Gemini Industries CDX-1200 User's Manual
Contents
1. SINGLE CD PLAYER CDX 1200 OPERATING INSTRUCTIONS INSTRUCCIONES DE OPERACION MODE D EMPLOI OPERATING INSTRUCTIONS FOR ENGLISH READERS PAGE 2 PAGE 5 FOR SPANISH READERS PAGE 6 PAGE 9 FOR FRENCH READERS PAGE 10 PAGE 13 FOR GERMAN READERS PAGE 14 PAGE 17 gemini CDX 1200 Q CDX 1200 Professional CD Player y PEN Y A NN 300 0 1 ae Y 24 ee a ONU J ace AH M U RELOOP RELOOP CD A al amp SEAMLESS LOOP Anti Shock N PLATI PAISE mar sey p ae Q 3 COMPACT QU LL c vO OT FORWARD BACK i gemini THIS APPARATUS SHOULD NOT BE EXPOSED TO DRIPPING OR SPLASHING AND NO OBJECTS CDX 1200 Professional CD Player LASER KLASSE 1 APPAREILA LASER DE CLASSE 1 LUOKAN 1 LASER LAITE KLASS 1 LASER APPARAT CLASS 1 LASER PRODUCT COMPILE 3 WITH DHHS RULES 2 CFR CHAPTER 1 SUBCHAPTER 3 FILLED WITH LIQUIDS SHOULD BE PLACED ON THE APPARATUS THIS DIGITAL APPARATUS DOES NOT EXCEED THE CLASS B LIMITS FOR RADIO NOISE EMISSIONS FROM DIGITAL APPARATUS SET OUT IN RADIO INTERFERENCE REGULATION OF CANADIAN DEPARTMENT OF COMMUNICATIONS POWER SUPPLY AC 115V 230V 240V 60 50Hz POWER CONSUMPTION 20WATTS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING SHOCK HAZARD DO NOT OPEN LINE OUT 1 R O1 u O MASTER RECORD UNE UNE LINE REAR PANEL OF MIXER PHO2. TIME ELAPSED indicates how much time has currently gone by since the play button was pressed TIME REMAING ON DISC will count down the time remaining on the entire disc and TIME REMAINING ON TRACK counts down the time that is left before the end of the track PITCH Pushing the PITCH button the button will light up blue activates the PITCH CONTROL SLIDE The pitch or speed of the CD will change plus or minus 12 depending on the position of the PITCH CONTROL SLIDER Push the PITCH button again to deactivate this mode PITCH CONTROL SLIDE Moving the PITCH CONTROL SLIDE up or down will lower or raise the pitch percentage or 12 PITCH BEND Pushing the PITCH BEND BUTTONS will automatically raise the pitch up to 16 or lower the pitch down to 16 from the existing pitch setting Releasing the buttons will return the pitch to the original pitch setting You can use this function to match the beat when mixing from one song to another LOOP SECTION A LOOP repeats the section between the entry point IN and the exit point OUT To set a loop while the unit is playing start by pressing the IN BUTTON it will light up and when you reach the desired end loop point press the OUT BUTTON it will also light up The loop will continue playing until you press the OUT BUTTON again allowing the music to continue from that point on to re engage the loop you must press the RELOOP BUTTON When you have released your loop the OUT BUTTON will turn OFF
3. and the IN BUTTON will remain lit to indicate that your loop is stored in the CDX 1200 memory Pressing the IN BUTTON again while the unit is playing will erase the previously saved loop while saving your new loop entry point Press OUT to exit the loop and save a new complete loop Press RELOOP to return to the beginning of the previously saved loop from normal play Press RELOOP repeatedly to cause the loop to stutter NOTE THE FIRST LOOP WILL HAVE A PAUSE AT THE EXIT POINT WHILE ALL OTHERS WILL BE SEAMLESS PLAY PAUSE Each press of the PLAY PAUSE BUTTON causes the operation to change from PLAY to PAUSE or from PAUSE back to PLAY The PLAY PAUSE BUTTON remains lit when in PLAY mode while it blinks in PAUSE mode CUE While the unit is playing and after the cue point has been programmed pressing CUE will cause the CD player to enter the PAUSE mode PLAY PAUSE BUTTON blinks at the programmed cue point the CUE LED is lit Holding down the CUE button changes the function to preview and allows you to stutter start or play from the programmed CUE POINT Releasing the CUE button will return the CD to the preset CUE point STOP BUTTON When pressed the STOP BUTTON stops the playback of the CD player CDX 1200 TRACK SELECTION The TRACK SELECTION buttons let you select the track to play 10 allows you to scan through the track selection in increments of 10 TRACK SKIP allows you to scan through each track one at a time NOTE O
