Garmin TR-1 Quick Reference Guide
Contents
1. Steps 1 amp 2 Settings Press and hold the Select Degrees Per Step PG 10 Choices 1 2 3 4 5 10 15 30 45 or 90 Degrees 45 Degrees the blinked code on the up and F down arrows Example Steps Zig Zag Amplitude BB 10 Choices 5 to 50 degrees by 5 s 30 Degrees default is set at 45 degrees Zig Zag Period 9 20 Choices 1 to 20 minutes by 1 s so the down arrow will blink 8 times When you are at the Cloverleaf Length 500 ft to 1 000 ft by 50 ft increments 1 000 Ft highest setting the up arrow will Search Spacing 50 ft to 1 000 ft by 50 ft increments be solid When you are at the Orbits The Autopilot will orbit the waypoint you have activated in your GPS at the distance from lowest setting the down arrow which you activate and enter the mode on the handheld will be solid2. TR 1 Gold Owner s Handheld Quick Reference NAUTAMATIC Click to go from Standby to Autopilot mode GPSTRACK To autopilot in reverse 1 Start from Standby 2 Press and To engage GPS push and release GPS Track button SELECTLOAD hold the GPS REV button 3 Press and release the Auto Must plot a waypoint route or steer to cursor REY Stby button 4 Release the GPS REV button Increase throttle by pressing the Up Arrow button For Man Overboard Maneuver press and release the Decrease throttle by pressing the Down Arrow button MOB button Williamson Turn The electric throttle runs in parallel with the tiller throttle this means that you can t reduce the RPM with the electric throttle if the tiller throttle is set high Itis best to always Step Turns Circles and Remote Steer to port when run with the tiller throttle set to idle NOT in GPS Mode Orbit Clover Leaf and Search to Port Step Turns Circles and Remote Steer to Starboard when IN GPS Mode when NOT in GPS Mode Orbit Clover Leaf and Search to Starboard when Press and hold the SETUP Button to see IN GPS Mode what your buttons are set at Idle Resume Factory Default Zig Zags MOB A To change from Idle Resume to MOB you would Press and hold SETUP then press the MOB button ETIN twice you will see the light change from 2 to 1 OTHER 3 Note Boat Hydraulics too active but the boat holds course Try adjusting the Sea State Filter Th
3. is is adjustable at four levels 1 4 factory default is set at the most active 4 Press and release the Setup button press the 1 2 3 button once to light up code 1 decrease this function by pressing the down arrow button until the setting is most comfortable for your use If you wish to save this setting Press and Hold the Select Load button while pressing and releasing the deckmount On Off switch For further assistance please call technical support at 1 866 559 0229 A GARMIN 907 0002 00 TR 1 Gold Owner s Handheld Quick Reference How to use Pattern Steering How to Change the Values of the Parameters y 1 Press and release the Setup Button Press and Hold the P Button While holding the Setup but 2 Using the codes below Make selection of the ton down press select and light up the LED number to the correspond setup function you want to change by pressing ing pattern from the table below Release the Setup button To engage and releasing the buttons labeled 1 9 until the pattern steering press and release the corresponding button Idle Resume appropriate LED s are lit or Bent Arrow Buttons etc 3 Increase the value of the parameter one step by each MOB Step Turns BM press of the Up Arrow button Idle Resume 5 Circles 8 Cloverleaf LITE Decrease the value of the parameter one step by each press Other Zig Zags 6 Remote Steer 9 Search fare Daa Aone ikon To read out the value of the handheld See
Download Pdf Manuals
Related Search