Fantech RE User's Manual
Contents
1. NOT APPLY b Visible Damages Save all cartons and file complaint directly with UPS 2 For product delivered via a common carrier File damaged goods claim directly with the freight company 3 Shortages Sign only for the total number of pieces received and call Fantech immediately a To damages from shipping either concealed or visible b To damages resulting from improper wiring or installation c To damages or failure caused by Acts ofGod or resulting from improper consumer procedures such as 1 improper maintenance FOR FACTORY RETURN 2 misuse abuse abnormal use or accident and PRODUCT S RETURNED WITHOUT AUTHORIZATION WILL NOT BE ACCEPTED 3 incorrect electricall voltage or current FANTECH WILL NOT ACCEPT THE RETURN OF ANY SPECIAL NON STOCK d To removal of or any alteration to the Fantech label control number or date OBSOLETE OR UNSALABLE PRODUCT S FANTECH MAY AT ITS OPTION of manufacture ACCEPT RETURN OF SALABLE PRODUCT S SUBJECT TO A 25 RESTOCKING CHARGE e To any other warranty expressed implied or written and to any consequential or 1 No product s will be accepted without a Return Materials Authorization RMA number incidental damages loss of propert revenues or profit or costs of removal This number can be obtained by calling Fantech Inc at 800 747 1762 Please have or reinstalltion for any breach of warranty have Bill of Sale or proof of date of installation available i 2 RMA must be clearly2. or other causes shall FANTECH be liable for special or consequential damages including but not limited to loss of profits or revenue loss of use of equipment or any other associated equipment cost of capital cost of substitute equipment facilities or services downtime costs or claims of customers of purchase for such damages FANTECH neither assumes or authorizes any person to assume for it any other liability in connection with the sale of product s or part s Some jurisdictions do not allow the exclusion or limitation of incidental or consequential damages so the above limitations and exclusions may not apply to you WARNING FANTECH INC products are designed and manufactured to provide reliable performance but they are not guaranteed to be 100 free from defects Even reliable products will experience occasional failures and this possibility should be recognized by the user If these products are used in a life support ventilation system where failure could result in loss or injury the user should provide adequate backup ventilation supplementary natural ventilation failure alarm system or acknowledge willingness to accept the risk of such loss or injury
3. readily accessible to people or animals WEAR HAND PROTECTION AND STAY CLEAR OF SHARP EDGES Screen guards must be installed when fan will be within reach of personnel within 7 feet of the working area or when advisable for safety Install intake side of fan facing an unoccupied space TYPICAL INSTALLATIONS a T R Z AS LA f ee Pitched roof with flat base siai ja 7 Flat roof for curb mount q i Wall mount Range hood venting oin y REC Roof Exhouster Bathroom venting Dimensions A RE C 6 RE C 8XL RE C 10XL A 13 07 15 75 19 76 B 6 50 6 00 11 75 P C 6 00 8 00 10 00 D 15 50 20 00 20 00 B E 15 50 20 00 20 00 Dimensions in inches K C gt NOTES j 1 Add 1 5 inches to B when using curb 2 Allunits provided with 7 8 knockout O 2 3 All units come with conduit and fittings o o D Q 2 S E Model REC for curb mounting SPECIFI STALLATION INSTRUCTIONS Suitable sealing such as tar or sit nilar material not included should be used to prevent leakage To prepare for installation determine the size and type of ducting if any to be used Make an opening in the roof just large endygh to accommodate dugting and electrical supply l Curb Mounting _ ectly on the deck b
4. RE41999R 1712 Northgate Blvd Sarasota FL 34234 INSTALLATION amp MAINTENANCE Phone 800 747 1762 Fax 800 487 9915 INSTRUCTIONS Phone 941 351 2947 Fax 941 359 3828 a Web Site www fantech us com Fantec SERIES Read and Save These Instructions DO NOT CONNECT POWER SUPPLY until fan is completely installed Make 4 sure electrical service to the fan is locked in OFF position All units are suitable for use with solid state speed control WARNING TO REDUCE THE RISK OF FIRE ELECTRIC SHOCK OR INJURY TO PERSONS OBSERVE THE FOLLOWING Use this unit only in the manner intended by the manufacturer If you 2 have any questions contact your manufacturers representative CAUTION Before installation servicing or cleaning unit switch power off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally When the service 3 disconnecting means cannot be locked securely fasten a prominent warningdevice such as a tag to the service panel Installation work and electrical wiring must be done by qualified person s in accordance with all applicable codes and standards including fire rated construction Sufficient air is needed for proper combustion and exhausting of gases through the flue chimney of fuel burning equipment to prevent back drafting Follow the heating equipment manufacturer s guideline and safety st
5. andards such as those published by the National Fire Association 5 NFPA and the American Society for Heating Refrigeration and Air Conditioning Engineers ASHRAB and the local code authorities When cutting or drilling into wall and ceiling do not damage electrical wiring and other hidden utilities Ducted fans must always be vented to the outdoors g If this unit is to be installed over a tub or shower it must be marked as 6 appropriate for the application and be connected to a GFCI Ground Fault Circuit Interrupter protected branch circuit NEVER place a switch where it can be reached from a tub or shower WARNING Check voltage at the fan to see if it corresponds to the motor 7 name plate INSTALLATION The compactness and adaptability of Models RE fans permit easy installation The fans are shipped fully assembled and can be mounted at any angle For various mounting see figures below Because this unit has rotating parts safety precautions should be exercised during phase of installation operation and maintenance CAUTION For General Ventilation Use Only Do Not Use To Exhaust Hazardous Or Explosive Material and Vapors Remove unit from package and inspect within 15 days after receipt If damaged report damage to carrier Do Not operate this unit with visible damage to the blower or impeller assembly CAUTION This unit has an unguarded impeller Do not use in locations
