Fisher-Price P4259 Instruction Sheet
Contents
1. Larger Baby e Insert the ends of the shoulder belts through the upper slots in e the pad and seat back ris 1 i eso n o Shoulder Belts aa Lower Slots Shoulder Belts e To adjust the restraint height for baby push to remove the shoulder belts from the seat back Smaller Baby e Insert the ends of the shoulder belts through the lower slots in the pad and seat back 15 Seat Adjustment PA 754 NX 2 Adjusting Seat Height Adjusting Seat Recline e Press the levers on both seat height adjusters and lift or lower the Hint Adjust the seat angle to any of three positions Upright seat to any of five different heights Semi Recline or Recline e Make sure both sides of the seat are adjusted to the same height e Lift the seat back latch and push the seat back forward or pull it e Push the seat bottom to be sure the seat is secure backwards to the desired position e Push the seat back to be sure it is latched in position 16 Using the Trays Hint Before use thoroughly wash all parts the trays that may contact food The snack tray is not dishwasher safe The snack and foot trays are not microwave safe Armrests Slide the snack tray onto the seat armrests Push the snack tray e Fit the food tray onto the seat armrests Push down until the tray until it snaps into place snaps into place 17 Using the Trays e While pulling the releas2. You may want to lower the seat to assemble the footrest e Fit the back base onto the bottom of both back legs as shown Refer to page 13 for instructions to lower the seat e Insert two M6 x 28mm screws into each back leg and tighten BACK VIEW M6 x 28mm d Screws M6 x 15mm Screws looo es T 40 8 si Qa 7 FS A Front Base a0 a aw F TC Front Legs Vv SB f J in 4 X SA A e Fit the front base onto the bottom of both front legs e Insert two M6 x 28mm screws into each front leg and tighten e Turn the assembly upright e While holding the footrest in place insert two M6 x 15mm screws into the holes on the back of the footrest and tighten Assembly REA LY gt a Fe XX D e At an angle fit the pegs on each side of the seat back into the holes in the sides of the seat bottom Hint You may need to flex the bottom edge of the seat back to fit the seat back pegs into the holes in the seat bottom e Lift the seat back latch and push the seat back forward Assembly M4 x 17mm Screws M4 x 17mm Screws e Insert two M4 x 17mm screws into the seat back and tighten e Fit a seat bracket to the side of the seat bottom as shown e Insert two M4 x 17 mm screws and tighten M4 x 17mm Screws e Fit the other seat bracket to the other side of the seat bottom as shown e Insert tw
3. EN Fisher Price l nae www fisher price com Consumer Information WARNING Prevent serious injury or death from falls or sliding out e The child should be secured in the high chair at all times by the restraint system CAUTION This package contains small parts in its unassembled state Adult assembly is required either in the reclining or upright position IMPORTANT Please keep these instructions for future reference The restraint belts must be adjusted to fit e Please read these instructions before assembly and use of your child snugly The tray is not designed this product to hold the child in the chair e Adult assembly is required Tool needed for assembly A Allen wrench included e It is recommended that only children Product features and decorations may vary from photographs capable of sitting upright unassisted use the high chair in the upright position e Always keep child in view while using the high chair e Never leave child unattended Parts lg Food Tray Footrest Snack Tray 2 Front Legs 2 Back Legs Seat Bottom with Crotch Belt 79 2 Seat Brackets Allen Wrench M4 x 17mm Screw 6 M6 x 28mm Screw 8 M5 x 60mm Screw 6 M6 x 15mm Screw 2 All Fasteners Shown Actual Size Tighten the screws with the enclosed Allen wrench Assembly IMPORTANT Before assembly and each use inspect this product for damaged hardware loose joints mis
4. e tabs on the sides of the food tray e To remove the snack tray pull the tabs on the sides of the snack adjust the tray forward or backward tray off the pegs e While pulling the release handles on the sides of the food tray e Slide the tray off of the armrests lift to remove it Storage Lever Back Legs e Push down on the levers on the back legs e Then push the back legs in towards the front legs 19 Care e The snack tray seat and restraint straps may be wiped clean using a mild cleaning solution and damp cloth Do not use bleach Do not use harsh or abrasive cleansers Rinse clean with water to remove residue e The food tray is dishwasher safe e Machine wash the seat pad in cold water with a mild detergent Do not use bleach Tumble dry on low heat and remove promptiv e To remove the pad Push to remove the shoulder belts waist belts and crotch belt from the seat and pads Unfasten the straps on the footrest e Remove the pad from the seat e To replace the pad and restraint straps refer to the assembly instructions in this manual IMPORTANT Be sure to replace the restraint system Never use this product without the restraint system CONSUMER ASSISTANCE Call toll free 1 800 432 5437 US amp Canada only M F 9AM to 7PM SAT 11AM to 5PM EST service fisher price com Write to us at Fisher Price Consumer Relations 636 Girard Avenue East Aurora New Vork 14052 Hearing impai
