Dimplex Indoor Fireplace EWMC-CC-SS User's Manual
Contents
1. decorative top panel to unit with 2 screws per bracket Screws included 6 Tighten remaining 4 screws on decorative top panel FIGURE 92. X Dimplex North America Limited PRACTICAL USER S GUIDE FOR THE CORNER WALL MOUNTED ELECTRIC FIREPLACE MODEL NUMBER EWMC CC SS Quality checked by Valued Customer We are pleased that you have chosen to purchase an electric fireplace manufactured by Dimplex North America Limited 7206640100REV04 CONTENTS PAGE 1 PAGE 2 PAGE 3 PAGE 8 PAGE 10 PAGE 12 Important Instructions Model and Serial Number Information Wall Mount Installation Operation Maintenance Warranty QUICK REFERENCE GUIDE FOR THE ELECTRIC CORNER WALL MOUNT FIREPLACE 1 Before using the electric corner wall mounted fireplace verify e Are the circuit breakers for the unit on e Are the light bulbs loose to check follow the instructions for replacing the light bulbs under the maintenance section of this manual 2 The heater may emit a slight harmless odor when first used This odor is a normal condition caused by the initial heating of internal heater parts The information regarding the model of your unit can be found on the rating plate located inside the unit on the top left hand corner above the mirror If you have any questions or concerns regarding the operation of your fireplace contact Dimplex customer service at 1 888 DIMPLEX 1 888 346 7539 IMPORTANT INSTRUCTIONS SAVE THESE INSTRUCTIONS RETAIN THIS USER S GUIDE FOR FUTURE REFERENCE When using electrical appliances basic precautions should al
3. d on top of unit is 25 Ibs 11 kg Do not use fireplace as a seat or step WARNING Ensure the power cord is not installed so that it is pinched or against a sharp edge and ensure that the power cord is stored or secured to avoid tripping or snagging to reduce the risk of fire electric shock or injury to persons Construction and electrical outlet wiring must comply with local building codes and other applicable regulations to reduce the risk of fire electric shock and injury to persons Do not attempt to wire your own new outlets or circuits To reduce the risk of fire electric shock or injury to persons always use a licensed electrician WARNING The supplied mounting brackets are designed for use with Dimplex corner wall mounted fireplaces only Improper use or use for purposes other than intended may cause damage or injury CORNER WALL MOUNTED ELECTRIC FIREPLACE INSTALLATION WARNING Failure to install the corner wall mounted electric fireplace as instructed below may result in damage to the equipment and or may expose the user to the risk of fire serious injury illness or death WARNING The corner wall mounted electric fireplace requires each wall mounting bracket to be installed into a minimum of one wall stud TOOLS Drill Y drill bit slotted screwdriver angle divider stud locator NOTE For optimum installation the corner wall mounted electric fireplace should be installed in a 90 SS corner 3 The use of washers
4. ded fused and polarized outlets Disconnect all power supply before performing any cleaning maintenance or relocation of the unit When transporting or storing the unit and cord keep in a dry place free from excessive vibration and store so as to avoid damage NOTE Procedures and techniques that are considered important enough to emphasize CAUTION Procedures and techniques which if not carefully followed will result in damage to the equipment WARNING Procedures and techniques which if not carefully followed will expose the user to the risk of fire serious injury illness or death 1 IMPORTANT INSTRUCTIONS If you have any questions about out products please have the product model and serial numbers available upon calling Dimplex customer service To locate the model and serial number labels see below Model Number LISTED gt Dimplex us Model Number Serial Number Be i Serial Number Model Number Firebox Carton NOTE A 15amp 120 volt circuit is required A dedicated circuit is preferred but not essential in all cases A dedicated circuit will be required if after installation the circuit breaker trips or the fuse blows on a regular basis when the heater is operating Additional appliances on the same circuit may exceed the current rating of the circuit breaker WARNING Placing heavy objects on top of this fireplace may cause damage or injury Maximum suggested weight to be place
