Garmin TR-1 Wireless Manual
Contents
1. Thank You Thank You for the purchase of your TR 1 Gold wireless remote Developed with the fisherman in mind the TR 1 wireless remote has been designed to give fishermen that competitve edge in fishing and unparalleled precision and control of their boat Nautamatic Marine Systems Inc is dedicated to create the finest controls and guidance systems for the best in boating and fishing Safety You are responsible for the safe and prudent operation of your vessel Your TR 1 Gold autopilot and wireless remote is a tool that will enhance your capability to operate your boat and catch fish It does not relieve you from the responsibility for safe operation of your vessel You must avoid hazards to navigation and never leave the helm unattended You must always be prepared to promptly regain manual control of your kicker The autopilot steering and throttle actuators can fail and hard over Learn to operate your autopilot on calm and hazard free waters Simultaneous operation of several radio controlled autopilots in near proximity may cause the autopilot to fail to respond to keypad button presses The near boat transmitter may jam your boat s receiver but will not control your autopilot or render the wired remote useless The Wireless remote will not respond as quickly to multiple button presses as the wired remote On occasion the wired remote will erroneously leave an indicator light on the throttle up down and idle resume indic2. Inc 1 800 588 7655 Inside the back cover of your keypad is written a 3 Character code This code is the security code that your receiver has been trained to respond to If you would like to keep this code tell the sales representative at the factory the code digits when you order your new keypad If you do not care about the code you will be sent a keypad with a randomly assigned code You can of course reprogram your receiver to recognize the new keypad when you take it to your boat Changing Batteries When the remote control system starts to respond erratically the key pad remote may need battery replacement The wireless remote keypad is powered by a CR 2032 Button Lithi um Cell Battery To access the battery for replacement gently pry apart the two halves of the keypad at the seam fingernails will do for this Once the unit is open remove the battery by sliding the battery out from beneath the retainer Replace with the same type of battery Caution The wireless remote keypad is not waterproof Do not expose the remote to rain or water spray Water in the remote will cause it to malfunction and possibly cause throttle runaway In the event the remote does get wet remove the battery from the remote immediately If the remote is subject to salt water incursion remove the battery and gently rinse the disassembled unit with clean alcohol and let it dry out before re assembly and reuse
3. neglect mishan dling misapplication faulty installation improper maintenance alteration set up adjustments inadequate signal pick up modification power surge commercial use of the product water damage or damage that is attributable to acts of God or service by anyone other than a NMSI factory service This warranty does not apply to any damage to the NMSI product that is the result of rust or corrosion This warranty does not cover any NMSI product that has been altered or modified so as to adversely affect its operation performance of durability or that has been altered or modified to change its intended use This warranty does not extend to repairs made necessary by normal wear or by the use of other parts or accessories which in the reasonable judgment of NMSJ are either incompatible with the NMSI product or adversely affect its operation Performance durability or that has been altered or modified to change its intended use NMSI obligation under this warranty is strictly and exclusively limited to the repair or replacement of defective parts and NMSI does not assume or authorize anyone to assume for them any other obligation NMSI reserves the right to change or improve the design of any NMSI product without assuming any obligation to modify any NMSI product previously manufactured Limits and Exclusions NMSI assumes no responsibility for incidental consequential or other damages including but not limited to expense for gas
4. Nautamatic Marine Systems Inc NMSI Limited Warranty Wireless Nautamatic Marine Systems Inc or TR 1 Autopilots collectively referred to as The Warrantor will repair this product with new or refurbished parts free of charge in the USA from the date of original purchase in the event of a defect in mate rial or workmanship as follows For one 1 Year Receiver cable assembly and Antenna only Wireless Keypad Transmitter has no warranty expressed or implied other than out of box failure You must report this out of box failure within seven 7 of purchase You will receive two 2 keypads at time of purchase One of them is considered your warranty replacement Batteries are not warranted For assistance in the USA or Canada in obtaining repairs contact Nautamatic Marine Systems Inc 3248 SE Ferry Slip Road South Beach OR 97366 Office 541 867 6751 Fax 541 867 6754 1 800 588 7655 If repair is needed during the warranty period the purchaser will be required to furnish a sales receipt proof of purchase indicating date of purchase The purchaser will be responsible for shipping the unit to the above address and will be responsible for all shipping costs to ship and return the repaired unit to the customer This warranty only covers failures due to defects in materials or workmanship which occur during normal use and does not cover damage which occurs in shipment or failures which are caused by accident misuse abuse
