GE SAM Specification Sheet
Contents
1. GE Lighting Solutions GUIDE FORM SPECIFICATIONS 201SA UNIT PACK GENERAL DESCRIPTION The complete luminaire designated identify shall be a GE 201SA unit pack ordering number specify SAM plus ordering number logic from catalog or approved equal to operate one specify 70 100 or 150 55V watt high pressure sodium HPS or 175 watt mercury specify clear or coated lamp from a nominal specify 120 or 240 volt 60 Hertz power source The luminaire shall include a completely prewired integral ballast hood wiring cable specify long 24 inch 610 mm none or short mounting bracket an optical assembly that shall provide an IES Distribution Type 5 pattern contact factory for Type 2 or 3 lamp two lag screws through bolt prewired photoelectric control receptacle and photoelectric control Units with the short mounting bracket shall be UL 1572 Listed Standard con struction is IP54 MECHANICAL CONSTRUCTION The ballast hood shall be of die cast aluminum with an integrally cast slipfitter and reversible clamp for mounting on 1 1 4 or 2 inch 42 or 60 mm OD diameter mounting arm All hardware shall be corrosion resistant BALLAST OPERATION The ignitor for use with HPS lamps and ballast shall be prewired to the lamp socket requiring connection of power supply leads to wiring cables only The luminaire shall contain a standard NPF Reactor or Lag type ballast in full compliance with lamp ballast specifications ava2. ilable to the fixture manufacturer from the lamp manufac turers at the time of fixture manufacture The ballast shall reliably start and operate the lamp in ambient temperatures down to 20 F for mercury or 40 F for HPS The luminaire and ballast shall be from the same manufacturer ROADWAY LIGHTING OPTICAL ASSEMBLY The optical assembly shall consist of a one piece aluminum reflector and specify open Type 5 acrylic latch type or open Type 2 3 or 5 acrylic screw type required for UL1572 Listing prismatic refractor Latches shall be stainless steel spring toggle type FOR MORE DEFINITIVE INFORMATION REFER TO BALLAST SPECIFICATIONS IN TECHNICAL DATA SECTION Guide Form Specifications 2011 GE Lighting Solutions e 1 888 MY GE LED e www gelightingsolutions com 1 888 69 43 533 GE Lighting Solutions is a subsidiary of the General Electric Company Evolve and other trademarks belong to GE Lighting Solutions The GE brand and logo are trademarks of the General Electric Company 2011 GE Lighting Solutions Information provided is subject to change without notice All values are design or typical values when measured under laboratory conditions
Download Pdf Manuals
Related Search