Fisher-Price T4144 User's Manual
Contents
1. NAN NIN IMPORTANT KEEP INSTRUCTIONS FOR FUTURE REFERENCE www fisher price co uk Consumer Information N WARNING To prevent serious injurv or death e Fall Hazard It is dangerous to use this product on an elevated surface since child s movement may cause the product to slide or tip over Use only on a floor e Suffocation Hazard Never use on a soft surface bed sofa cushion since the product can tip over and cause suffocation in soft surfaces e Always use restraint system e Never leave child unattended e Never use as a car seat e Not recommended for children who can sit up by themselves 6 months approximately until 9 kg 20lb e Never use toy bar as a handle e Never use as a carrier or lift while child is seated AN CAUTION This package contains small parts in its unassembled state Adult assembly is required e Please read these instructions before assembly and use of this product e Adult assembly is required Tool needed for assembly Phillips Screwdriver not included e Requires one D LR20 alkaline battery not included for soothing unit operation Requires two LR44 alkaline button cell batteries for toy operation e Product features and decorations may vary from photographs Great Britain Vanwall Business Park Maidenhead SL6 4UB Helpline 01628 500303 www service mattel com uk Australia Mattel Australia Pty Ltd 658 Church Street Locked Bag 870 Richmond2. e Place your child in the seat Position the restraint pad between your child s legs e Fasten the restraint belts to the restraint pad Make sure you hear a click on both sides e Check to be sure the restraint system is securely attached by pulling it away from your child The restraint system should remain attached Restraint System e Tighten each waist belt so that the restraint system is snug against your child Please refer to the next section for instructions to tighten the waist belts Setup and Use Anchored End Anchored End i Free End Free End 3 TIGHTEN LOOSEN To tighten the restraint belts e Feed the anchored end of the restraint belt up through the buckle to form a loop O Pull the free end of the restraint belt To loosen the restraint belts e Feed the free end of the restraint belt up through the buckle to form a loop Enlarge the loop by pulling on the end of the loop toward the buckle Pull the anchored end of the restraint belt to shorten the free end of the restraint belt Soothing Unit Power Switch S e Make sure your child is properly secured in the seat e Slide the power switch to Vibrations or Off IMPORTANT Low battery power causes this product to operate erratically no vibrations and the product may not turn off Remove and discard the battery and replace with a new D LR20 alkaline battery e Pull the ring on the toy for
3. Fit the lower pocket on the back of the pad onto the footrest Retainers loc Press the body support strap to the fastener on the back of the pad Soothing Unit J Hint You can move the body support up or down for your e Fit the retainers through the side openings in the pad baby s comfort e Fit the edges of the soothing unit through the large opening in the front of the pad Battery Installation Hint We recommend using an alkaline battery for longer battery life 1 5V D LR20 Protect the environment by not disposing of this product with household waste 2002 96 EC Check your local authority for recycling advice and facilities Europe only e Pull to remove the pad from around the retainers and the soothing unit e Remove the pad bottom pocket from the footrest C e Loosen the screw in the battery compartment door Remove the battery compartment door e Insert one D LR20 alkaline battery into the battery compartment e Replace the battery compartment door and tighten the screw e Pull and fit the pad seat bottom pocket around the soothing unit and footrest e If this product begins to operate erratically you may need to reset the electronics Slide the power switch off and then back on 6 Battery Safety Information In exceptional circumstances batteries may leak fluids that can cause a chemical burn injury or ruin your product To avoid battery leakage e Do not mix
