Extron electronic 700M User's Manual
Contents
1. Overview The Extron RM 700M allows the TLP 700MV TouchLink panel to be mounted in a standard rack The RM 700M uses 5 U of vertical space in a standard 19 inch equipment rack This guide provides basic instructions for an experienced installer to mount and connect the TLP 700MV Using the RM 700M mounting kit To mount the TLP 700MV in any standard 19 equipment rack follow these instructions 1 2 Extron USA West Disconnect all cables from the TLP 700MV Run cables for video network and power to the rack Secure the RM 700M to the rack using the screws provided by the rack s manufacturer Remove the faceplate from the TLP 700MV and ensure that all the locking arms are laying flush with the unit Push the TLP 700MV through the hole in the mounting kit and tighten the six screws for the locking arm As the screws tighten the locking arms rotate and clamp against the back of the mounting kit holding the TLP 700MV in place Connect the cables to the rear panel connectors Connect the LAN port to the network with a straight through cable Connect an S video or composite video source to the unit using these two BNC connectors e For S video connect the Y luminance signal to the VID Y input and the C chrominance signal to the C input e For composite video connect the input to the VID Y input Connect the power input toa 12 VDC 1 0 A RM 700M Sg2. Screws 6 Provided by Manufacturer power supply using the 2 pole captive screw connector Tighten screws to rotate locking arms Faceplate snaps to unit 4 plcs ea side Power input Video inputs 2 LAN input TLP 7OOMV Rear Panel If you do not plan to calibrate the TLP 700MV immediately see the TLP 700MV user s manual replace the faceplate by pressing the catches on the faceplate into the corresponding holes on the sides of the panel Headquarters 800 633 9876 Inside USA Canada Only 1 714 491 1500 1 714 491 1517 FAX Extron USA East 800 633 9876 Inside USA Canada Only 1 919 863 1794 1 919 863 1797 FAX Extron Europe Extron Asia 800 3987 6673 800 7339 8766 Inside Europe Only Inside Asia Only 31 33 453 4040 65 6383 4400 31 33 453 4050 FAX 65 6383 4664 FAX Extron Japan Extron China Extron Middle East 81 3 3511 7655 400 883 1568 971 4 2991800 81 3 3511 7656 FAX Inside China Only 971 4 2991880 FAX 86 21 3760 1568 86 21 3760 1566 FAX 2009 Extron Electronics All rights reserved 68 1793 01 Rev A 08 09 UL Guidelines for Rack Mounting The following Underwriters Laboratories UL guidelines are relevant to the safe installation of these products in a rack 1 Elevated operating ambient temperature If the unit is installed in a closed or multi unit rack assembly the ope
3. rating ambient temperature of the rack environment may be greater than room ambient temperature Therefore install the equipment in an environment compatible with the maximum ambient temperature Tma 113 F 45 C specified by Extron Reduced air flow Install the equipment in the rack so that the equipment gets adequate air flow for safe operation Mechanical loading Mount the equipment in the rack so that uneven mechanical loading does not create a hazardous condition Circuit overloading Connect the equipment to the supply circuit and consider the effect that circuit overloading might have on overcurrent protection and supply wiring Give appropriate consideration to the equipment nameplate ratings when addressing this concern Reliable earthing grounding Maintain reliable grounding of rack mounted equipment Pay particular attention to supply connections other than direct connections to the branch circuit such as the use of power strips
Download Pdf Manuals
Related Search