Cooper Lighting RKD-140RS-49-10B User's Manual
Contents
1. RKD 140RS 48 10B amp RKD 140RS 49 10B Installation Instructions Installation instructions for converting two lamp or more industrial and strip type fluorescent fixtures to Rapid Start single lamp 48 and 49 3 4 reflectorized fluorescent fixtures Contents 1 48 1 2 or 49 3 4 reflector h WARNING Risk of fire or electrical shock Reflector kit installation requires knowledge of fluorescent lighting fixtura electrical systems If not qualified do not attempt installation Contact a qualified electrician 1 40 steel channel cover SSe WARNING To prevent wiring damage or abrasion do not expose wiring to edges of sheet metal or other sharp 2 800 URS socket brackets objects Reflector kit is not intended to ba used for damp or wet locations 2 953 lamp holders sockets WARNING Risk of fire or electrical shock Fixture wiring ballast or other alectrical parts may be damaged when 4 8 TEK screws 70E3 A drilling for installation of reflector kit hardware Check for enclosed wiring and components ares in rastenors WARNING Do not make or alter any open holes in an enclosure of wiring or electrical components during kit 2 self tapping loc screws A installation 2 wire connectors l ballast the following considerations should channel end of fixture row spacing ig place opposite bracket in socket covers can ba installed as shown below be made Use only UL Listed Class P t2. hermally protected ballast It should be suitable for lamps lamp holders type It should not exceed voltage and wattage rating Ballast leads should be of proper length to avoid splicing Primary voltage of ballast should ba selected according to supply source valtage 1 Disconnect Power a w a oh Sa e e a steel channel cover 2 Remove and discard lamps existing channel covers socket brackets and ballast Retain only a bare channel and channel end caps Please dispose of lamps and ballast properly and recycle if possible anemee 3 With bare channel now begin installation of new retrofit kit 4 Prewire lamp holders sockets Insert lamp wire leads of new ballast into 953 RS socket wire terminals This should be completed according to the ballast manufacturer s wiring diagram printed on the ballast label 6 Beginning at one end of the channel install appropriate pre wired socket into first 800 URS bracket Using 8 TEK screws attach the bracket flush with the end of the fixture channel 5 Install ballast with sockets attached to leads into channel Make connections of supply wire to ballast using provided wire connectors cooker Cooper Lighting 8 TEK screw self tapping loc screw quarter turn fastener E METALUX P O Box 1207 Americus Georgia 31709 912 924 8000 Fax 912 924 5507 place and attach with 8 TEK screws Spacing between b
3. rackets is 40 Note When converting an 8 section of fixture feed the remaining two pre wired 953 sockets above the bracket Repeat steps 6 and 7 placing center two brackets back to back 8 Using self taping loc screws attach reflector to the steel channel cover 9 Snap quarter turn fasteners into holes at each end of the reflector 10 Attach reflector and steel channel cover to the socket brackets using slots in brackets 11 Remove protective film coating and install lamps 12 Re connect power Note Dimensions and speciications subject to change without notice 041193
Download Pdf Manuals
Related Search