6. eneath 1 Outside dimensions of flanged curb should be r edge of base may be slid approximately 3 8 smaller than the outside di ion of base Flanged curbs are available Flat Base Mounting 1 Base may be mounted roof shingles or u underneath shingles 2 Securely screw or bolt base plate to roof throug four corner mounting points 3 Through the opening attach ductwork to fan inlet orifice by using Fantech FC clamps or duct tape 4 Refer to wiring diagram in this guide to complete electrical connections 5 Once secured and wired generously apply tar or other sealant around edges of the base to prevent leakage Be sure to replace any lifted shingles alant along the top edge of the curb 4 Place unit on curb and securely attach with bolts Or screws p Continue installation by following items 3 through g 5 in previous instructions for Flat Base For installations in which the fan is connected to a range hood or if an exhaust grille connected to the fans is located above or near the cooking surface as shown below be sure to observe the following safety warnings CAUTION CEILING WARNING TO REDUCE THE RISK OF FIRE USE ONLY METAL DUCTWORK COOKING AREA P Use only galvanized steel ductwork Use only galvanized steel ductwork in accordance with all applicable codes Note If the fan is not connected to a range hood or a grille in vicinity of the cooking surface other approved ducting
7. marked on outside of carton or delivery will be refused All product s must be returned freight prepaid WARRANTY VALIDATION F 3 r 3 Product s will be repaired replaced and shipped back to buyer no credit will be issued The end user must keep a copy of the Bill of Sale to verify purchase date Valid proof 4 Any out of warranty product will be evaluated and buyer will be notified of cost repair cost of the date of installation may also serve as a verification of commencement of will be charged to customer buyer will be responsible for return freight or product may be warranty period returned without action to the buyer freight collect No credit will be issued LIMITATION OF WARRANTY AND LIABILITY This warranty does not apply to any FANTECH product or part which has failed as a result of faulty installation or abuse incorrect electrical connections or alterations made by others or use under abnormal operating conditions or misapplication of the product or parts We will not approve for payment any repair not made by us or our authorized agent without prior written consent The foregoing shall constitute our sole and exclusive warranty and our sole exclusive liabiltiy and is in lieu of any other warranties whether written oral implied or statutory There are no warranties which extend beyond the description on the page hereof In no event whether as a result of breach of contract or warranty or alleged negligence defect incorrect advice
8. may be used P rfi pp g may EQUIPMENT WARNING WARNING TO REDUCE THE RISK OF A RANGE TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A TOP GREASE FIRE RANGE TOP GREASE FIRE OBSERVE THE FOLLOWING A Never leave surface units unattended A SMOTHER FLAMES with a close fitting lid cookie sheet or metal tray then turn at high settings Boilovers cause smoking off the burner BE CAREFUL TO PREVENT BURNS If the flames do not go and greasy spillovers that may ignite Heat out immediately EVACUATE AND CALL THE FIRE DEPARTMENT oils slowly on low or medium settings B NEVER PICK UP A FLAMING PAN You may be burned B Always turn hood on when cooking at C DO NOT USE WATER including wet dishcloths or towels a violent steam high heat or when cooking flaming foods explosion will result C Clean ventilating fans frequently if D Use an extinguisher ONLY if accessible Grease should not be allowed 1 You know you have a Class ABC extinguisher and you already know how to to accumulate on fan or filter operate it D Use proper pan size Always use cook 2 The fire is small and contained in the area where it started ware appropriate for the size of the suface 3 The fire department is being called element 4 You can fight the fire with your back to an exit WIRING DIAGRAMS SPECIAL WIRING PRECAUTIONS All installation should be wired according to the following diagrams Failure to comply will cause the moto
9. r to hum or not work 1 Turn off power at service entrance before wiring this fan Read the fan data plate to determine the current draw Check that available supply is suitable 3 Remove top enclosure of fan and the wiring box lid A 7 8 hole is provided for electrical service entry Use connectors and conduit provided 4 Connect electrical supply inside wiring terminal per diagram below 5 Replace wiring box lid and top enclosure WITH MOTOR SPEED CONTROL WITHOUT MOTOR SPEED CONTROL MOTOR CAPACITOR SPEED CAPACITOR CONTROL BLACK BLACK Se T O BLACK 115V SUPPLY E BLUE 115V SUPPLY WHITE WHITE FIVE 5 YEAR WARRANTY THIS WARRANTY SUPERSEDES ALL PRIOR WARRANTIES FANTECH RETURN POLICY Claims for damages or shortages must be reported within ten 10 days of receipt of FANTECH INC will repair or replace any part of your product that has a factory product s For any product s received damaged by the forwarding agent THE defect in workmanship or material Product must be returned to point of purchase FOLLOWING INSTRUCTIONS MUST BE FOLLOWED with Bill of Sale within five 5 years of purchase If factory return is required as 1 For product delivered by UPS f y determined by rep distributor the warrantee assumes all cost to and from the factory a Concealed Damages Keep all cartons Call UPS for an inspection and notify Fantech immediately THE FOLLOWING WARRANTIES DO
Download Pdf Manuals
Related Search