Fortinet ASM-S08 User's Manual
Contents
1. QuickStart Guide RATINET ACTIRDY Copyright 2007 Fortinet Incorporated All rights reserved PORT Products mentioned in this document are trademarks or registered trade marks of their respective holders Regulatory Compliance FCC Class A Part 15 CSA CUS 7 September 2007 ADM S08 01 30005 0413 20070907 FortiGate ASM S08 LED State Description Ejection latch open HS Flashing Ejection latch opened during system operation Installing the AMC Module It is important to carefully seat the FortiGate ASM S08 module all 5 Pull out the hot swap latch on the right hand side of the the way into the chassis Only then will the FortiGate ASM S08 module if pushed in MOOS PONEN ANE SAUR Coleen 6 Insert the module by applying moderate force to the front CAUTION The ambient room temperature of a FortiGate unit with ee NEANG Upper ede Ao SUAS ENE MOALE ewe the ASM S08 module installed must be no greater than 35 C 95 F The module should glide smoothly into the chassis If you 7 lata thi Au neci encounter any resistance while sliding the module in the P E E a pe module could be aligned incorrectly Pull the module back e A FortiGate chassis with an empty AMC single width SW Bur ane MSENGI AGAN opening 7 Press the hot swap latch firmly to lock in the module 8 Power on the FortiGate unit e To avoid any electrostatic discharge install in a static free area FortiGate ASM S08 modules are not hot swappable T2. he procedure for inserting the FortiGate ASM S08 module into a FortiGate chas sis slot requires the FortiGate unit to be powered off FortiGate ASM S08 modules must be protected from static dis charge and physical shock Only handle or work with FortiGate ASM S08 modules at a static free workstation To avoid any Removing the AMC module Should you need to remove the ASM S08 shut down the Forti Gate unit using proper shut down procedures To remove the ASM S08 module Ensure the FortiGate unit is powered off before proceeding electrostatic discharge ESD when handling FortiGate ASM S08 2 To avoid any electrostatic discharge ESD when handling modules install in a static free area FortiGate ASM S08 modules install in a static free area To insert a FortiGate ASM S08 module into a FortiGate chassis PUII the hot swap latch on the right hand side of the module to the extended position to unlock the module from the 1 Ensure the FortiGate unit is powered off before proceeding FOM Sa UNN 4 Gently pull the hot swap latch to remove the module 2 Remove the panel block on the FortiGate unit using the hot swap latch 3 Insert the FortiGate ASM S08 module into the empty slot in the chassis Ensure the Fortinet logo is right side up It should be on the upper right corner of the module 4 Carefully guide the module into the chassis
Download Pdf Manuals
Related Search