Cornelius ED2XX 629080214 User's Manual
Contents
1. EES a E 3 FRONT MOUNTING PLATE z lt 603 8 N 605 8 FIGURE 1 AS REQ D SS REAR MOUNTING PLATE 6 SEAL WITH RTV AS REQ D BEVERAGE PANEL ACCESS COVER KEYSWITCH FIGURE 2 3 6209141012. to the side of one Unit as indicated in Figure 1 Ends of the gasket should fit tight to each other Place Units into position on the counter The Units must be at the same height and sitting level The outside outside dimension of the Units should be 60 3 8 inches 3 8 inch between the Units at the center Remove one screw from each base at the rear of the Unit and install rear mounting plate item 2 to main tain the proper spacing between the Units see Figure 2 Install front mounting plate item 3 using the four beverage panel mounting screws at the center of the Units The rectangular plate is for use with the six or eight valve Units Apply RTV item 5 at the gasket cabinet joint to seal any gaps between the Units on all sides of the gas ket Using one screw on each cabinet at the center of the Units above the drip trays install drip tray cover to match color of the drip tray The drip trays must be at the same height along the edges for cover to fit properly Assemble two long 8 32 screws item 9 to lower panel item 1 using plastic washers item 10 Install lower panel assembly on Units Install Cornelius logo item 11 Replace hopper covers on the Units manual fill Units Connect power cords for Ice Beverage Dispenser to electrical outlet Check Dispensers for proper opera tion 620914101 2 APPLY GASKET KEYSWITCH BETWEEN SIDES OF EH EHK EH HK he KEYSWITCH A Ley Sy
3. IMI CORNELIUS INC One Cornelius Place Gee REMCOR INSTALLATION INSTRUCTIONS FOR ED2XX DUAL MOUNTING KIT DISPENSER MODEL KIT PART NUMBER ED200 250 629085101 PARTS LIST Drip Tray Cover Black e femmo salat nstuctons SSCS H TET 1 Qty 2 1 Disconnect electric power to the Ice Beverage Units while installing the Kit 2 Remove lower panel assembly from both Units 3 Relocate beverage valve keyswitch to right side of the beverage panel on one of the Units This Unit will be positioned on the right side of the counter A Remove beverage panel access covers B Locate black and red wires of the keyswitch Cut these wires approximately 2 inches from the crimp nut connection to the yellow wires C Loosen the keyswitch mounting nut and remove the keyswitch Using a 7 8 inch deep socket will help access the nut D Remove plastic plug from right side of the beverage panel and insert into the left side keyswitch opening E Install keyswitch into the right side of the beverage panel and tighten mounting nut E IMI Cornelius Inc 1998 RevA December 9 1998 620914101 10 11 12 13 14 F Move black and red wires from left to right side of the beverage panel Strip red black wires and reconnect to the keyswitch using wire connectors item 4 provided G Install beverage panel access covers Install Adaptor Kits if applicable for the type of ice makers used Apply self adhesive gasket material item 7
Download Pdf Manuals
Related Search