De'Longhi KBC3010 User's Manual
Contents
1. has only two pin socket outlets or if you are in doubt consult a qualified electrician Should the mains lead ever require replacement it is essential that this operation be carried out by a qualified electrician and should only be replaced with a flexible cord of the same size Only 3amp replacement fuses which are asta approved to B S 1362 should be fitted This appliance conforms to the Norms EN 55014 regarding the suppression of radio interference 182IDL 09 02 8 Kettle KBC3010 KBX3010 CHETI Living innovation2. 182IDL 20 09 2002 8 04 Pagina 1 M DeLonghi M Instructions CORDLESS KETTLE KBC 3010 KBX 3010 Living innovation 182IDL 20 09 2002 8 04 Pagina 2 3 Description of Appliance The following terms are used throughout the instruction manual W_ lt V Filter Lid release button lt On Off switch 2 Kettle KBC3010 KBX3010 CHETA Living innovation 182IDL 20 09 2002 8 04 Pagina 3 3 Thank you for choosing this De Longhi kettle To get the best results from your new kettle it is advisable to read these instructions carefully before using the appliance This is the only way to ensure optimum results and maxi mum safety Using for the first time Before use check that the appliance has not been damaged dur ing transport Remove all packaging from the kettle and power base Remove any labels from the outer surfaces Remove the filter as shown in fig and wash with water refer to pag 5 Removing the scale filter Fill the kettle and boil The boiled water should be discarded and the kettle rinsed out with cold water This procedure should be carried out three times to remove any manufacturing dust etc After the kettle has been rinsed out re fit the filter as described on page 5 Using the kettle With the specially designed power base and central connector you can now set the kettle on the base at any angle from any position Release cord from storage base and adjust length by wind
3. ically Pouring Remove the kettle from the power base and carefully pour out the water Do not tilt the kettle suddenly or pour water out at too sharp an angle When you lift the kettle from the base you may see moisture on the top surface of the base This is condensation from the Fig 7 steam that causes the kettle to turn off automatically after boil ing Steam is allowed to escape via vents in the underside of the kettle Condensation on the base is perfectly normal and should not be a cause for alarm Safety devices 1 Automatic ON OFF switch Your kettle is fitted with an ON OFF switch which automatical ly switches off once the water has boiled If the kettle has just boiled wait a minute or so before re boiling the kettle Do not attempt to hold the ON OFF switch in the on position or adjust the switch mechanism 2 Safety cut out If the kettle is switched ON with too little or no water it is protected against damage by a safety cut out which will switch off the power If this cut out operates disconnect the kettle from the mains supply and leave to cool down before refilling with cold water otherwise the element could be damaged 3 If kettle is lifted from base while operating ON it will auto matically switch off 4 Kettle KBC3010 KBX3010 QHT LI Living innovation 182IDL 20 09 2002 8 04 Pagina 5 3 Cleaning and maintenance Cleaning the kettle Allow the kettle to cool down f
4. ils into the kettle The use of accessory attachments not recommended by the appliance manufacturer may result in fire electric shock or personal injury Never use the kettle without its lid Position the kettle properly on the power base before switching on Use the kettle only with the power base supplied and vice versa Do not operate this kettle if the mains lead or plug is damaged if the kettle malfunctions or has been damaged in any manner It must be returned to a service agent for repair or replacement in order to avoid hazard The power cable must not be replaced by the user as this requires the use of special tools If the power cable is damaged contact an authorized Service Centre If the kettle is overfilled boiling water may overflow 7 Kettle KBC3010 KBX3010 QHT LI Living innovation 182IDL 20 09 2002 8 04 Pagina 8 3 Electrical Requirements The flexible mains lead is supplied connected to a B S 1363 fused plug having a fuse of 13 amp capacity Should this plug not Green and Yellow to fit the socket outlets in your home it should be cut off and Earth replaced with a suitable plug following the procedure outlined below Note Such a plug cannot be used for any other appliance and y should therefore be properly disposed of having removed the LE Brown to fuse and not left where children might find it and plug it into a Blue M TRR supply socket with the obvious consequent danger Neutral i If the plug is a m
5. ing around the base to give the correct cord length to reach the plug socket to be used fig 4 Do not leave loose cord hanging over the edge of work sur faces Filling Remove the kettle from the base unit before filling Open lid by pressing on the lid release button The lid will open automatically fig 5 Fill kettle to desired level Do not fill with less than 0 6 litre of water to prevent the kettle running dry while operating misuse of this kind will shorten the life of the element Do not fill with more than 1 7 litres of water fig 6 If the kettle is overfilled there is a risk that boiling water may be ejected causing burns To close the lid push it on the upper part Fig Fig 3 CORD EXIT Fig 4 Push Fig 5 3 Kettle KBC3010 KBX3010 QH ST Living innovation 182IDL 20 09 2002 8 04 Pagina 4 3 Switching on Plug the power base into the mains socket e Place kettle on power base Press the ON OFF switch down fig 7 to switch the kettle on e The pilot light will switch on The kettle will automatically switch off once the water is boiled the ON OFF switch will click upwards and the light will go out To turn the kettle off before the water boils you may move the Fig 6 ON OFF switch up to the OFF position or simply lift the kettle from its base it will switch off and the switch will return to the OFF position automat
