Fisher-Price TREEHOUSE 75972 User's Manual
Contents
1. e Make sure the area where the chalkboard label will be applied is clean and dry e Bend the chalkboard label in half lengthwise e Remove the backing from the upper half of the label e Align the bottom edge of the label with the bottom edge of the chalkboard outline on the ladder panel e Apply the top half of the label to the ladder panel and smooth the label downward e Remove the backing from the lower half of the label e Smooth the label downward J Front Trunk Panel Chalkboard Safe e Stand the front trunk panel upright e Position the ladder panel so that the chalkboard is toward the safe on the front trunk panel e Insert the hooked ladder panel tabs into the slots in the front trunk panel Front Trunk Ladder Panel Panel N Helpful Hint You may need the help of another person with this assembly step e Turn the assembly upside down so that the ladder panel rests on a flat surface e Lift the assembly up and pound the ladder panel onto the surface to lock the tabs on the ladder panel into the slots in the front trunk panel Assembly N e Position the assembly so that the ladder panel is laying on a flat surface Helpful Hint Push the front trunk panel back to allow for easier assembly e With the table top at an angle completely insert the tab on the table top into the slot above the supports on the ladder panel e Rotate the table top2. properties when installed at a sufficient uncompressed depth of at least 6 inches These materials include sand fine and coarse gravel fine and medium and shredded wood products wood mulch shredded bark wood chips Loose fills should not be installed over hard surfaces such as asphalt or concrete The depth of any loose fill material could be reduced during use resulting in different shock absorbing characteristics For this reason a depth greater than the minimum recommended should be considered Unitary materials are generally rubber mats or a combination of rubber like materials held in place by a binder that may be poured in place at the playground site and cures to form a unitary shock absorbing surface Maintenance Periodically check to be sure equipment has adequate protective surfacing under and around it Inspect surfacing material for deterioration Check loose surfacing material for foreign objects or debris Also look for compaction and reduced depth with special attention to heavy use areas such as those under swings and slide exit regions Message to Parents Thank you for purchasing the Fisher Price Backyard Treehouse The Backyard Treehouse should be assembled by an adult preferably by two adults Please read these instructions carefully and identify all parts before assembly Refer to the parts illustration on the next page for identification Questions We d like to hear from you Call Fisher Price C
3. Fisher Price Instructions Backyard Treehouse Model Number 75972 If you experience a problem with this product or are missing a part please call us at 1 800 432 KIDS rather than return this product to the store Please save these instructions for future reference Adult assembly is required No tools needed for assembly Weight Limit 300 Ibs The Fisher Price Backyard Treehouse is designed to easily attach to other Fisher Price outdoor playsets equipped with a connecting feature Do not attach other manufacturer s playsets to this Fisher Price product Ages 1 2 to 6 years A WARNING Falls onto hard surfaces could result in head or other serious injuries Never put on concrete asphalt wood packed earth or any other hard surface Carpet over hard floors may not prevent injury A CAUTION Please keep small parts and plastic bags out of children s reach Dispose of plastic bags properly Important Safety Information Do not climb on the Backyard Treehouse until it has been properly assembled by an adult e Only five children should use the Backyard Treehouse at one time e The total weight limit for the Backyard Treehouse is 300 Ibs e As with any climbing equipment adult supervision is essential to ensure that children play safely e Be sure children are dressed appropriately to avoid potential hazards while using the Backyard Treehouse Children should not
4. ard the treetop while pushing the treetop toward the wall panel until the treetop snaps into place Assembly J e Firmly push down on the roof to insert the long tab on the wall panel into the slot in the roof e Push and pull the back panel as shown to secure the e Firmly push down on the roof to snap the back panel into back panel in the roof the slot in the roof Check to be sure the roof is securely attached to the panel assembly Push up on the roof on all four sides If the roof can be removed from one of the panels re read and repeat steps a A S Receiv S e Fit the phone into the receiver on the wall panel e Firmly push down on the roof to insert the long tab on the ladder panel into the slot in the roof e Firmly push down on the roof to snap the tabs on the back panel into the slot in the roof Connecting Maintenance Helpful Hint There are two connecting areas to attach the ramp to the Backyard Treehouse You can connect the ramp to either of these areas and switch it whenever you like You can also attach other Fisher Price outdoor play sets to these two areas on the Backyard Treehouse If the Fisher Price outdoor playset is equipped with a slide or walkway use the instructions below to attach it to the Backyard Treehouse Ramp to Wall Panel LO o a Geert YA Yh UKA TAWA A HH le Panel P