4. MINI CUSTOMER SERVICE AT 1 732 346 0061 DO NOT ATTEMPT TO RETURN THIS EQUIPMENT TO YOUR DEALER 8 Do not use chemical solvents to clean the unit 9 Keep the laser pickup clean by keeping the tray closed 10 Keep this manual in a safe place for future reference CONNECTIONS VOLTAGE SELECTION SWITCH Before plugging the CDX 1200 into any wall outlet make sure that the VOLTAGE SELECTION SWITCH is set to the proper voltage To change this selection unscrew the hard plastic protective top with a Phillips head screw driver Then use a flat head screw driver to move the switch to the proper selection 115V or 230V Do not force or twist the switch Excessive force may cause damage if the switch does not move smoothly contact a qualified technician CDX 1200 CD Player This state of the art 2U professional CD player is backed by a 1 year warranty Prior to use we suggest that you carefully read all the instructions CDX 1200 POWER After you have properly set the VOLTAGE LINE SELECTOR SWITCH you may plug in the power cord of the CDX 1200 LINE OUTPUT JACKS Plug one end of the included RCA cable into LINE OUTPUT JACKS on the rear panel Plug the other end of the RCA connectors into any available line input jacks on your mixer If you are connecting the CDX 1200 through a reciever you can plug the RCA connectors into the CD or AUX INPUT JACKS on your reciever If there are no CD or AUX INPUTS use any line level n
5. NCE YOU HAVE SKIPPED TO ANOTHER TRACK YOU MAY NOT GO BACK TO YOUR PROGRAMMED CUE POINT YOU MUST BEGIN YOUR CUE SELECTION OVER AGAIN THE CUE WILL BE PRESET TO THE BEGINNING OF THE NEWLEY SE LECTED TRACK TROUBLESHOOTING If a disc will not play check to see if the disc was loaded correctly label side up Also check the disc for excessive dirt scratches etc If the disc turns but there is no sound check the cable connections if they are ok check your amplifier or reciever If the CD skips check the CD for dirt or scratches Do not assume that the CD player is defective Many cd s are recorded out of spec and will skip on most or all CD players Before sending the unit for repair try playing a CD that you are sure plays properly SPECIFICATIONS GENERAL AA E NEUEUEEEHNSURLOEN Compact Disc Player DISC Pe Standard Compact discs 12 cm amp 8 cm Time Display Track Elapsed Track Remain or Total remain Variable Pitch 12 Slider with Resume Switch Piteh Beh ee 16 Maximum fe ai STORE nme Within 0 03 seconds SO esate annie 19 each Dimensions Main unit 19 x 3 5 x 10 482 6 x 88 9 x 254 mm Weight Per Unit ss Main unit 11 35 lbs 5 14 kg AUDIO SECTION QUONTIZONION ansia 1 Bit Linear Channel 3 Beam Laser Oversampling Rate 8 Times Sampling PS QUEEN scales 44 1 kHz Frequency Response 20 Hz to 20 kHz Total Harmonic Distortion Less Than 0 05 Signal to Noe R
6. NO N N UNE PHONO LINE PHONO GND NOT INCLUDED INTRODUCTION Congratulations on purchasing the Gemini FEATURES Audio CD CD R CD RW compatible Anti shock using RAM buffer memory 2 Selectable Jog modes Pitch Bend Search Instant start amp cue with preview Single auto cue continuous play modes Seamless loop with reloop Pitch bend via jog wheel or buttons Three mode time selection Frame accurate search Large blue backlit LCD display Coaxial RCA digital output Rubber jog wheels with finger grips Variable pitch control with a 16 range SAFETY SPECIFICATIONS Laser Diode Properties Material Ga Al As Wavelength 755 815 nm 25 C Laser Output Continuous