Dell B-DCX-4s Replacement Procedure
Contents
1. one of the cable management finger assemblies 2 Unscrew and save the three 3 screws holding the finger assembly to the rack upright Figure 1 Support the assembly to prevent it from falling Remove the cable management finger assembly 4 If necessary repeat steps 1 3 for the other finger assembly PowerConnect B DCX 4S Vertical Cable Management Fingers Replacement Procedure 3 53 1001795 01 qooGson oyip PUMHUUUO BDU GUOLUOKUO i a Y miiy al Allla FIGURE 1 Vertical cable management finger assemblies oe Replacing the cables management finger assemblies 1 Position and tighten the three 3 screws to secure the vertical cable management finger assembly to the rack upright Arrange the cables along the cable management finger assembly If necessary repeat step 1 and step 2 for the other cable management assembly 4 PowerConnect B DCX 4S Vertical Cable Management Fingers Replacement Procedure 53 1001795 012. 53 1001795 01 aM January 31 2010 PowerConnect B DCX 4S Vertical Cable Management Fingers Replacement Procedure Supporting PowerConnect B DCX 4S Backbone 53 1001795 01 0 DANOU UON D N TET Notes Cautions and Warnings NOTE A NOTE indicates important information that helps you make better use of your computer A CAUTION See the safety and regulatory information that shipped with your system For additional regulatory information see the Regulatory Compliance Homepage on www dell com at the following location www dell com regulatory_compliance CAUTION A CAUTION indicates potential damage to hardware or loss of data if instructions are not followed DANGER A DANGER indicates a potential for property damage personal injury or death Information in this document is subject to change without notice 2009 Dell Inc All rights reserved Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc is strictly forbidden Trademarks used in this text Dell the DELL logo Inspiron Dell Precision Dimension OptiPlex Latitude PowerEdge PowerVault PowerApp Dell OpenManage and the YOURS IS HERE logo are trademarks of Dell Inc Intel Pentium and Celeron are registered trademarks of Intel Corporation in the U S and other countries Microsoft Windows Windows Server MS DOS and Windows Vista are either trademarks or registered trademarks of Microsoft Corpo
3. ration in the United States and or other countries Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products Dell Inc disclaims any proprietary interest in trademarks and trade names other than its own Regulatory Model Codes Brocade DCX 4S Brocade DCX 2 PowerConnect B DCX 4S Vertical Cable Management Fingers Replacement Procedure 53 1001795 01 In this guide e Installing the PowerConnect B DCX 4S Vertical Cable Management Fingers 3 Tmerre ip aeroreceewenieresec renee eee ARE rE ey eeabens 3 Kems SCN esea ninaa aa amp Geel Mates EEA 3 Removing the cable management finger assembly 2005 3 e Replacing the cables management finger assemblies 4 Installing the PowerConnect B DCX 4S Vertical Cable Management Fingers The PowerConnect B DCX 4S comes equipped with two vertical cable management finger assemblies It can continue to operate during the replacement of the cable management fingers Due to the horizontal orientation of the blades in the DCX 4S the finger assemblies are attached to the uprights of the mounting rack Time required The replacement procedure for the cable management fingers takes less than five minutes Items required e One or two DCX 4S vertical cable management finger assemblies e A 1 Phillips screwdriver Removing the cable management finger assembly 1 Rearrange the cables around
Download Pdf Manuals
Related Search