Fisher-Price 75973 User's Manual
Contents
1. the front edge of the swing and lift the restraint bar Slide the restraint bar up e Squeeze tabs on the release buckles to unfasten the crotch belt from the waist belt Helpful Hint The restraint bar will remain in the up position for ease in placing a child in or out of the Lift amp Lock Swing Wash the Lift amp Lock Swing with a mild soap and water solution Rinse with clean water to remove soap residue Remove the Lift amp Lock Swing from your swing set or other location and store it indoors when the outdoor temperature drops below freezing Mattel Australia Pty Ltd 658 Church Street Locked Bag 870 Richmond Victoria 3121 Australia warrants to the original owner that the Lift amp Lock Swing is free from all defects in material and workmanship when used under normal conditions for a period of three 3 years from the date or purchase This warranty does not cover the swing ropes color fading of the product or product parts or damage from excessive weather abuse or acts of God Should the product fail to perform properly we will repair or replace it at our option free of charge Purchaser is responsible for shipping the product to Mattel Australia Pty Ltd at the address indicated above and for all associated freight and insurance cost Mattel Australia Pty Ltd will bear the cost of shipping the repaired or replaced item to you This warranty is void if the owner repairs or modifies the product This warranty2. Fisher Price Instructions Model Number 75973 Lift amp Lock Swing Please save these instructions for future reference No assembly is required For children 9 months 3 years and up to 20 kg 45lbs A WARNING e Falls onto hard surfaces could result in head or other serious injuries e Never place over concrete asphalt wood or other hard surfaces e Always use the restraint system e Never leave child unattended Do not allow use of the Lift amp Lock Swing until it has been properly installed by an adult according to these instructions Install the swing at least one meter three feet from any structure or obstruction such as a tree trunk fence garage house overhanging branches laundry lines or electrical lines Do not use the swing as an infant seat Place only one child at a time in the swing Adult supervision is essential to ensure that children play safely Make sure your child is dressed appropriately to avoid potential hazards while using the swing Your child should not wear loose clothing such as ponchos or scarves Attire should include well fitting shoes Place child in the center of the swing Make sure the restraint belt and the restraint bar are properly secured Review the following safety tips with your child before use Do not walk close to in front of or behind the swing while it is in use Do not twist or spin the swing Do not push the swin
3. excludes any liability other than that expressly stated above including but not limited to any incidental or consequential damages SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH MAY VARY FROM STATE TO STATE Australia Mattel Australia Pty Ltd 658 Church Street Locked Bag 870 Richmond Victoria 3121 Australia Consumer Advisory Service 1300 135 312 New Zealand 16 18 William Pickering Drive Albany 1331 Auckland Fisher Price Inc a subsidiary of Mattel Inc East Aurora NY 14052 U S A 2001 Mattel Inc All Rights Reserved and designate U S trademarks of Mattel Inc Printed in Australia 75973pr 0920
4. g when it is not occupied Do not stand in the swing Do not get out of the swing while it is in motion Before installing the Lift amp Lock Swing select and prepare a play area Placement Install the swing at least one meter three feet from any structure or obstruction such as a tree trunk fence garage house overhanging branches laundry lines or electrical lines Surfacing Following are guidelines from the U S Consumer Product Safety Commission s Handbook for Public Playground Safety to minimize injuries that can result from falls These guildelines apply to playground equipment including but not limited to swing sets and climbing equipment Hard surfacing materials are not suitable for use under this equipment Earth surfaces such as soils and hard packed dirt are also not recommended because their shock absorbing properties can vary depending on climatic conditions such as moisture and temperature Grass and turf are not recommended because their effectiveness in absorbing shock during a fall can be reduced considerably due to wear and environmental conditions Acceptable surfacing materials are available in two basic types loose fill and unitary Loose fill materials can have acceptable shock absorbing properties when installed at sufficient uncompressed depth of at least 15 cm 6 inches These materials include sand fine and coarse gravel fine and medium and shredded wood products wood mulc
5. h shredded bark wood chips Loose fills should not be installed over hard surfaces such as asphalt or concrete The depth of any loose fill material could be reduced during use resulting in different shock absorbing characteristics For this reason a depth greater than the minimum recommended should be considered Unitary materials are generally rubber mats or a combination of rubber like materials held in place by a binder that may be poured in place at the playground site and cures to form a unitary shock absorbing surface The Lift amp Lock Swing can be attached to a swing set pole or tree branch IMPORTANT When installing the Lift amp Lock Swing be sure it cannot swing to within one meter three feet of any other object in front of behind or to the side of it N CAUTION Periodically inspect S hooks for wear Metal to metal contact between hooks may cause premature wear If your swing set does not have a bushing you may want to replace the existing hook with a hook and bushing assembly available at toy stores and home centers Swing Set Installation not included 7 Bushing not included S Hook e Fasten the Lift amp Lock Swing S hooks included onto the hooks not included on your swing set Installation of the Lift amp Lock Swing Pole or Tree Branch Installation INPORTANT Before installing check the strength and stability of the pole or tree branch Place the Lif
6. t amp Lock Swing at least one meter three feet from a tree trunk or any other structure e Wrap the S hook end of the Lift amp Lock Swing ropes around the pole or tree branch e Hook the S hook around the ropes Pull down on the ropes to make sure the Lift amp Lock Swing is securely fastened TX Release E Lever Pull the release lever toward you and raise the restraint bar e Unbuckle the waist belts from the crotch belt e Place your child in the swing e Pull the crotch belt up between your child s legs and fasten both waist belts to the crotch belt Make sure you hear a snap on both ends e Insert the restraint bar down into the latch until it snaps into place Pull up on the restraint bar to be sure it is securely latched To tighten the waist belts e Feed the anchored end of the waist belt up through the buckle to form a loop Pull the free end of the waist belt e Repeat this procedure to tighten the other waist belt To loosen the waist belts e Feed the free end of the waist belt up through the buckle to form a loop Enlarge the loop by pulling on the end of the loop toward the buckle e Pull the anchored end of the waist belt to shorten the free end of the waist belt e Repeat this procedure to loosen the other waist belt Removing Your Child Release Lever e The release lever is located on the underside of the swing seat Squeeze the release lever toward
Download Pdf Manuals
Related Search