Cooper Lighting IMI-654 User's Manual
Contents
1. Pole Application WARNING Do not use fixtures on poles or tennons smaller than noted below Insure that upper most set screws engage the tenon pole Fixture Type Fitter Type Pole Insert Depth Medium Epic Spider Mouni Large Epic Spider Mount AUXILLIARY GROUND POLE CAP TERMINAL BLOCK TERMINAL BLOCK SERVICE WIRES SET SCREWS These instructions do not claim to cover all details or variations in the equipment procedure or process described nor to provide directions for meeting every possible contingency during installation operation or maintenance When additional information is desired to satisfy a problem not covered sufficiently for user s purpose please contact your nearest representative COOPER Lighting Customer First Center e 1121 Hwy 74 South Peachtree City GA 30269 IMl 654 AVU0711352. INY LE Epic ene INSTALLATION INSTRUCTIONS IMPORTANT Read carefully before installing fixture Retain for future reference General Upon receipt of fixture thoroughly inspect for any Safety This fixture must be wired in accordance with freight damage which should be brought to the attention of the national electrical code and applicable local codes the delivery carrier Compare the catalog description listed and ordinance Proper grounding is required to insure on the packing slip with the fixture label on the housing to personal safety Carefully observe grounding procedure assure you have received the correct merchandise under installation section All work should be done by a qualified electrician WARNING Risk of Electric Shock Disconnect power at fuse or circuit breaker before installing or servicing Remove Pole Cap and let hang from fitter Position the service wires to feed through the bottom of the arm Fig 1 Slip the arm onto the pole feeding the service wire leads to the interior of the arm Fig 2 Connect the service wires lead to the terminal block Install the Pole Cap and tighten the 8 set screws provided Rotate and position the arm on the pole so the street side and the fixture side are facing the correct direction The street side label is located on the inside of the reflector Fig 2 Tighten and make sure that locite is applied to the 6 SS set screws provided located at the base of the arm Fig 2
Download Pdf Manuals
Related Search