Wave max 0 5 mW PRECAUTIONS 1 Do not use this CD player at temperatures below 41 F 5 C or higher than 95 F 35 C 2 The apparatus should not be exposed to dripping or splashing and no objects filled with liquids such as vases should be placed on the apparatus 3 Place the unit in a clean and dry location 4 Do not place the unit in an unstable location 5 When disconnecting the power cord from the AC outlet always grasp it by the plug Never pull the power cord 6 To prevent electric shock do not remove the cover or the bottom screws 7 There are NO USER SERVICEABLE PARTS INSIDE Please refer to a qualified technician IN THE USA IF YOU EXPERIENCE PROBLEMS WITH THIS UNIT CALL GE
7. atio osorno 85 dB Dynamic RA 85 dB Channel Separata 85 dB 1 KHz A Levei a 2 0 0 2V R M S Power Suppl Mirra AC 115 230V 60 50 Hz SPECIFICATIONS AND DESIGN ARE SUBJECT TO CHANGE WITH OUT NOTICE FOR PURPOSE OF IMPROVEMENT
8. isplay bar and three diffirent time displays These times displays are TIME ELAPSED on the track TIME REMAIN ING on the disc and and TIME REMAINING on the track Time is measured in minutes seconds and frames PGM Allows you to create a set playlist To program a set list into the CDX 1200 memory begin by stopping the unit from play and pressing PGM to begin the set list Select a track by using the track selection button to scan to the first track to be placed in the set list When you have selected the proper track press PGM and the CDX 1200 will be ready to set your next selection Repeat the previ ous steps until you have completed your playlist then press play to begin the set list REPEAT Press the repeat button once to engage 1 or repeat the selected track Press REPEAT again to engage ALL setting wich will repeat all the tracks on the CD Press REPEAT again to disengage the repeat function FUNCTIONS CONTINUED SINGLE Pressing the SINGLE button engages SINGLE mode in this mode the CDX 1200 will play one song and then stop Pressing the SINGLE button again will then activate CONTINUOUS mode causing the unit to play continuously after the last track the unit will return to the first track of the disc and continue to play TIME The TIME BUTTON switches the time display between three available sources these three are TIME ELAPSED on the track TIME REMAINING on the disc and and TIME REMAINING on the track
9. ot phono inputs FUNCTIONS POWER Once you have connected all your cables and made sure that the VOLTAGE SELECTION SWITCH is set correctly you can turn the CDX 1200 on by pressing the POWER button pressing the CDX 1200 s POWER button a second time will turn off the unit DISC TRAY The DISC TRAY is where the CD is held during loading unloading and playback and holds both 12 cm and 8cm CD s DO NOT FORCE THE CD TRAY TO CLOSE EXCESSIVE FORCE WILL DAMAGE THE CD MECHANISM USE THE OPEN AND CLOSE BUT TONS EJECT BUTTON Pressing the EJECT BUTTON will open or close the DISC TRAY unless the CDX 1200 is in play mode then you must first stop the side you wich to eject JOG WHEEL In SEARCH MODE the JOG WHEEL can be used to search forward or bacwards in the music track as well as for fine adjustments to a CUE point in PAUSE mode In PITCH BEND mode the JOG WHEEL will function the same as the PITCH BEND allowing you to speed up FORWARD or slow down REWIND the music clock wise bieng FORWARD and counter clockwise being REWIND JOG MODE BUTTON When the JOG MODE BUTTON is illuminated it indicates the the JOG WHEEL is in SEARCH MODE and when not illuminated it indicates that the JOG WHEEL is in PITCH BEND MODE DISPLAY The DISPLAY shows the track number pitch value pitch bend single continue for continuous play play pause modes fast forward reverse modes loop mode reloop mode PGM repeat modes the playback d
Download Pdf Manuals
Related Search