Cooper Lighting IMI-699 User's Manual
Contents
1. IMPORTANT READ CAREFULLY BEFORE INSTALLING FIXTURE RETAIN FOR FUTURE REFERENCE LUMARK Impact Wall Medium Thru Wiring SC Option INSTALLATION INSTRUCTIONS GENERAL Upon receipt of the fixture thoroughly inspect for any freight SAFETY This fixture must be wired in accordance with the National damage which should be brought to the attention of the delivery carrier Electrical Code and applicable local codes and ordinances Proper Compare the catalog description listed on the packing slip with the grounding is required to insure personal safety Carefully observe fixture label on the housing to assure you have received the correct grounding procedure under installation section material WARNING Risk of Fire Shock If not qualified consult an electrician Risk of Electric Shock Disconnect power at fuse or circuit breaker panel or fuse box before installing or servicing NOTE This instruction sheet is applicable for both Trapezoid and Cylinder shapes Trapezoid shape is used for illustration THROUGH WIRING ASSEMBLY NOTE Through Wires should be rated for minimum 140 C with 320 400W fixture and minimum of 120 C with 250W and below Reflector 1 Open the door by unscrewing two 2 door screws If lamp is installed carefully unscrew it Remove the reflector by unscrewing four 4 reflector mounting screws FIG 1 2 Supply wires should now be accessible Carefully pull the three 3 supply wires in through the2. presentative NOTE Specifications and dimensions subject to change without notice Customer First Center 1121 Highway 74 South Peachtree City GA 30269 770 486 4800 FAX 770 486 4801 ADH081515 COOPER Lighting
3. rubber plug while holding the plug to make sure it does not pop 4 10 24 x 3 8 inside the housing Phillips Pan Head Screws 3 Line up the two 2 larger holes in the bracket provided with two 2 existing holes in the back casting With existing holes lined up drill four 4 0 166 Diameter holes in back casting FIG 2 4 Install the bracket provided with four 4 thread forming screws into the back casting covering the rubber plug 5 Unscrew the two 2 conduit plugs provided on the side of housing FIG 3 Screw in the 3 4 conduit 6 Bring in through wiring from conduit and use provided wire ties to route the wiring in fixture FIG 3 7 Follow mounting instructions provided in IMI 697 to complete installation 5 Wire ties for Thru Wiring 2 Screws in a a p Y E li 7 h T l m Conduit Plug reS on Si RTPA TTT z l provided by others 2 Wire ties for Line up these holes Thru Wiring in bracket with two 2 back casting holes Once bracket is line up drill four 4 holes into back casting 2 2 Screws in Conduit Plug These instructions do not claim to cover all details or variations in the equipment procedure or process described nor to provide directions for meeting every possible contingency during installation operation or maintenance When additional information is desired to satisfy a problem not covered sufficiently for user s purpose please contact your nearest re
Download Pdf Manuals
Related Search