6. oulded on type the fuse cover must be refit ted If the fuse cover is lost the plug must not be used until a replacement cover is obtained The colour of the correct replace ment fuse cover is that of the coloured insert in the base of the fuse recess or elsewhere on the plug Always state this colour when ordering a replacement fuse cover N B We recommend the use of good quality plugs and wall sockets that can be switched off when the machine is not in use important the wires in the mains lead fitted to this appliance are coloured in accordance with the following code Warning this appliance must be earthed GREEN AND YELLOW EARTH BLUE NEUTRAL BROWN LIVE As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the termi nals in your plug proceed as follows The wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol or coloured green or green and yellow The wire which is coloured blue must be connected to the termi nal which is marked with the letter N or coloured black The wire which is coloured brown must be connected to the ter minal which is marked with the letter L or coloured red When wiring the plug ensure that all strands of wire are securely retained in each terminal Do not forget to tighten the mains lead clamp on the plug If your electricity supply point
7. re that your mains supply voltage is the same as that marked on the underside of your kettle To protect against electrical hazards do not immerse the mains lead plug power base or kettle in water or any other liquid Do not use in the bathroom or near any source of water Do not use outdoors Do not touch hot surfaces i e body or lid Use handles or knobs Do not remove the lid while the kettle is boiling Take care when pouring do not over tilt the kettle as water may enter into the switch mechanism Water can remain hot for a long time after boiling and can present a scald hazard Keep the kettle and the mains lead away from the edge of the work surface and out of the reach of chil dren Do not allow the mains lead to hang over the edge of the table or work surface or anywhere it may be accidentally caught or tripped over Close supervision is necessary when any appliance is used near children Remove the plug from the mains socket when not in use and before cleaning Allow the kettle to cool before cleaning Remove the kettle from its power base before filling Never move the kettle whilst it is in use Do not use the kettle if you have wet hands Keep the kettle the power base and the mains lead away from hotplates hobs or burners 6 Kettle KBC3010 KBX3010 CEMT Living innovation 182IDL 20 09 2002 8 04 Pagina 7 3 Do not use the kettle for any purpose other than heating water Do not place any utens
8. ully and disconnect the appli ance from the mains before cleaning Do not immerse the kettle or base in water Use a soft dampened cloth to wipe the outside of the kettle and dry with a soft dry cloth e DO NOT use harsh scouring agents Ensure that all connectors and sockets are kept dry Scale Scale is mainly calcium carbonate chalk a harmless naturally occurring mineral found in most water supplies Hard water con tains more of this mineral than soft water When the water is heated the minerals in the water solidify mak ing the water appear cloudy These minerals form a thin film on the walls element and on the surface of the water The water may look like it has white coloured pieces of plastic floating on the sur face On traditional kettle elements scale forms a hard white crust which adversely affects performance and reduces the life of the element As soon as you notice a film forming on the water or when clean ing the filter if you notice a film on the walls or the element simply rinse the kettle and wipe it out Scale filter Your kettle is fitted with a scale filter to prevent loose particles of scale being poured into your beverage This filter is both removable and washable The frequency with which you will need to clean any scale deposits from your filter will depend on the hardness of water in your area and how often you use the kettle You should remove and clean the
9. water filter when you notice any deposits being left on the filter or if the pouring efficiency is impaired Removing the scale filter e Allow the kettle to cool down fully Disconnect the appliance from the mains electrical supply Make sure that your hands are clean and free from soap cream or anything which might taint the water e Empty the kettle and open the lid Remove the filter by pushing the catch down and lifting up see figure 1 e Rinse under a tap whilst brushing with a soft brush fig 2 Replace the filter sliding it firmly down see fig 3 5 Kettle KBC3010 KBX3010 Living innovation 182IDL 20 09 2002 8 04 Pagina 6 3 To clean the scale filter It is vital to clean and descale regularly in order to maintain good working order Use a proprietary descaling product e g citric acid crystals We recommend using citric acid crystals as follows Pour into kettle about 50 gr or 2 oz of citric acid crystal and then fill with water up to the max level indicated and then boil Allow the contents to cool and then rinse thoroughly Do not use a more concentrated solution lf the filter requires descaling remove the filter and place into the citric acid solu tion Ensure that the electrical connections are completely dry before using the kettle Citric acid crystals are available from most pharmacies Safety Warnings Please read these instructions before operating and retain for future reference Ensu
Download Pdf Manuals
Related Search