Home

Euro-Pro EP700 User's Manual

image

Contents

1. EURO PRO X Ultra Lightweight Upright Vacuum Model EP700 Use and Care Instructions For information or assistance USA EURO PRO Corporation Canada EURO PRO Corporation 178 West Service Rd 4400 Bois Franc Champlain NY 12919 St Laurent QC H4S 1A7 Tel 800 798 7398 Tel 514 842 8691 IMPORTANT SAFEGUARDS When using an electrical appliance basic safety precautions should always be observed including the following READ ALL INSTRUCTIONS BEFORE USING YOUR VACUUM CLEANER WARNING To reduce the risk of fire electrical shock or injury 1 Do not leave vacuum cleaner unattended when it is plugged in Unplug from outlet when not in use and before changing bags or filters 2 To reduce the risk of electric shock do not use outdoors or on wet surfaces 3 Do not allow children to use as a toy Close attention is necessary when used by or near children 4 Use only as described in this manual Use only manufacturer s recommended attachments 5 Do not use with damaged cord or plug Do not use vacuum cleaner if it has been dropped damaged left outdoors or dropped into water Return appliance to EURO PRO Corporation for examination repair or adjustment 6 Do not pull or carry by cord Do not use cord as a handle close a door on cord or pull cord around sharp edges or corners Do not run appliance over cord Keep cord away from heated surfaces 7 Do not unplug by pulling on cord To unplug grasp the plug not the c
2. from wall outlet Pull hard shell body cover 8 off by releasing the latch 11 on top of the cover Remove the old dust bag by holding the cardboard support and pull towards you from the bottom first and next from the top Remove carefully to avoid dust dirt spilling from dust bag Take a new dust bag and while holding the cardboard support push the bag over the opening of the dirt discharge tube until it is seated against the rear of the enclosure Make sure that the entire bag is inside the hard shell housing before closing outer cover Always check the filter every time you change the dust bag Once the new dust bag is in place re close the hard shell front cover by aligning the bottom locking tab with the slot in the body close cover slowly allowing the mid locks to engage then snap top in place The latch will self lock 2 Changing the Filter A B C D NOTE E This is best done while changing the dust bag Follow instructions for changing the dust bag Once dust bag has been removed peel off exhaust filter located behind the dust bag on unit body The filter is held in place by Velcro strips and is easily removed and replaced for cleaning To clean filter rinse in warm soapy water Filter must by completely dry before re installing into your vacuum To re install press filter back onto Velcro strips DO NOT OPERATE VACUUM WITHOUT FILTER IN PLACE Once filter has been replaced follow instr
3. g does not fit fully in the outlet reverse the plug If it still does not fit contact a qualified electrician Do not modify the plug in any way SAVE THESE INSTRUCTIONS FOR HOUSEHOLD USE ONLY EURO PRO X Ultra Lightweight Upright Vacuum Model EP700 120 V 60 Hz 3 3 A Main Components 9 10 1 Handle Assembly 6 Power Cord Storage Hooks 2 Middle Hard shell Body Section 7 Power Cord Guide Clips 3 Vacuum Cleaner Power Nozzle 8 Hard shell Body Cover 4 On off Foot Switch 9 Light Bulb Lens Cover 5 Power Cord 10 Power Nozzle Bumper 11 Cover Latch Warning Do not plug in vacuum unit until it is fully assembled Assembling Your Vacuum Cleaner Carefully unpack all components set aside packaging Place power nozzle section on a flat surface loosen clamping collar Make sure that the power nozzle elbow is a in the vertical and locked position d A Take the middle body section and insert the tapered end j of the dirt tube into the top opening of the power nozzle elbow Clamp in place by turning the locking collar clockwise Do not over tighten Clamping Collar To assemble the handle align the handle tube with the locking collar on the upper middle body section Insert the 4 tube until it is bottomed and then turn locking collar UN clockwise until secure Do not over tighten M Power Cord Unwrap power cord and push lower cord guide clip 7 onto dust tube just behind exhaus
4. he Phillips screw at the center of the base adjacent to the beater bar The light housing on the power nozzle top cover may now be removed allowing access to the light bulbs Pull the burnt bulb out of socket and replace in the same manner with a new bulb Reassemble unit by reversing steps B C amp D being careful not to pinch internal wiring and ensure that the light lens is correctly seated Screw for light EURO PRO X Ultra Lightweight Upright Vacuum TO ORDER REPLACEMENT BAGS FILTERS BELTS OR LIGHTS BULBS for Model EP700 Or for Customer Service Call EURO PRO Customer Service In U S 800 798 7398 or 514 842 8691 Monday to Friday 8 30 A M 5 00 P M Eastern Standard Time Please Note The Exhaust Filter is washable Important Make sure that the Filter is completely dry before inserting back in the vacuum EURO PROX THREE 3 YEAR LIMITED WARRANTY EURO PRO CORPORATION warrants this product to be free from defects in material and workmanship for a period of three 3 years from the date of the original purchase when utilized for normal household use subject to the following conditions exclusions and exceptions If your appliance fails to operate properly while in use under normal household conditions within the warranty period return the complete appliance and accessories freight prepaid to In US EURO PRO Corporation 178 West Service Rd Champlain N Y 12919 If the appliance is fo
5. or limitation of incidental or consequential damages so the above may not apply to you This warranty gives you specific legal rights and you may also have other rights which vary from state to state Important Carefully pack item to avoid damage in shipping Be sure to include proof of purchase date and to attach tag to item before packing with your name complete address and phone number with a note giving purchase information model number and what you believe is the problem with item We recommend you insure the package as damage in shipping is not covered by your warranty Mark the outside of your package ATTENTION CUSTOMER SERVICE OWNERSHIP REGISTRATION CARD Please fill out and mail the product registration card within ten 10 days of purchase in order to validate the foregoing Limited Warranty The registration will enable us to contact you in the unlikely event of a product safety notification By returning this card you acknowledge to have read and understood the instructions for use and warnings set forth in the accompanying instructions RETURN TO EURO PRO CORPORATION 178 WEST SERVICE RD CHAMPLAIN N Y 12919 Appliance model Date purchased Name of store Owner s name Address City State Zip Code Printed in China
