Franke Consumer Products FF 5000 User's Manual
Contents
1. a S lt 2 FF 5000 SERIES Revolving mixer with separate handshower Installation guide ENGLISH C6 1398 XX G 13396 XX G RO239 XX G 28900 XX G R1190 Fa 51685 PARTS LIST G 1403 Flexible hose of the side spray G 1697 Priority water flow system G 1404 Flexible hose 6 1635 Fastening set rubber washer triangular flange metal washer nut allen key G R1190 5 Sim TECHNICAL FEATURES Maximum water flow 2 2 gpm 60 psi Recommended pressure range 15 75 psi Over 75 psi PRV required Complies with Proposition 65 NSF61 UPC and C UPC requirements Faucet installation ENGLISH Please remove all components from package and inspect prior to installation see itemized table and picture NOTE Call us immediately if you see inconsistencies 1 800 626 5771 or visit www frankeksd com TABLE OF CONTENT 2 3 Fastening set rubber washer metal washer nut 7 Fastening set rubber washer triangular flange metal washer nut allen key 2 5mm 8 Counter weight Remove all mounting hardware from protecting plastic bag Install faucet to the sink or countertop Set the faucet into place on the sink as indicated in the figure NOTE the rubber O ring should be sitting on top of the countertop and between the faucet body DO NOT use putty or other sealant at this location Install faucet to the sink or co2. cet handle by rotating it backwards so that it opens in the full cold position and open the cold supply for 15 seconds Clo se the cold supply Move the faucet handle to the off position Replacing the cartridge gt e to a L Allen key 2 5 mm _ G 28 mm wrench lt rna gt Q 00A ek PVO COG rE F Before starting shut off the water supply to the faucet and move the faucet handle to the off position Use a 2 5 mm Allen key to loosen the set screw A which is accessible from the back of the handle Lift the handle B from the cartridge F Find the small notch at the base of the chrome ring cap and carefully pry up against this to remove the cap C Remove the brass retaining ring E using a 28 mm wrench Lift out the cartridge F Ensure that the grommets O rings are in good condition and properly seated and remove all mineral deposits Install the new cartridge so that the central pivots fit into the corre sponding seats Cleaning of the aerator It is recommended that you periodically clean the aerator of your fau cet To do so unscrew the aerator holder from its own seat Simply using a toothbrush or something similar rub the filter under the wa ter removing the impurities and any build up Screw the areator back into place Cleaning of the side spray om Any deposits which may accumulate on the nozzle can be removed by simply running a finger over the rubber extrusions a
3. duct operational Franke at its op tion may repair or replace the product or components necessary to restore the product to good working condition Franke reserves the right to inspect the installation prior to the actual replacement of the product or component part This warranty does not cover misuse or abuse accidental damages scuffs or scratches improper instal lation abnormal usage negligence or damage caused by improper maintenance or cleaning Normal wear of parts is excluded from the warranty Damage caused by impurities or acts beyond our control are not covered Any product or part which has been repaired or altered in any manner outside of Fran ke s factory unless previously authorized in writing by Franke will void warranty Any replacement excludes transportation and any labor re installation costs This warranty does not allow recovery of incidental or consequential damages such as loss of use delay property damage or other consequential damage and Franke accepts no liability for such damages The Franke warranty is limited to the above conditions and to the warranty period specified herein and is exclusive Franke DISCLAIMS all other warranties expressed or implied including IMPLIED WAR RANTIES OF MERCHANTABILITY AND OR FITNESS FOR AS PARTICULAR PURPOSE This warranty gives you specific legal rights that may vary from state to state Further information For any further information about our products about the insta
4. llation of them or about the guarantee please dial the number of the customer service Phone number 1 215 822 6590 Or 1 800 626 5771 Fax number 1 215 822 5873 Franke Consumer Products Inc Kitchen Systems Division 3050 Campus Drive Suite 500 Hatfield PA 19440 11 ET 39388 R2
5. nd then run ning the water for a few seconds In extreme cases this step may have to be repeated General maintenance Clean aerator periodically Do not use harsh detergents solvents chemical agents metallic sponges etc that could harm the surface Clean only with a soft sponge and soapy water Clean and then dry properly the faucet in case of very hard or calcare ous water whose deposits cold damage the surface ENGLISH Limited lifetime warranty Franke Consumer Products Inc Kitchen Systems Division extends the following warranty to the origi nal purchaser of its faucets effective January 1 2003 All faucets installed in a private residence will carry a limited lifetime warranty on all mechanical parts to be free of manufacturing defects in material and workmanship under normal usage A chrome finishes carry a limited lifetime warranty all other finishes are warranted for five 5 years form the original date of purchase Marine and Outdoor Installation Franke Consumer Products Inc faucets are NOT warranted for Marine and Outdoor installations This warranty applies only to the original owner providing the product has been installed in accordance with our installation instructions used as recommended and in a normal residential application In the event of a warranty claim the owner will be required to provide proof of purchase save sales receipt This warranty covers all components which make the pro
6. untertop follows Install the fastening components to the faucet s threaded shank in the following sequence round gasket 1 triangular flange 2 metal washer 3 and threaded nut 4 the triangular flange can be omitted if the sink countertop is too thick Install the fastening items of the spray head holder in the following sequence the flat rubber washer 5 the metal washer 6 and the threaded nut 7 ENGLISH Assembly of side spray and connecting of the priority water flow system ORAS SOY RIN Proceed to the connection of the flexible hose of the side spray A and the priority water flow system B follow the phases indicated Interposing the holding gaskets within the connections as indicated in the figure Fix the lead counter weight to the flexible hose of the side spray at a distance of approx 40 cm from the connection to the outlet pipe Connect the supply lines ENGLISH G g J D Arrow BLU COLD water gt Leaver NANNINI RS IRRINRNINN SAN A KOs eA RA KN KS RNA RA 2 AI kK KR SAY EE Arrow RED HOT water Connect the hot and cold supply lines Do not allow the supply tubes to twist or bend sharply Leave the valves closed Move the faucet handle by rotating it onwards so that it opens in the full hot position and open the hot supply for 15 seconds Close the hot supply Move the fau
Download Pdf Manuals
Related Search