5. included may be required if the corner is not within the specified tolerance 1 Select the desired corner near an electrical outlet power cord length is 5 feet 2 Ensure the front of the unit when installed is at least 3 feet 0 9m from combustible materials such as furniture pillows bedding papers clothes and curtains 3 Mount the unit in the corner with the bottom trim being at a minimum of 15 mounting bracket 50 above the floor FIGURE 1 amp 2 NOTE It is recommended that the bottom trim of the FIGURE 1 FIGURE 2 unit not be mounted higher than 18 from the ground mounting bracket no higher than 53 FIGURE 1 amp 2 4 To mount the unit so that the wall outlet is hidden mount the bracket 30 33 above the top of the outlet FIGURE 3 5 Use a stud locator to determine the location of the studs in the corner 6 Mark the stud locations on the wall 7 Position mounting brackets on wall and align with wall stud markings NOTE Ensure that each mounting bracket is installed into at least one wall stud NOTE When installing into one wall stud use one of the FIGURE 3 center locations as indicated in FIGURE 6 NOTE When installing into two wall studs use the outer locations as indicated in FIGURE 7 8 Choose the center marking and place the bubble level onto the top of the wall mounting bracket 9 Adjust the wall mounting bracket so the bubble on the level is centered between
6. jects to enter any ventilation or exhaust opening as this may cause an electric shock or fire or damage to the heater To prevent a possible fire do not block air intake or exhaust in any manner Do not use on soft surfaces like a bed where openings may become blocked All electrical heaters have hot and arching or sparking parts inside Do not use in areas where gasoline paint or flammable liquids are used or stored or where the unit will be exposed to flammable vapors Do not modify the corner wall mounted electric fireplace Use it only as described in this manual Any other use not recommended by the manufacturer may cause fire electric shock or injury to persons To reduce the risk of electric shock this appliance has a polarized plug one blade is wider than the other The plug will fit in a polarized outlet only one way If the plug does not fit fully in the outlet reverse the plug If it still does not fit contact a qualified electrician to install the proper outlet Do not change the plug in any way Avoid the use of an extension cord Extension cords may overheat and cause a risk of fire If you must use an extension cord the cord must be No 16 AWG minimum size and rated no less than 1875 watts Do not burn wood or other materials in the corner wall mounted electric fireplace Do not strike the glass front Always use a certified electrician should new circuits or outlets be required Always use properly groun
7. the two black lines 10 Mark the other two mounting screw locations on the wall bracket ensuring that the wall bracket stays level 11 Drill holes into the wall on the marked locations where wall anchors are to be installed FIGURE 4 NOTE Do not drill Y holes into the wall where the studs have been located 12 Squeeze the wall anchor together and insert the wall anchors into the Y holes in the wall FIGURE 5 13 Insert the wall anchor screws through the wall bracket and thread into the wall anchors The screws should extend beyond the wall anchors Tighten the screws FIGURE 5 a A 14 Install the remaining screw s into the wall DDN stud s as required IN A hole 15 Repeat steps 8 to 14 for 2 bracket aN in wall D SY gt SF FIGURE 4 Wall Anchor Bolt Wall Bracket FIGURE 5 FIGURE 6 FIGURE 7 UNIT INSTALLATION FIGURE 8 SECURING DECORATIVE TOP PANEL TO UNIT NOTE Secure decorative top panel to unit after installing unit to wall NOTE Top panel brackets are left loose by the manufacturer in order to be adjusted to match the engaging holes in the back panel TOOLS Slotted screwdriver 1 Place decorative top panel on top of unit 2 Open door to achieve access to top panel brackets 3 Align top panel brackets with holes on back panel 4 If required adjust top panel to achieve a consistent gap above the door 5 Secure
8. ways be followed to reduce the risk of fire electric shock and injury to persons 1 Read all instructions before using the corner wall mounted electric fireplace The heater is hot when in use To avoid burns do not let bare skin touch hot surfaces The trim around the heater outlet becomes hot during heater operation Keep combustible materials such as furniture pillows bedding papers clothes and curtains at least 3 feet 0 9m from the front of the unit Extreme caution is necessary when any heater is used by or near children or invalids and whenever the unit is left operating and unattended Always unplug the corner wall mounted electric fireplace when not in use Do not operate with a damaged cord or plug or if the heater has malfunctioned or if the wall mounted electric fireplace has been dropped or damaged in any manner Return heater to authorized service facility for examination electrical or mechanical adjustment or repair Do not use outdoors The corner wall mounted electric fireplace is not intended for use in bathrooms laundry areas and similar indoor locations Never locate heater where it may fall into a bathtub or other water container Do not run the cord under carpeting Do not cover cord with throw rugs runners or the like Arrange cord away from traffic area and where it will not be tripped over To disconnect the unit turn the controls off then remove the plug from the outlet Do not insert or allow foreign ob
Download Pdf Manuals
Related Search