Fujitsu 130 User's Manual
Contents
1. Installing the Pen Tablet in the Case Unzip the wraparound zipper and lay the HEC open flat as shown in Figure 1 HEC Screen wy Pen Holder Figure 3 Enclosed PenCentra Installing a Screen Protector 1 To ensure good adhesion clean the exterior surface of the HEC window with a soft cotton cloth dampened with denatured alcohol before installing the screen protector Wraparound Zipper Note Using denatured alcohol to clean the window may Figure 1 Empty PenCentra HEC result in streaking when it dries If streaking occurs gently buff the surface with a clean soft cloth PenCentra 130 and PenCentra 200 are trademarks of Fujitsu PC Corporation 2000 Fujitsu PC Corporation 7 00 58 0671 00C 2 For installation on the harsh environment case HEC remove the edge from the screen protector as shown in Figure 4 gt Figure 4 Removing Screen Protector Edge Strip 3 Peel the protective film from the adhesive side of screen protector as shown in Figure 5 Pa Figure 5 Removing Adhesive Backing 4 Apply the screen protector with the adhesive side down and the notch in the lower left corner as shown in Figure 6 Apply pressure along the edges of the screen protector with your finger Avoid lifting the screen protector from the display window after it is installed The adhesive requires 48 hours to cure completely e a i eae2. k Figure 6 Applying the Screen Protector 5 Remove the protective film from the top surface of the screen protector as shown in Figure 7 Figure 7 Peeling the Protective Film 6 Wipe the exposed surface of the screen protector with a clean dry cloth to remove any tacky residue left behind by the protective film If necessary clean the surface of the HEC window with a soft cotton cloth dampened with denatured alcohol to remove the residue Using the carrying strap and hand straps The carrying strap assembly can be attached to either end of the HEC depending upon your preference Attach the clips to either the left or right set of d rings One or both of the two elasticized handstraps can be used Slide your hand between one or both straps whichever is most comfortable and the HEC D rings one of four 19 V Handstraps Figure 8 HEC Handstrap Assembly 2of2 58 0671 00C
3. FMWCC36 FUJITSU Harsh Environment Case Position your PenCentra in the back of the case as User s Instructions shown in Figure 2 Zip up the wraparound zipper Verify that the Record Button extension is positioned PenCentra 130 and 200 directly over the Record Button Record Button Extension These instructions provide details on using the FMWCC36 harsh environment case HEC The HEC provides added protection for your PenCentra 130 or PenCentra 200 when it is being used transported or stored Note the following when using the harsh environment case e When charging the pen tablet in the HEC suspend the system to avoid overheating e To prevent scratches a screen protector should be installed on the display window of the HEC Two screen protectors are provided with the HEC Additional screen protectors can be obtained using order number FMWSP9 12 pack e If your PenCentra 130 or PenCentra 200 will be Figure 2 PenCentra in HEC used both with and without the HEC any screen protector on the pen tablet can be left in place Once the system is installed in the HEC you can either However if the pen tablet will be used only in store the pen in the system pen holder or it can be the HEC any screen protector on the pen tablet stored in the pen holder on the left of the HEC as should be removed for better viewing shown in Figure 3 e If you use a pen tether attach it to one of the D rings on the back of the case
Download Pdf Manuals
Related Search