Greenway Home Products MES31CR User's Manual
Contents
1. Musk ka seme DE PHOENIX serus ELECTRIC STOVE POELE LECTRIQUE ESTUFA EL CTRICA Model Mod le Modelo USE amp CARE GUIDE Si MES31MB GUIDE D UTILISATION ET D ENTRETIEN we MES31CR MANUAL D USO Y CUIDADO MES31BL Thank you for purchasing a Muskoka Electric Stove IMPORTANT INSTRUCTIONS When using electrical appliances basic precautions should always be followed to reduce the risk of fire electric shock and injury to persons including the following 1 2 a N o 10 12 13 14 15 16 17 18 19 Read all instructions before using this appliance This stove is hot when in use To avoid burns do not let bare skin touch hot surfaces e penn use handles when moving this appliance Keep combustible materials such as furniture pillows bedding papers clothes and curtains at least 3 feet 914 mm from the front of this appliance Caution Extreme caution is necessary when any heater is used by or near children or disabled persons and whenever the heater is left operating unattended Always unplug this appliance when not in use Do not operate any heater with a damaged cord or plug or after the appliance malfunctions has been dropped or damaged in any manner Any repairs to this appliance should be carried out by a qualified service person Under no circumstances should this appliance be modified Parts having to be removed for servicing must be replaced prior to o2. NLY TYPE B 10 E 12 socket base light bulbs Turn off the power to the unit Let the stove cool if it has been operating Turn the stove so you are facing the back of the stove Look for the access plate with the gold printing on it Remove the two 2 screws holding the bulb slides These slides allow you to pull each bulb to the access panel opening making it easier to change the light bulb Oo UBWDN Remove the four 4 screws holding the access plate in position Once you have removed the four 4 screws remove the access plate You can now see and access the two 2 25 watt chandelier bulbs under the ember bed 7 Pull the bulb slides towards you until you can easily reach the bulbs 8 Remove each light bulb by unscrewing them out of the bases turning them towards you You can use one hand to hold the light socket in place if required 9 Install the new light bulbs by turning each light bulb into the base away from you You can use one hand to hold the light socket in place if required 10 Push the bulb slides back into position 11 Replace the access plate by pushing the plate up against the stove back and inserting the four 4 screws 12 Insert and tighten the 2 screws holding the bulb slides in place 13 Turn the stove back so you are facing the front of the stove 14 Turn the power on and enjoy the flame effect OPERATING INSTRUCTIONS After reading these instructions confirm that all contro
3. e a bed where openings may become blocked This oo has hot and arching or sparking parts inside Do not use it in areas where enn paint or flammable liquids are used or stored This appliance should not be used as a drying rack for clothing nor should Christmas stockings or decorations be hung on or near it Use this appliance only as described in this manual Any other use not recommended by the manufacturer may cause fire electric shock or injury to persons METAL SCREW Avoid the use of an extension cord because the extension anvan DD cord may overheat and cause a risk of fire However if you GROUNDED have to use an extension cord the cord shall be 14 AWG N 11 OUTLET Box minimum size and rated not less that 2025 watts The GROUNDING PIN extension cord must be a three wire cord with grounding ap type plug and cord connector The extension cord shall not GROUNDING ADAPTOR NGROUNDING LUG be more than 20 feet 6m in length FIG 1 SAVE THESE INSTRUCTIONS SPECIFICATIONS p 20 5 x 13 5 x 25 Dimensions W x D x H BS ani 35 cinsi bd em Net Weight 38 lbs 17 kg Gross Weight 47 bs 21 kg ELECTRICAL CONNECTION A 15 Amp 120 Volt 60 Hz circuit with a properly grounded outlet is required to operate this appliance Preferably the stove will be on a dedicated circuit as other appliances on the same circuit may cause the circuit breaker to trip or the fuse to blow when the heater is in operation The unit co
4. ls on the stove are in the off position Plug the stove into a 15 amp 120 volt outlet All controls and switches are on the front panel of the stove located inside the right hand door Flame to enjoy the flame just press the power switch to the on position Flame Brightness control you can adjust the intensity of the flame by moving the dial from the minimum position to the maximum position Select the brightness that you prefer This feature will only work if the power switch is in the on position MIN Heat 700 to obtain low heat just press the heat switch marked 700 to the on position MAX Heat 1400 to obtain high heat you must ensure the thermostat dial is in the maximum position and then press the 700w and the 1400w switches to the on position If you move the thermostat to the minimum position this High Heat Switch will be automatically shut off CLEANING YOUR STOVE Before you clean your stove please ensure the unit has been turned off unplugged from the power source and the unit has cooled To clean the doors Remove dust with a clean dry soft cloth that will not scratch the surface of the door Remove finger prints or other oily marks with a clean damp soft cloth To clean metal and other painted parts Remove any marks on any of these surfaces with a clean damp soft cloth that will not scratch these surfaces DO NOT USE abrasive cleansers or spray liquids on any surface of this st