5. ay 75996 that way for long They grow out of Grow With Me Slide things every day and into something 1h 6 yrs else But a backyard playset is one thing that needs to hold your child s interest for more than a season To make sure ours will be enjoyed for a long time we ve given them special features that make them toddler friendly as well as challenging for preschoolers And of course all of our playsets are built playground tough of double walled plastic so they ll survive years of outdoor adventures 72097 Grow With Me Picnic Table 2 yrs amp up Both the table top and seats adjust in height with your growing children Gn Grow With Me Teeter 1 2 6 yrs y t Combines gentle rocking for toddlers with teetering excitement for preschoolers 1996 Fisher Price Inc East Aurora New York 14052 B Two slides in one Adjusts from a toddler slope to a more challenging preschool angle 15 mos 6 yrs OF Wy Combines playhouse FR 75990 Grow With Me Playhouse Gym features with gym activities Slide adjusts from 18 for toddlers to 30 for preschoolers 75972 1 75972 0920
6. eg Groove Ramp Ne e Locate the connecting area on the wall panel e Insert the thin peg on the ramp into the slot in the wall panel e Firmly push down on the other ramp peg to fit it into the groove in the back panel va e Locate the connecting area on the ladder panel e Insert the thick peg on the ramp into the slot in the ladder panel e Firmly push down on the other ramp peg to fit it into the groove in the back panel e Inspect the Backyard Treehouse twice monthly during the usage season for wear or damage and tighten any screws as needed It is particularly important that this procedure be followed at the beginning of each usage season e To clean or to remove static electricity use a mild soap and water solution and a clean cloth Rinse clean with water to remove soap residue e Periodically check to be sure the Backyard Treehouse has adequate protective surfacing under and around it Inspect surfacing material for deterioration e Check loose surfacing material for foreign objects or debris Also look for compaction and reduced depth with special attention to heavy use areas such as those under swings and slide exit regions Three 3 Year Limited Warranty Fisher Price Inc 636 Girard Avenue East Aurora New York 14052 warrants to the original owner that the Backyard Treehouse is free from all defects in material and workmanship when used under normal conditions for a period of
7. elp of another person with this assembly step e Turn the panel assembly so that the wall panel is laying on a flat surface e Push down on the ladder panel as shown to snap the platform hooked tab into the slot in the ladder panel Left Roof Tabs Treetop A Slot Slot C Top of Tree J e Position the treetop on a flat surface with the slots facing up and the top toward you e Locate the left roof labeled L e Position the left roof so that the flatter side is toward you e Insert the left roof tabs into the slot in the treetop Assembly Front Trunk Panel e Position the right roof labeled R so that the flatter side is C toward you e Insert the right roof tabs into the slot in the treetop Helpful Hint You will need the help of another person with this assembly step e Lift the roof treetop assembly and lower it onto the panel assembly The treetop should be over the front trunk panel e Hold the roof treetop assembly in place e Grasp the ladder panel with one hand and the treetop with the other hand e Pull the ladder panel toward the treetop while pushing the treetop toward the ladder panel until the treetop snaps into place e Fit the hooked tab and the long tab on the left roof into the slot and groove in the right roof Wall Panel Ne J Grasp the wall panel with one hand and the treetop with the other hand e Pull the wall panel tow
8. ing up e Insert a shutter lower peg into the lower hinge hole on one side of the back panel e Fit and snap the shutter upper peg into the upper hinge hole on the same side of the back panel e Repeat this procedure to assemble the other shutter to the back panel Ladder Panel NT e Stand ihe assembly upright as shown e Insert the hooked tabs on the ladder panel into the slots in the back panel e To lock the ladder panel tabs into the back panel slots Climb onto the ladder panel and stomp down until it snaps into place This may require alot of force Back Panel Half Circle Cut out J1 fi Pean i o e Position the platform with the wood grain surface upright e Insert the long tab next to the half circle cut out in the platform into the slot in the ladder panel e Insert the two long tabs on the side of the platform into the slots in the back panel S Assembly e Insert and snap the hooked tabs and long tab on the platform into the panel assembl as shown Wall Panel Helpful Hint You may need the help of another person with this assembly step e Turn the panel assembly so that the ladder panel is laying on a flat surface e Push down on the wall panel as shown to snap the plat form hooked tab and long tab into the slots in the wall panel 5 Push Here Ladder Panel Ex J Helpful Hint You may need the h