5. o M4 x 17 mm screws and tighten Seat Bracket Assembly e Unbuckle the lower restraint Assembly Slots Shoulder Belt Waist Belts Crotch Belt 19 e Pull the waist belt ends through the slots in the seat pad Hint The shoulder belts come assembled to the seat back in the Pull the crotch belt through the slot in the seat pad lower position for a smaller child To change to the upper slots for a larger child refer to page 12 e Place the seat pad onto the seat e Pull the shoulder belts ends through the slots in the seat pad 10 Assembly Elastic Loops BACK VIEW e Fit the elastic loops on the seat pad down through the slots in 22 the footrest e Fit the elastic loops on the seat pad bottom onto the pegs on the footrest Assembly Shoulder Belts e Fit the ends of the waist belts through the clips on the e Fit the upper pocket of the seat pad onto the seat back shoulder belts Securing Your Child WARNING Prevent serious injury or death from falls or sliding out e The child should be secured in the high chair at all times by the restraint system either in the reclining or upright position The restraint belts must be adjusted to fit your child snugly The tray is not designed to hold the child in the chair e It is recommended that only children capable of sitting upright unassisted use the high chair in the upright position e Always keep child in view while u
6. red consumers using TTV TDD equipment please call 1 800 382 7470 In Mexico 59 05 51 00 Ext 5206 or 01 800 46359 89 In Brazil 0800 550780 CANADA Mattel Canada Inc 6155 Freemont Blvd Mississauga Ontario L5R 3W2 Fisher Price Inc a subsidiary of Mattel Inc East Aurora New York 14052 U S A 2009 Mattel Inc All Rights Reserved and designate U S trademarks of Mattel Inc PRINTED IN CHINA P4259pr 0920
7. sing parts or sharp edges DO NOT use if any parts are missing or broken Contact Fisher Price for replacement parts and instructions if needed Never substitute parts Back Leg Seat Bottom Large Socket e Turn the seat bottom upside down on a flat surface e Position a back leg so that it curves up and fit it into a large socket in the seat bottom Hint If the leg does not seem to fit into the seat bottom socket try the other back leg M5 x 60mm Screw 2 UU e Insert an M5 x 60mm screw into the side of the seat bottom and tighten e Insert an M5 x 60mm screw into the side of the seat bottom e Push the back leg until it snaps in place and tighten e Push the back leg until it snaps in place Assembly Front Leg gt Front Leg e Position a front leg so that it curves up and fit it into the small e Fit the other front leg into the small socket in the seat bottom socket in the seat bottom Hint If the leg does not seem to fit into the seat bottom try the other front leg M5 x 60mm Screws Nike M5 x 60mm aan 6 ww e Insert two M5 x 60mm screws into the side of the seat bottom and tighten e Insert two M5 x 60mm screws into the other side of the seat bottom and tighten Assembly Back Base Back Legs M6 x 28mm Screws 11 e Fit the sockets on the footrest onto the posts on the front of the assembly e Slide the footrest up onto the posts Hint
8. sing the high chair e Never leave child unattended Waist Shoulder Waist Shoulder Belt e Place your child in the seat Position the crotch belt between your child s legs e Fasten both waist shoulder belts to each side of the crotch belt e Make sure you hear a click on both sides e Check to be sure the restraint system is securely attached by pulling it away from your child The restraint system should remain attached Securing Your Child Adjuster Adjuster TIGHTEN e Tighten each waist belt shoulder belt so that the restraint system is snug against your child Please refer to the next section for instructions to tighten the waist belts shoulder belts 3 LOOSEN e To tighten the waist belts Feed the anchored end of the waist belt up through the buckle to form a loop Pull the free end of the waist belt e To tighten the shoulder belts Hold the adjuster and pull the shoulder belt down e To loosen the waist belts Feed the free end of the waist belt up through the buckle to form a loop 0 Enlarge the loop by pulling on the end of the loop toward the buckle e Pull the anchored end of the waist belt to shorten the free end of the waist belt e To loosen the shoulder belts Lift the adjuster Note After adjusting the restraint system to fit your child make sure you pull on it to be sure it is securely fastened 14 Securing Your Child Shoulder Belts Upper Slots
Download Pdf Manuals
Related Search