5. mes standard with a 4 5 ft 1 5 m long 3 wire cord exiting out the back of the stove Plan the installation to avoid the use of an extension cord If an extension cord must be used it must be a minimum 14 ga 3 wire with grounding type plug and connector and rated not less than 2025 watts The extension cord shall not be more than 20 ft 6 m in length A WARNING Electrical outlet wiring must comply with local building codes and other applicable regulations to reduce the risk of fire electrical shock and injury to persons A WARNING Do not use this stove if any part of it has been under water Immediately call a qualified service technician to inspect the stove and replace any part of the electrical system which has been under water SERVICE INSTRUCTIONS FOR YOUR SAFETY Service must be performed by a qualified service agency REPLACING THE LIGHT BULBS NOTE Light bulbs become loose during shipment If the flame effect is dim or does not work poun check that the light bulbs are lightly secured into their sockets See instructions for replacing the bulbs The MES31CR MES31MB and the MES31BL use two 2 clear 120 Volt 25 watt B 10 E 12 socket base light bulbs small base chandelier candle type bulbs The access plate is located on the back of the unit For convenience if one of the light bulbs burns out it may be easier to replace both of the light bulbs at the same time A CAUTION To reduce the risk of fire use 25 watt O
6. n to assume for it any other liability in connection with the stove manufactured by it The warranty is null and void if used in commercial or industrial applications Greenway Home Products
7. ove WARRANTY DO NOT RETURN THIS PRODUCT TO THE STORE Please contact Customer Service at 1 866 253 0447 web www greenwayhp com email support greenwayhp com Canada 400 Southgate Dr Guelph Ontario Canada N1G 4P5 USA 6507 Fairfield Dr Northwood Ohio USA 43619 Limited Warranty Definitions Greenway Home Products Greenway Manufacturer Electric Stove stove Stove manufactured by Greenway Home Products Purchaser Purchaser of the stove Distributor Facility authorized to sell Greenway Home Products Warranty Card Greenway Home Products Limited Warranty Registration Card identifying the Purchaser and product model Greenway Limited Warranty Greenway warrants to the Purchaser that the stove is free from defects in material and workmanship under normal use and service for one 1 year 1 year limited parts from the date of purchase All warranty repairs must be pre authorized by Greenway Home Products Greenway will at its option replace or repair free of charge any defective part which the Purchaser shall notify their Distributor or Greenway Home Products within the warranty period The obligation of Greenway Home Products under this warranty is expressly limited to such replacement or repairs The provisions of this limited warranty shall not apply to the following 1 Accidents 2 Unauthorized repairs or alterations 3 Normal maintenance 4 Changes made to other units manufactured after thi
8. perating this appliance again Do not use outdoors This appliance is not intended for use in bathrooms laundry areas and similar indoor locations Never locate this appliance where it may fall into a bathtub or other water container Do not run cord under carpeting Do not cover cord with throw rugs runners or the like Arrange cord away from traffic areas and where it will not be tripped over To disconnect this appliance turn controls to the off position grip the plug then remove the plug from the outlet Never pull by the cord Connect to properly grounded outlets only This appliance when installed must be electrically grounded in accordance with local codes with the current CSA C22 1 Canadian Electric codes or for USA installations follow local codes and the National Electrical Code ANSI NFPA No 70 This heater is for use on 120 volts The cord has a plug as shown in FIG 1 An adapter is available for connecting three blade grounding type plugs to two slot receptacles The green grounding lug extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box The adapter should not be used if a three slot ound receptacle is available Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock fire or damage the appliance To pren possible fire do not block air intakes or exhaust in any manner Do not use on soft surtaces lik
9. s stove was manufactured 5 Incidental damages caused by failure of the stove such as inconvenience or loss of use 6 Improper installation The provisions of this limited warranty shall not apply to deterioration due to wear and exposure beyond the following limitations 1 For 180 days from the date of purchase on electrical component and circuit boards lightbulbs excluded Greenway Limited Warranty is void unless the following conditions are adhered to 1 Warranty registration must be completed and returned to Greenway Home Products 2 All warranty repairs must be preauthorized by Greenway repair facility 3 Greenway reserves the right to inspect defective parts that have been replaced under warranty Distributor is expected to hold defective parts for 60 days 4 Only parts and accessories and other material available through Greenway Home Products are to be used in the performance of warranty service 5 Purchasers are responsible for presenting notifying their Distributor as soon as a problem exists The warranty repairs should be completed in a reasonable amount of time from the date of authorization Not to exceed 30 days past notification This limited warranty is expressly in lieu of any other expressed or implied warranty including any implied warranty or merchantability or fitness for a particular purpose and of any obligations or liabilities on Greenway Home Products which neither assumes nor authorizes any other perso
Download Pdf Manuals
Related Search