Fisher-Price L7334 Instruction Sheet
Contents
1. it does not mean that the battery power in the remote is low Replace the batteries in the remote if the LED signal indicator on the remote is dim when the button is pressed If the LED signal indicator does not light after installing new batteries in the remote check the orientation of the batteries in the battery compartment to make sure they are properly installed Protect the environment by not disposing of this product with household waste 2002 96 EC Check your local authority for recycling advice and facilities Europe only Remote Battery Installation 1 5V x 2 AAA LR03 6 In exceptional circumstances batteries may leak fluids that can cause a chemical burn injury or ruin your product To avoid battery leakage Do not mix old and new batteries or batteries of different types alkaline standard carbon zinc or rechargeable nickel cadmium Insert batteries as indicated inside the battery compartment Remove batteries during long periods of non use Always remove exhausted batteries from the product Dispose of batteries safely Do not dispose of product in a fire The batteries inside may explode or leak Never short circuit the battery terminals Use only batteries of the same or equivalent type as recommended Do not charge non rechargeable batteries Remove rechargeable batteries from the product before charging If removable rechargeable batteries are used they are only to be charg2. fully secure the screws Tighten and loosen all screws with a Phillips screwdriver Do not over tighten 4 Locate the battery compartment on the back of the base Loosen the screws in the battery compartment door with a Phillips screwdriver Remove the battery compartment door Hint If the crib adaptor is attached to the base loosen the screws in the crib adaptor and remove it first Insert three D LR20 alkaline batteries as indicated inside the battery compartment Hint We recommend using alkaline batteries for longer battery life Replace the battery compartment door and tighten the screws IMPORTANT Under normal use conditions the batteries in the base will require replacement more often than the batteries in the remote When sounds or light become faint or movement of the mobile is sluggish it s time for an adult to replace the batteries in the base Base Battery Installation Battery Compartment 1 5V x 3 D LR20 5 Battery Compartment Locate the battery compartment on the back of the remote Loosen the screw in the battery compartment door with a Phillips screwdriver Remove the battery compartment door Insert two AAA LR03 alkaline batteries as indicated inside the battery compartment Hint We recommend using alkaline batteries for longer battery life Replace the battery compartment door and tighten the screw IMPORTANT If the mobile does not respond to the remote
3. Please keep this instruction sheet for future reference as it contains important information Requires three D LR20 alkaline batteries for the mobile and two AAA LR03 alkaline batteries for the remote batteries not included Adult assembly is required Tool required for assembly Phillips screwdriver not included www fisher price com L7334 2 WARNING Possible entanglement injury Keep out of baby s reach Remove mobile portion of product from crib or playpen when baby begins to push up on hands and knees This product will not attach to all crib designs Do not add additional strings or straps to attach to crib or playpen The mobile portion of a product may be used from birth until 5 months Base portion of product may be used from birth until 36 months A crib mobile is intended for visual stimulation and is not to be grasped by a child Always attach with all provided fasteners clamp tightly to a crib or playpen according to the instructions Check frequently Wipe this toy with a clean cloth dampened with a mild soap and water solution Do not immerse this toy This toy has no consumer serviceable parts Do not take this toy apart Consumer Information 3 Remote Crib Adapter Base Arm Parts 3 Soft Stars Mobile Hub 3 Soft Animals Clamp Note All of the screws used to assemble this toy are located in the product Follow these instructions carefully to
4. ed under adult supervision Battery Safety Information United States Only This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful inter ference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Consult the dealer or an experienced radio TV technician for help Note Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user s authority to operate the equipment FCC Statement Fisher Price Inc a subsidiary of Mattel Inc East Aurora NY 14052 U S A L7334pr 0920 2007 Mattel Inc All Rights Reserved and designate U S trademarks of Mattel Inc PRINTED IN CHINA 7 Assembly Crib Adaptor Fit the c
5. om of Base At least 7 inches Clamp 10 Use IMPORTANT In the unlikely event that use of the remote interferes with normal use of other remote controlled equipment such as televisions and stereos or use of other electric or battery powered appliances interfere with operation of the mobile do not use both appliances at the same time For best performance between the base and the remote avoid using the remote in areas of bright light In bright natural or artificial light you may notice loss of range Move the base or otherwise reduce the amount of light to improve performance When using the remote make sure that the arrow on the base s dome is pointing towards the transmitter window on the remote For best results make sure the path between the transmitter window on the remote and the dome on the base are in a direct line and free of obstacles Rotate the base dome so that the arrow points to the area from which you re most likely to use the remote For example if you ll most often be using the remote from the doorway of the nursery make sure that the arrow on the base dome is pointing towards the doorway and that the path between the base dome and the doorway is free from obstructions Base Dome 11 Classical Music Soothing Lullabies Lights and Motion Dome Lights Control Button Dome Lights Control Button Press to turn the soothing night light on or off Power Volume Switch Power Volume Switch Cho
6. ose from four settings off on with low volume on with medium volume or on with high volume Mode Select Switch Mode Select Switch Slide the switch to select one of three modes Music Select Buttons Music Select Buttons Choose classical music from Bach Mozart Beethoven or soothing lullabies Music motion and projected lights Music and motion Music only Press the button on the remote to activate music lights and motion Press again to stop Note The remote will remain active for about one hour After an hour you will need to slide the power volume switch on the mobile off then on again to reactivate 12 Convert to a Cribside Night Light Remove the mobile and use as a music box with a night light Loosen both screws in the arm near the base Lift and remove the arm from the base Close the small door on top of the base Store the mobile in a safe place for future use
7. rib adaptor to the base Tighten the four screws in the crib adaptor First press the button next to the socket and then slide the socket door open Fit the arm into the socket in the base Tighten both screws in the arm Base 2 1 Arm Base Socket PRESS PRESS SLIDE SLIDE PRESS SLIDE 8 Assembly Fit the mobile hub onto the end of the arm Tighten both screws in the arm to secure the mobile hub Mobile Hub 3 Soft Animal 4 Soft Star Attach Soft Animals Fit the string on a soft animal through the slot in the end of outer spoke larger Pull down gently on the soft animal to secure the string in the outer spoke Repeat this procedure to attach the remaining soft animals to the other two outer spokes Attach Soft Stars Fit the string on a soft star through the slot in the end of inner spoke smaller Pull down gently on the soft star to secure the string in the inner spoke Repeat this procedure to attach the remaining soft stars to the other two inner spokes 9 Crib Attachment Base Crib Top Rail Fit the base onto the crib top rail so that the threaded peg extends outside the crib Fit the clamp onto the threaded peg and turn the clamp clockwise to secure the base to the crib Do not over tighten the clamp If the distance between the toy and the mattress is less than 7 inches 18 cm lower the crib mattress Mattress Bott
Download Pdf Manuals
Related Search