed 1 5m If the extra hose is too long cut it either at point AorB How to change the direction of the drain hoses e Figure 1 indicates the ex factory installation position of the drain hose Figure 1 Extend the drain hose from the side of spin tub e Put soft items on the ground Lean the machine down gently with the front surface facing the ground Take off the drain hose from the cabinet Take the hose out of the fixing groove See to Figure 2 e Embed the drain hose into the groove Soft item along the side of the spin tub in
10. oof laundries like the raincoat bike covers etc to avoid ventilation hole with carpet abnormal vibrations in spinning E Ventilation hole at the bottom of the washing machine 9 Do not let the machine share one receptacle with other electric appliances If the power plug is damaged or the plugging into the receptacle is loose do not use the plug any more 9 9 Safety precautions Do not stretch hands into the working machine It is dangerous even if the rotation is slow Take special care of the children Do not decompose repair or alter the machine by Do not put any hot or heavy items such as the kettle with hot water on the washing machine Do not wash laundries with volatile materials such as thinner petrol etc Handicapped or children without care shall not use the machine To protect your laundries and wash ing machine please take out all of the coins buttons sand hairpin and other foreign materials before washing Keep the machine away from direct sunlight and heat source like the heater Please check if the water faucet is open and if the connection of the water inlet pipe is proper e Itis suggested to use foamless washing powder Installation and adjustment Please install and adjust the machine according to the requirement o
11. ssed evenly vibration during e Are there laundries falling to the outer side of spinning the spin tub e Are the laundries in spin tub too much There may be some waterflowing out of e It is the water remained in the factory inspection the drain hose in the of performance first use of the P machine 15 Packing list Name Quantity User s manual One piece KR a Q Water inlet hose ent One piece om Gland One piece Twin tub washing machine One set Ne Specification Water level Water quantity about L Maximum 99 Medium 79 Minimum 59 Rated washing capacity kg 13 5 Rated spinning capacity kg 7 0 Injection pressure MPa 0 02 0 2 16
12. tons of the laundries may sand hairpins close zippers etc Lx and loosen the laundries before putting them in the tub 2 cause noise For the sake of discretion please put the laundries with buttons into other laundries X Check if the laundries are applicable for washing with machine Divide the laundries that are not colorfast from other laundries Put those laundries difficult to absorb water into water with hand For those laundries with heavy soil please first remove the dirt like mud or dust For the parts with heavy soil please apply detergent on them in advance which can make it easier to remove the soil For those laundries that may get lint ball and those with long fur tum it over before putting in Do not put those laundries polluted by chemicals into the washing machine directly The musts in washing e The capacity of washing and spinning of the machine refer to the largest weight of the standard laundries under dry condition that can be washed or spinned in one time Laundries quantity in one washing cycle shall be lower than the rated capacity The thickness size type of the cloth will influ ence the actual washing capacity Itis suit able to put in reasonable amount of laundries and the laundries can be turned round in wash ing for one time washing e Do not select Maximum water level for few laundries so as to avoid splashing of water
13. ut from wash tub side due to too much inflow please turn down the water tap a bit 2 Close the spin tub outer cover and spin for about 1 2 min Rinsing Rinse with water filing 1 Put the laundries into the wash tub Select suitable current according to the laundries If you find water flo wing out here please 2 Adjust the water level twist the water tap to Set the water level with water level adjusting _ limit the water filling lever according to the laundries quantity v Then fill suitable water continuously 3 Rinse Adjust the wash timer to 5 7 minutes to do rinsing Repeat the midway spinning and rinsing with stored water for 2 3 times Rinse with stored water 1 Put the laundries into the wash tub Select suitable current according to the laundries 2 Fill water to preset water level 3 Rinse Adjust the wash timer to 2 3 minutes to do rinsing When the laundries quantity is few please use Soft current If you use Standard current it may splash 10 1 Put the laundries into the spin tub evenly and smoothly 2 Press the gland in the tub properly Close the inner and outer cover of the spin tub 3 Spin Select suitable spin time according to the laundries and do spinning eDuring spinning if there s abnormal sound it is generally owing to slanting placement of the laundries Please stop the machine and re order the laundries In spinning it will p
Download Pdf Manuals
Related Search