Cooper Lighting McGraw-Edison EPL/HS User's Manual
Contents
1. McGraw Epison EPL HS EPL HSCF EPL DLS Envoy The Architecture of Form amp Light House Side Shield or Drive Lane Shield INSTALLATION INSTRUCTIONS IMPORTANT READ CAREFULLY BEFORE INSTALLING FIXTURE RETAIN FOR FUTURE REFERENCE GENERAL Upon receipt of luminaire thoroughly inspect for any freight WARNING Make certain power is OFF before starting installation or damage which should be brought to the attention of the delivery attempting any maintenance A carrier Compare the catalog description listed on the packing slip WARNING Risk of Electric Shock Disconnect power at fuse or circuit with the luminaire label on the housing to assure you have received the breaker before installing or servicing correct merchandise WARNING Risk of Burn Disconnect power and allow luminaire to cool SAFETY This luminaire must be wired in accordance with the national before changing lamp or handling luminaire electrical code and applicable codes and ordinance Proper grounding WARNING This luminaire is for use with downlight application only is required to insure personal safety Carefully observe grounding WARNING RISK OF FIRE DO NOT mount on or near combustible procedure All work should be done by a qualified electrician materials FAILURE TO FOLLOW INSTRUCTIONS MAY RESULT IN SERIOUS INJURY OR Figure 1 DEATH 9 UPPER REFLECTOR UPPER HOUSE SIDE SHIELD HS ACCESSORY ENVOY PARKING LUMINAIRE INSTALLATION Figure 1 1 Unlatch bot2. ariations in the equipment procedure or process described nor to provide directions for meeting every possible contingency during installation operation or maintenance When additional information is desired to satisfy a problem not covered sufficiently for user s purpose please contact your nearest representative NOTE Specifications and dimensions subject to change without notice Customer First Center 1121 Highway 74 South Peachtree City GA 30269 770 486 4800 FAX 770 486 4801 ADH080774 COOPER Lighting
3. h latches to allow lens to swing open CAUTION Support the lens while it swings open 2 Install upper HS on the upper reflector on the side where light is to be ie AN shielded with provided 6 32 screws Note Maximum quantity of 2 sets of house side shield may be used for a total coverage of 180 LENS LATCH BOTTOM HOUSE SIDE SHIELD HS OR DRIVE LANE SHIELD DLS ACCESSORY ENVOY PARKING LUMINAIRE INSTALLATION 6 32 SCREW i PREE HA 1 Unlatch both latches to allow lens to swing open CAUTION Support the lens while it swings open Note Detach lens from die cast housing if necessary by removing 8 32 screw and retainer Figure 3 BOTTOM HS RETAINER okena CAUTION Support the lens while removing screw and retainer ora MAIN REFLECTOR 2 Run wire retainers behind the main reflector on the side where light is to be shielded Figure 2 3 Slide bottom HS or DLS onto bottom hook of wire retainers Note Curve of shield should follow inside contour of lens Figure 2 4 Hook top wire retainers to the top edge of main reflector Figure 2 Note Drive lane shield accessory is normally positioned in center of lens in Borini line with drive lane Two 2 shields may be used for 2 way driving For OR GLARE SHIELD 1 way driving shield should be placed on side towards on coming traffic Figure 2 Figure 3 RETAINER These instructions do not claim to cover all details or v
Download Pdf Manuals
Related Search