Epson Network Image Express Card User's Manual
Contents
1. Network Image Express Interface Card T his section explains how to install the optional N etwork I mage Express interface card B12B808393 in your scanner Setting Up Client Computers Before connecting the scanner to your network make sure any computer you want to use for scanning is set up properly Check that m an Ethernet network card is installed in the computer m thecomputer is configured to use the TCP IP network protocol m your scanner software is installed see the Start H ere sheet for instructions For instructions on installing your computer s card see the manual that came with the card For instructions on setting up TCP IP see your computer s manual or online hdp Installing the Card in Your Scanner 1 Turn off the scanner and disconnect the power cord and any cables 2 Removethetwo screws securing the shield plate to the scanner s optional interface slot and then remove the plate K eep the screws and shield plate in case you want to reinstall them later 3 Fully insert the N etwork Image Express card in the slot and tighten its screws Caution Do not insert the card with the scanner tumed on or you could damage the card or the scanner 4 Plugin the scanner and reconnect its cables 5 Initialize the card by holding down its RESET button to the right of the connector while you turn on the scanner Continue holding down the button for about 10 seconds until the card s red and green light2. s to the left of the connector turn on N ow you re ready to connect the scanner to your network Connecting the Scanner to Your Network 1 2 Turn off the scanne Connect an Ethernet cable Category 5 unshielded twisted pair to the RJ 45 jack on the card and then connect the other end to a hub on your network Note To prevent corruption of scanned data you must use a Category 5 cable Do not connect the scanner directly to your computer instead connect it to the network through an existing hub Turn on the scanner Check the lights on the card Initialization is in progress while the red and green lights are on When the yellow light comes on initialization is complete Assign the card an IP address See the N etwork I mage Expres Card U ser sGuidefor instructions Be sure to note the address as you ll need it in the next section
Download Pdf Manuals
Related Search