CyberPower CS20A-EBP User's Manual
Contents
1. berPower User s Manual for CyberShield External Battery Pack CS20A EBP 20Ah 12V Battery eS PAY CyberShield UPSs are designed to provide a local power solution for cable telephony wireless local loop WLL and fiber to the home FTTH broadband equipment CyberShield External Battery Pack connects directly to the CyberShield providing longer runtime for connected applications IMPORTANT SAFETY WARNINGS SAVE THESE INSTRUCTIONS This manual contains important instructions regarding the installation and operation of this device Read this manual thoroughly before attempting to unpack install or operate this device CAUTION The battery can energize hazardous live parts inside even when the AC input power is disconnected CAUTION To prevent the risk of fire or electric shock install in a temperature and humidity controlled indoor area free of conductive contaminants Please see specifications for acceptable temperature and humidity range CAUTION To reduce the risk of electric shock do not remove the cover except to service the battery No user serviceable parts inside except for the battery CAUTION To avoid electric shock turn off the unit and unplug it from the AC power source before servicing the battery or installing a computer component UNPACKING Inspect the unit upon receipt Notify the shipping carrier or product supplier if there is damage The box should contain the following 1 th2. Merchantability or for Fitness for a Particular Purpose if applicable to the Product is limited in duration to three years This provision shall NOT create any Implied Warranty or Merchantability or of Fitness for a Particular Purpose that would not otherwise apply to the Product NOTE Some States and Provinces do not allow limitations on how long an implied warranty lasts so the above limitation may not apply to you To be covered you must still be the owner of the Product at the time of the failure that results in the claim made under this Limited Warranty Your sole and exclusive remedies are those provided by this Limited Warranty This exclusion of other express warranties applies to written and oral express warranties CyberPower excludes any liability for personal injury CyberPower excludes any liability for direct indirect special incidental or consequential damages whether for damage to or loss of property loss of profits business interruption information or data This exclusion applies even though damage or loss is caused by negligence or other fault NOTE Some States or Provinces do not allow the exclusion or limitation of incidental or consequential damages so the above limitation may not apply to you DO NOT USE FOR MEDICAL OR LIFE SUPPORT EQUIPMENT OR OTHER HIGH RISK ACTIVITIES CyberPower does not sell the PRODUCT for use in high risk activities The PRODUCT is not designed or intended for use in hazardous environments requiri
3. a safe procedure isolated from electrical hazards You may leave the UPS and connected equipment on for this procedure To replace the battery module refer to BATTERY INSTALLATION above Once the battery is disconnected the connected equipment is not protected from power outages Deliver spent batteries to a recycling facility or ship to the manufacturer in the replacement battery packing material pb The UPS battery charges when it is connected to utility power The battery charges fully during the first 24 hours of normal operation Do not expect full battery run capability during this initial charge period SPECIFICATION Battery Type Sealed Maintenance Free Lead Acid Battery Numbers ofBattery OAH 12Vx4 Replaceable 0 000 doo Yes ooo Physical _ a i Maximum Dimensions LWD 30cm x 28cm x 9 9cm Weight kg ooo 7 5 i A Environment e ile el ai aris cae So Operating Temperature 32 F 104 F 0 40 C Operating Humidity 0 95 noncondensing within enclosure Max Operating Elevation 40 000ft 3 000m Max Storage Elevation _ 50 000 15000m BF 113 F 15 C 45 C Storage Temperature FCC NOTICE This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equip
4. e enclosure cable and connector attached 2 the battery installed not connected 3 product documentation ENCLOSURE INSTALLATION Carefully follow these instructions during installation of this device 1 Carry out the installation in a safe area that is free of excessive dust and has adequate airflow 2 Screws must be appropriate for total weight of the UPS and the mounting surface material 3 Do not operate the UPS where the temperature and humidity are outside the specified limits Refer to specification in this manual Step 1 Step 2 Step 3 a Remove the battery cover a Unstrap strap from battery a Use the enclosed installation template to b Slide battery off of the mark an installation location for the unit shelf b Mount the unit on the wall with 2 mounting c Disconnect battery cable screws into the keyhole slots connector at chassis end c Tighten the screws to secure the units d Connect the battery connector and replace the battery back BATTERY INSTALLATION Step 1 Step 2 Step 3 a Remove the battery cover a Loosen the battery strap b Disconnect battery cable connector close the battery cover to remove battery c Replace with new battery and re connect the battery connector a Tighten the battery strip and gt Pe CONNECTING A SINGLE EXTERNAL BATTERY PACK BATTERY REPLACEMENT This UPS has an easy to replace hot swappable battery Replacement is
5. ment generates uses and can radiate radio frequency energy and if not installed and used in accordance with these instruc tions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures 1 Reorient or relocate the receiving antenna 2 Increase the separation between the equipment and receiver 3 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected 4 Consult the dealer or an experienced radio TV technician for help CAUTION Shielded signal cables must be used with this device to ensure compliance with Class B FCC limits CAUTION Any changes or modifications not expressly approved by Cyber Power could void the authority granted by the FCC to operate this equipment LIMITED WARRANTY CyberPower warrants to you the Initial Purchaser that the Product will be free from defects in material and workmanship for three years from the date of original purchase subject to the terms of this Limited Warranty This Limited Warranty gives you specific rights and you may have other rights which vary from State to State or Province to Province Any Implied Warranty of
6. ng fail safe performance including the operation of nuclear facilities aircraft navigation or communication systems air traffic control weapons systems life support or medical applications or for use in any circumstance in which the failure of the PRODUCT could lead directly to death personal injury or severe physical or property damage or that would affegt operation or safety of any medical or life support device collectively High Risk Activities CyberPower expressly disclaims any express or implied warranty of fitness for High Risk Activities CyberPower does not authorize use of any PRODUCT in any High Risk activities ANY SUCH USE IS IMPROPER AND IS A MISUSE OF A CYBERPOWER PRODUCT The Limited Warranty is governed by the laws of the United States and the State of Minnesota without reference to conflict of law principles The application of the United Nations Convention of Contracts for the International Sale of Goods is expressly excluded For more information please contact CyberPower Systems USA Inc 5555 12th Avenue East Suite 110 Shakopee MN55379 Phone 952 403 9500 Fax 952 403 0009 www cyberpowersystems com CyberPower Systems B V Europe Uilenwaard 42 5236 WB s Hertogenbosch The Netherlands Phone 31 73 649 1209 Fax 31 73 649 1208 www cyberpower eu com CyberPower Power To Control the Pawety KO1 CS20A00
Download Pdf Manuals
Related Search