Home

Fisher-Price RAINFOREST M6711 User's Manual

image

Contents

1. Please Note After adjusting the belts to fit your child make sure you pull on them to be sure they are securely fastened Music Switch O 9 Power Switch e Place your child in the seat and secure properly Hint After turning on power this product may not swing unless there is a child in the seat e Slide the power switch to any of five speed settings e Give the seat a light push to start the swinging motion Adjust the power switch to the desired swing motion setting Hint As with most battery powered swings a heavier child will reduce the amount of swinging motion on all settings In most cases the low setting works best for a smaller child while the high setting works best for a larger child e If swinging stops while using a lower setting try a higher setting Give the seat a light push to start the swinging motion again e Slide the music switch to on with low volume on with high volume 4 or off O e Be sure to turn this product off when not in use Slide the power switch to the off setting O e Make sure your child is properly secured in the swing seat e Grasp both handles as shown and lift e Carefully carry the swing to another room Be sure to set the swing down on a non elevated flat surface e Lift the seat bottom e Press the frame release buttons on the inside of the frames and push the front legs inward
2. Pierric Z WARNING IMPORTANT KEEP INSTRUCTIONS FOR FUTURE REFERENCE www fisher price co uk Consumer Information WARNING To prevent serious injury from falls and being strangled in the restraint system e Always use the restraint system e Not recommended for children who can sit up by themselves 6 months approximately until 9 Kg 20 Ibs e Never leave child unattended e It is dangerous to use this product on an elevated surface e Never use toy bar as a handle CAUTION This package contains small parts in its unassembled state Adult assembly is required e Please read these instructions before assembly and use of this product e Adult assembly is required e Tool required for assembly Phillips screwdriver not included e Requires four C LR14 alkaline batteries for operation not included e Weight Limit 9 kg 20 Ibs IMPORTANT The maximum weight limit for this product is 9 kg 20 lbs If your child weighs less than 9 kg 20 Ibs but is really active and appears to be able to climb out of the swing immediately discontinue its use e Product features and decoration may vary from photo 2009 Mattel Inc All Rights Reserved and designate U S trademarks of Mattel Inc Fisher Price Inc a subsidiary of Mattel Inc East Aurora New York 14052 U S A GREAT BRITAIN Mattel UK Ltd Vanwall Business Park Maidenhead SL6 4UB Helpline 01628 500303 www service
3. Never substitute parts IMPORTANT Please remove all parts from the package and identify them before assembly Some parts may be packed in the pad Back Leg 2 Swing Frames Hint To allow the product to swing properly the swing arm to frame with power switch connection is designed to be loose lt 77 e Slide the front and back legs on the swing frame out until they click into place e Repeat this procedure to open the other swing frame Seat Pad Seat Frame Z 2 Base Tubes e While pressing the buttons on each front leg insert the front legs into the base tube 6 x 2 5 cm Screw 2 e Push the front 1e down into the base tube until the Shawn Actual Size buttons click into place Note Tighten or loosen all screws with a Phillips screwdriver Do not over tighten the screws e While standing on the base tube pull the front legs up The front legs should remain secured to the base tube If you can remove the front legs you have not assembled them correctly to the base tube Re read and repeat assembly Base Tube e While pressing the buttons on each back leg insert the back legs into the remaining base tube e Push the back legs down into the base tube until the buttons click into place e While standing on the base tube pull the back legs up The back legs should remain secured to the base tube If you can remove the back legs you have not assembled them correctly to the base tu
4. be Re read and repeat assembly step 4 e Position the seat frame so that the tubes are upright as shown e While gently pulling the seat hubs out fit them to the matching frame hubs Hint If the hubs do not fit together simply turn the seat frame around and try again Seat Hub e Insert a screw through the outside of each seat hub Tighten the screws Pad Upper Pocket Waist Belt e Fit the pad upper pocket over the seat back tube e From behind the assembly insert the waist belts through the slots in the pad Pad Lower Pocket Seat Bottom Tube e Fit the pad lower pocket onto the seat bottom tube e Insert and snap the peg on the toybar into the socket on the swing arm Pull the toy bar up to be sure it is secure e Fit the toy strings up through the slots in the toy bar leaf Assembly is now complete Battery Installation Hint We recommend using alkaline batteries for longer battery life 15V x 4 C LR14 Note Low battery power may cause product movement to slow and sound volume to become faint or turn off all together If this should happen please remove and discard all four batteries and replace with four new C LR14 alkaline batteries Battery Compartment Door e Locate the battery compartment door on the frame e Loosen the screws in the battery compartment door e Remove the battery compartment door e Insert four C LR14 alkaline batteries e Replace the batte