4. old and new batteries or batteries of different types alkaline standard carbon zinc or rechargeable nickel cadmium e Insert batteries as indicated inside the battery compartment e Remove batteries during long periods of non use Alwavs remove exhausted batteries from the product Dispose of batteries safely Do not dispose of product in a fire The batteries inside mav explode or leak e Never short circuit the batterv terminals e Use only batteries of the same or equivalent type as recommended e Do not charge non rechargeable batteries e Remove rechargeable batteries from the product before charging e If removeable rechargeable batteries are used they are only to be charged under adult supervision Setup and Use AN WARNING To prevent serious injurv or death e Fall Hazard lt is dangerous to use this product on an elevated surface since child s movement mav cause the product to slide or tip over Use only on a floor e Suffocation Hazard Never use on a soft surface bed sofa cushion since the product can tip over and cause suffocation in soft surfaces e Always use restraint system e Never leave child unattended e Never use as a car seat e Not recommended for children who can sit up by themselves 6 months approximately until 9 kg 20lb e Never use toy bar as a handle e Never use as a carrier or lift while child is seated Restraint Pad 1 Restraint Belts Securing Your Infant
5. Victoria 3121 Australia Consumer Advisory Service 1300 135 312 New Zealand 16 18 William Pickering Drive Albany 1331 Auckland Asia Mattel East Asia Ltd Room 1106 South Tower World Finance Centre Harbour City Tsimshatsui HK China Malaysia Diimport amp Diedarkan Oleh Mattel SEA Ptd Ltd 993532 P Lot 13 5 13th Floor Menara Lien Hoe Persiaran Tropicana Golf Country Resort 47410 PJ Tel 4603 3341 9052 Mattel Europa B V Gondel 1 1186 MJ Amstelveen Nederland Fisher Price Inc a subsidiarv of Mattel Inc East Aurora NV 14052 U S A 2009 Mattel Inc All Rights Reserved and designate U S trademarks of Mattel Inc PRINTED IN CHINA T4144pr 0726 Parts IMPORTANT Please remove all parts from the package and identify them before assembly Some parts may be packed in the pad Retainer Seat Back Tube Retainer Body Support Footrest Left Base Wire Base Tube Right Base Wire M5 x 20 mm Screw 4 Note Screw shown actual size Tighten or loosen all screws with a Phillips screwdriver Do not over tighten the screws Assembly IMPORTANT Before assembly and each use inspect this product for damaged hardware loose joints missing parts or sharp edges DO NOT use if any parts are missing or broken Contact Fisher Price for replacement parts and instructions if needed Never substitute parts Left Base Wire 4 Uil Right Base Wire e Place the base
6. music and sounds Care e The pad and body support are machine washable Wash them separately in cold water on the gentle cycle Do not use bleach Tumble dry separately on low heat and remove promptiv e The frame toy bar and toys may be wiped clean using a mild cleaning solution and damp cloth Do not immerse the toy bar Do not use bleach Do not use harsh or abrasive cleaners Rinse clean with water to remove residue To remove the pad e Pull o the pad from around the retainers and the soothing unit e Remove the bottom pocket of the pad from the footrest Lift to remove the pad e To replace the pad refer to Assembly steps 7 and 8 Battery Removal e Before disposing of the toy bar please remove the batteries e Loosen the screws in the battery compartment door Remove and dispose of the batteries safely
7. tube on a flat surface e Position the left and right base wires as shown e Fit the left base wire and right base wire into the base tube e Position the feet with the non skid surface is down e Fit the feet on the base tube as shown Assembly Seat Back Tube e Fit the seat back tube onto the ends of the base wire e Push the seat back tube to be sure it is completely on the base wires Retainer Socket Up e Position the footrest so that the soothing unit is upright e Fit the footrest onto the ends of the base wires e Fit a retainer to the outside of the seat back tube as shown Make sure the socket in the retainer is upright e Insert a screw through the hole in the seat back tube base wire and into the inside of the retainer e Repeat this procedure to assemble the other retainer to the other side of the seat back tube e Pull the seat back tube up to be sure it is secure If you can remove either end of the seat back tube you have not assembled the retainers correctly Remove the screws re read and repeat 4 Assembly steps 5 and 6 Assembly Pad Lower Pocket Toy Bar Plugs tr A Sockets 10 e Insert and snap the toy bar plugs into each retainer socket Hint The toy bar is removable Press the ends of the latches and lift the toy bar 7 e Position the pad above the frame e Fit the upper pocket on the back of the pad onto the seat back tube e Lift the footrest
Download Pdf Manuals
Related Search