9. onsumer Affairs toll free at 1 800 432 KIDS 8 AM 6 PM EST Monday through Friday Hearing impaired consumers using TTY TDD equipment please call 1 800 382 7470 Or write to Fisher Price Consumer Affairs 636 Girard Avenue East Aurora New York 14052 If you experience a problem with this product or are missing a part please call us at 1 800 432 KIDS rather than return this product to the store Left Roof Right Roof Tree Top Shutter 2 Not Shown Vinyl Label 2 Box of Chalk Ne e Please save all packaging material until assembly is complete to ensure that no parts are discarded e Before assembling the Backyard Treehouse please wipe each part with a clean dry cloth Assembly Safe Door Lower Peg Lower Hinge Hole Upper Hinge Hole X e Position the front trunk panel on a flat surface with the inside facing up Helpful Hint The safe door may be difficult to attach to the front trunk panel Place a cloth under the front trunk panel to protect the surface Apply a small amount of liquid soap to the pegs on the safe door e Position the safe door with the dial facing up Insert the safe door lower peg into the lower hinge hole in the front trunk panel e Firmly push down on the safe door to snap the upper peg into the upper hinge hole in the front trunk panel 2 2 Chalkboard Label Upper Half e Locate the ladder panel
10. three 3 years from the date of purchase This warranty does not cover color fading of the product or prod uct parts or damage from excessive abuse or Acts of God Should the product fail to perform properly we will repair or replace it free of charge Purchaser is responsible for ship ping the product to the address indicated above and for all associated freight and or insurance cost Fisher Price Inc will bear the cost of shipping the repaired or replaced item to you This warranty is void if the owner repairs or modifies the product This warranty excludes any liability other than the above mentioned including but not limited to any incidental or consequential damages SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES SO THE ABOVE LIMITATION OR EXCLU SION MAY NOT APPLY TO YOU THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH MAY VARY FROM STATE TO STATE If you have any questions about this product In Canada call 1 800 567 7724 or write to Mattel Fisher Price 6155 Freemont Blvd Mississauga Ontario L5R 3W2 In Great Britain telephone 01734 770488 In Australia call the Fisher Price Australian Consumer Advisory Service toll free at 1 800 800 812 or write to Fisher Price Mattel Pty Limited 461 Plummer Street Port Melbourne Victoria 3207 Fisher Price knows little kids become big kids E ooe knows little kids don t st
11. toward the supports _Ladder Panel Ne 2 e Check to be sure the table top is properly attached to the ladder panel There should be no gap between the table top and the ladder panel a Mailbox Label 2 I Mailbox Door e Make sure the area where the mailbox label will be applied is clean and dry e Bend the mailbox label in half and remove the backing e Apply the mailbox label to the mailbox door e For best adhesion try to avoid applying the label more than once Please Note The mailbox label may already be applied to the mailbox door e Position the wall panel on a flat surface with the outside facing up e Insert one of the mailbox door pegs into one of the hinge holes in the wall panel e Fit and snap the other mailbox door peg into the other hinge hole in the wall panel Telephone Receiver Front Trunk Panel e Position the assembly so that the front trunk panel is laying on a flat surface e Position the wall panel so that the telephone receiver faces the ladder panel e Insert the tabs on the wall panel into the slots in the front trunk panel e Push down firmly on the wall panel to snap the tabs in place Assembly Shutter Lower Peg Back Panel Lower aa ae Hole Upper Peg ICES ee a Label e Position the back panel on a flat surface with the warning label fac
12. wear loose clothing such as ponchos or scarves Attire should include well fitting shoes Do not climb on the Backyard Treehouse when it is wet e Do not use the Backyard Treehouse in a manner that is unintended e Do not attach other manufacturer s playsets to this Fisher Price product Placement and Play Area Surfacing Before assembling this product select and prepare a play area Select a Play Area Select an area on level ground at least 6 feet from any structure or obstruction such as a fence garage house overhanging branches washing lines or electrical lines Prepare a Surface Following are guidelines from the Consumer Product Safety Commission s Handbook for Public Playground Safety to mini mize injuries that can result from falls These guidelines apply to playground equipment including but not limited to swing sets and climbing equipment Hard surfacing materials are not suitable for use under this equipment Earth surfaces such as soils and hard packed dirt are also not recommended because their shock absorbing properties can vary depending on climatic conditions such as mois ture and temperature Grass and turf are not recommended because their effectiveness in absorbing shock during a fall can be reduced considerably due to wear and environmental conditions Acceptable surfacing materials are available in two basic types loose fill and unitary Loose fill materials can have acceptable shock absorbing
Download Pdf Manuals
Related Search