5. ho can sit up by themselves 6 months approximately until 9 Kg 20 Ibs e Never leave child unattended e It is dangerous to use this product on an elevated surface e Never use toy bar as a handle Buckle Restraint Pad e Place your child in the seat Position the restraint pad between your child s legs e Fasten both waist belts to the buckles on each side of the restraint pad Make sure you hear a click on both sides e Check to be sure the restraint system is securely attached by pulling it away from your child The restraint should remain attached e Tighten each waist belt so that the restraint system is snug against your child Please refer to the next section for instructions to tighten the waist belt IMPORTANT The maximum weight limit for this product is 9 kg 20 Ibs If your child weighs less han 9 kg 20 lbs but is really active and appears to be able to climb out of the swing immediately discontinue its use Anchored End Anchored End Free End To tighten the belts Feed the anchored end of the belt up through the buckle to form a loop Pull the free end of the belt Repeat this procedure to tighten the other belt To loosen the belts Feed the free end of the belt up through the buckle to form a loop Enlarge the loop by pulling on the end of the loop toward the buckle Pull the anchored end of the belt to shorten the free end of the belt Repeat this procedure to loosen the other belt
6. mattel com uk AUSTRALIA Mattel Australia Pty Ltd 658 Church Street Locked Bag 870 Richmond Victoria 3121 Australia Consumer Advisory Service 1300 135 312 NEW ZEALAND 16 18 William Pickering Drive Albany 1331 Auckland ASIA Mattel East Asia Ltd Room 1106 South Tower World FinanceCentre Harbour City Tsimshatsui HK China MALAYSIA Diimport amp Diedarkan Oleh Mattel SEA Ptd Ltd 993532 P Lot 13 5 13th Floor Menara Lien Hoe Persiaran Tropicana Golf Country Resort 47410 PJ Tel 03 78803817 Fax 03 78803867 Care The pad and toys are machine washable Wash them separately in cold water on the gentle cycle Do not use bleach Tumble dry separately on low heat and remove promptly The frame and toy bar can be wiped clean using a mild cleaning solution and a damp cloth Do not immerse this product To remove the pad e Lift the seat bottom tube and remove the pad lower pocket e Push the restraint belts back through the pad e Turn the product face down Unfasten the buckle and turn the product upright again e Slide the pad upper pocket off the seat back tube To re assemble the pad e Refer to assembly steps 8 and 9 PRINTED IN CHINA M6711b 0726 IMPORTANT Before assembly and each use inspect this product for damaged hardware loose joints missing parts or sharp edges DO NOT use if any parts are missing or bro ken Contact Mattel for replacement parts and instructions if needed
7. ry compartment door and tighten the screws If this product begins to operate erratically you may need to reset the electronics Slide the power switch off and then back on x e Protect the environment by not disposing of the product with household waste 2002 96 EC Check your local authority for recycling advice and facilities Europe only Battery Safety Information In exceptional circumstances batteries may leak fluids that can cause a chemical burn injury or ruin your product To avoid battery leakage e Do not mix old and new batteries or batteries of different types alkaline standard carbon zinc or rechargeable nickel cadmium e Insert batteries as indicated inside the battery compartment e Remove batteries during long periods of non use Always remove exhausted batteries from the product Dispose of batteries safely Do not dispose of this product in a fire The batteries inside may explode or leak e Never short circuit the battery terminals e Use only batteries of the same or equivalent type as recommended e Do not charge non rechargeable batteries e Remove rechargeable batteries from the product before charging e If removeable rechargeable batteries are used they are only to be charged under adult supervision Securing Your Child WARNING To prevent serious injury from falls and being strangled in the restraint system e Always use the restraint system e Not recommended for children w

Download Pdf Manuals

image

Related Search

Related Contents

UM10570 SSL4101DB02 4-channel high  TAC4 DG + RC - AERIA - La maîtrise de l`air  USER MANUAL - MARUSON Technology Spanish  T200 Terminal User's Manual - EBS Ink    Ice-O-Matic GEM0650A/W User's Manual  User's Manual  ®uto 6ti  

Copyright © All rights reserved.
Failed to retrieve file