Electrolux ETC15TKH User's Manual
Contents
1. Your compactor has been designed to require minimum space without loss of capacity whether free standing or built in Free Standing As shipped the Compactor is only configured for built in installations This appliance can be converted from built in to free standing with the use of Toe Kick Accessory Kit Model ETC15TKH sold separately If additional cord length is required for free standing installation remove the cord clamp and wire tie on the back of the unit CAUTION Failure to use Toe Kick Accessory Kit Model ETC15TKH in a free standing installation may cause the compactor to be unstable during operation Installation Built in Installations MOUNTING STRAPS TOP OF COMPACTOR FRONT OF COMPACTOR Two under counter mounting straps are provided Use these straps to secure the compactor to the underside of a countertop Fasten the slotted end of the straps to the compactor using the holes in the top of the compactor cabinet as shown NOTE When installing compactor under granite or solid surface countertops bend the mounting straps so they can be secured to the adjacent cabinetry UNDER COUNTER OPENING 15 W gt 24 D 345 s H o o ELECTRICAL OUTLET 12 My The compactor requires an under counter opening 15 in wide 34 s in high and 24 in deep Plan to provide an electrical outlet2. in the opening that meets all applicable electrical codes and requirements See Grounding Instructions section on Page 3 for specific information CORD CLAMP The compactor is equipped with a 6 ft long power cord Use the cord clamp to prevent excess power cord from being pinched beneath the cabinet during installation or service 6 Installation Leveling the Compactor Your compactor has four adjustable levelers 2 rollers in the rear and 2 legs in the front They allow you to adjust for uneven floors and also trim the unit up to fit an under counter installation BACK OF COMPACTOR ae o d SCREWS 1 ROLLERS To level the back of the compactor Tip the back of compactor up and onto a wood block Loosen the adjusting screws only far enough to move the rollers to a higher or lower slot Retighten the adjusting screws and remove the wood block FRONT OF COMPACTOR LEVELING LEGS To level the front of the compactor Tip the front of compactor up and onto a wood block Turn the leveling legs in or out to the desired position Remove the wood block
Download Pdf Manuals
Related Search