6. ord 8 Do not handle plug or vacuum cleaner with wet hands Do not use outdoors or on wet surfaces 9 Do not put any objects into openings Do not use with any opening blocked and do not restrict airflow Keep all openings free of dust lint hair and anything that may reduce airflow 10 Keep hair loose clothing fingers and all parts of body away from openings and moving parts 11 Do not pick up hot coals cigarette butts matches or any hot smoking or burning objects 12 Do not pick up hard or sharp objects such as glass nails screws coins etc 13 Do not use without dust bag and or filters in place 14 Turn off all controls before plugging or unplugging vacuum cleaner 15 Use extra care when vacuuming on stairs 16 Do not pick up flammable or combustible materials lighter fluid gasoline kerosene etc or use in the presence of explosive liquids or vapor 17 Do not pick up toxic material chlorine bleach ammonia drain cleaner etc 18 Do not use in an enclosed space filled with vapors given off by oil based paints paint thinner moth proofing substances flammable dust or other explosive or toxic vapors 19 Use only on dry indoor surfaces 20 Do not use for any purpose other than described in this user s guide IMPORTANT NOTICE This appliance has a polarized plug one blade is wider than the other To reduce the risk of electric shock this plug will fit in a polarized outlet only one way If the plu
7. t grill Take extra cord guide clip 7 and push onto top handle section Wrap power cord using cord storage hooks 6 Upper cord storage hook 6 swivels to make it easy to unwrap cord before using vacuum cleaner Operation Release Power Cord The upper cord storage hook 6 has a quick release action To release cord rotate the hook downward and the entire power cord will drop off the hook for immediate use To Store Cord Return the cord hook 6 to the upright position before rewinding the cord Unplug from wall outlet by grasping the plug and pulling then rewind cord using upper and lower cord storage hooks Turn Vacuum On and Off On Off Switch To start the vacuum cleaner push step on the switch 4 3 ea on top right side of the power nozzle 3 To stop the vacuum cleaner push step on switch again Maintenance amp Care For best cleaning results the dust bag should be changed often The use of powder carpet fresheners can decrease the effectiveness of the dust bag filtering system by clogging the bag and not allowing air to flow though properly We recommend that hard objects pins broken glass paper clips etc be picked up from the floor before vacuuming Although your vacuum will pick them up they could do severe damage to the vacuum Use genuine EURO PRO dust bags belts and filters only to insure top performance from your vacuum 1 Changing the Dust Bag A B C D E F Unplug cord
8. uctions for installing dust bag and closing front hard shell cover Exhaust Filter fe 3 Changing the Power Nozzle Belt A B C D E F G H Occasionally the power nozzle drive belt will require changing the frequency will depend upon the amount of use your vacuum sees Turn unit Off and unplug from wall outlet Lower handle until it is flat on the floor Turn unit over so that power nozzle base faces up Use a Phillips screwdriver and remove all seven 7 screws from the power nozzle base Lift off power nozzle base being careful not to remove the bumper If the belt has broken remove any loose pieces before replacing Grasp the beater bar at either end and lift straight up Place one end of new belt over motor shaft and the other on the round pulley end of the beater bar Align the rubber supports at the ends of the beater bar with the slots in the power nozzle Push into place Ensure that the cut outs on the rubber supports face upwards Re install the power nozzle base and seven 7 Screws Changing the Power Nozzle Light Should the long life power nozzle bulbs burn out they can be changed in the following manner A B C D E F Unplug unit from wall outlet Remove power nozzle base follow instructions for changing the drive belt Do not remove the drive belt or beater bar when only changing the light bulbs Once the power nozzle base has been removed remove t
9. und by EURO PRO to be defective in material or workmanship EURO PRO will repair or replace it free of charge Proof of purchase date and 19 95 to cover the cost of return shipping and handling must be included Non durable parts including without limitation dust cup filters filters brushes and electrical parts which normally require replacement are specifically excluded from warranty The liability of EURO PRO Corporation is limited solely to the cost of the repair or replacement of the unit at our option This warranty does not cover normal wear of parts and does not apply to any unit that has been tampered with or used for commercial purposes This limited warranty does not cover damage caused by misuse abuse negligent handling or damage due to faulty packaging or mishandling in transit This warranty does not cover damage or defects caused by or resulting from damages from shipping or repairs service or alterations to the product or any of its parts which have been performed by a repair person not authorized by EURO PRO This warranty is extended to the original purchaser of the unit and excludes all other legal and or conventional warranties The responsibility of EURO PRO Corporation if any is limited to the specific obligations expressly assumed by it under the terms of the limited warranty In no event is EURO PRO Corporation liable for incidental or consequential damages of any nature whatsoever Some states do not permit the exclusion

Download Pdf Manuals

image

Related Search

Related Contents

Warp 3.0 User Manual 4-03.qxd - Andover Consulting Group, Inc.  Bosch PLR 15  NJ-EM10  Stainless Steel Platform Scale Plateau De Balance en Acier  Kip 7970 User Manual  Internet Telephony PBX System - PLANET Technology Corporation.  

Copyright © All rights reserved.
Failed to retrieve file