5. ators If this creates a problem for you we can load an updated software version on your ECU to eliminate the erroneous indicators There is a remote possibility that talking on a cellphone may interfere with and possibly jam the radio receiver Please use caution Note The wireless remote keypad is not waterproof Do not expose the remote to rain or water spray Water in the remote will cause it to malfunction and possibly cause throttle runaway In the event the remote does get wet remove the battery from the remote immediately If the remote is subject to salt water incursion remove the battery and gently rinse the disassembled unit with clean alcohol and let it dry out before re assembly and reuse 1 Wireless Kit Complete 120 2400 00 TR 1 AUTOPILOT WIRELESS REC 6 7 8 Wireless keypad transmitter Neck Lanyard 3 Antenna 240 2452 00 1 Antenna Base 340 245 1 00 1 4 40 x 3 8 Php Screw 310 0072 03 1 Co O Peor 1 Oval head Screw 10 0106 2 C e FE Php Sheet Meral Screw 310007213 2 6 a Oval Head Sheet Meal Sew 10oras 2 _ 2 Introduction Thank you for purchasing this accessory for your TR 1 Autopilot Please read and understand this manual before installing and operating this system The TR 1 wireless remote control is an add on system that provides the most often used functions of the standard TR 1 wired remote in a compact wireless form Note The wireless d
6. nt the receiver box Mount the unit away from possible electronic interferance such as the Electrohydraulic Unit Use the screws provided or use wire ties to mount 2 Mount the antenna using the screws provided See Installation Considerations above 3 Unplug the wired remote from the ECU wire 3 and plug in the wire coming from the receiver box unit See Fig 1 and Fig 2 4 Plug the wired handheld into the second wire stub from the receiver See Fig 3 Also see installation diagram on page 5 Installation Diagram Connect wire To Connection 3 At ECU Wireless J Receiver Antenna Electrohydraulic Connector Unit i CLIC Pele a MS T Handheld Wired Caution Keep Wireless Receiver away from Hydraulic Unit It may cause electronic interferance Security Codes Each keypad transmitter transmits its own unique identification code when a button is pressed The receiver computer must be programmed to recognize your transmitter Program the receiver transmitter pair by 1 Turn the TR 1 Autopilot on 2 Watch the LED on the receiver box when it starts blinking press any button on the wireless keypad until the LED stops blinking You will need to do this once anytime you change keypads Replacement Remote Keypads You may purchase replacements by calling Nautamatic Marine Systems
7. oes not replace your existing handheld You will still need your wired handheld to tune your autopilot or use the other functions of the autopilot Keypad push button functions The buttons on the wireless keypad correspond to buttons on the wired remote as indicated in the pictures below Up Arrow MOB Throttle Up Arrow Idle Resume Other TF 1 Autopilot en Left Straight Arrow f amp Right Straight Turn Button L gt Arrow lt Turn Button Wireless NAUTAMATIC aro sw Left Straight Tn ET Right Straight Down Arrow Arrow an Throttle Down Arrow Turn Button Turn Button GPSTRACK GLATIOD REV MOB MOB Idle Resume IDLE RES 2 Down Arrow OTHER 3 Throttle Down Arrow Installation Considerations When installing the wireless remote system 1 Mount the receiver box and antenna away from sources of electronic interference such as the autopilot hydraulic pump and the engines ignition systems 2 Mount the antenna in free space and in a direct line of sight to where the keypad transmitter is expected to be used Do not mount the antenna in a corner or behind a bulkhead that may reflect or absorb the radio signal from the remote Choose the locations for mounting the receiver and antenna such that the cable lengths allow for proper connections You may want to temporarily mount the components with tape or tie wraps and try out system operation before hard mounting any parts Installation 1 Mou
8. oline expense of transporting the NMSI product to an authorized dealer and expense of returning the NMSI product to the owner removal of the NMSI product from a boat and reinstallation mechanics travel time telephone trailering or tow ing charges rental of like product during the time warranty service is being performed travel lodging loss of or damage to person or property loss of revenue loss of use of the NMSI product loss of time or inconvenience Some states do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long an implied warranty lasts so the above exclusions or limitations may not apply to you This warranty gives you specific legal rights and you may also have other rights which vary from state to state n the event that a warranty claim is required outside the continental United States or Canada with the exception of Alaska or Hawaii there may be additional charges not covered under warranty based on local practices and conditions such as but not limited to freight insurance taxes license fees import duties any and all other financial charges including those levied by governments states territories and their respective agencies which will be the responsibility of the retail purchaser 8
Download Pdf Manuals
Related Search