Coleman 9232C179 User's Manual
Contents
1. Coleman WEATHERMASTER 17 X9 Instructions apply to Part Number 9232C179 Chain shock corded When You Are Ready To POLE ASSEMBLY PARTS S Set Up Your Tent Center Curved Roof Poles sss gt Select a level campsite clear kee Cnet a a End Curved Roof Poles lt amp Sya a other Blue Sticker Part No 9232 303 lt h De nepsciupyourieni Center Brace Poles GSES inder arses Red Sticker Part No 92328304 OEE For best results in windy SS SS conditions position the end End Brace Poles of tent into the wind Blue Sticker Part No 9232B305 C See owners manual for NN rE pa Awning Poles e Green Sticker Part No 9232 306 Sn gt C 1 Rainfly Part No 9232A307 Layout amp Positioning of Tent a area Layout and position tent with door Roof Sleeve properly staked facing desired direction illus 1 Stake down tent starting with the corners Do not stretch too tight Angle the Stakes slightly toward the tent illus 2 Keep the floor taut Illus 1 Front Door Unzip the door Assemble amp Place Roof Poles Forms an arch Assemble all shock corded Roof Poles When assembled will pi Sanin dace ak non Illus 3 Curved Roof Pole assembly Select Center Roof Poles with Red stickers and square ends Then insert them through the two center roof sleeves illus 4 Select End Roof Poles with Blue stickers and round ends Then insert them through the roof sl2. REMOVED BY PULLING ON THE STAKE ITSELF NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER DURING STORAGE Seam sealer has not been provided with your tent It is necessary and we recommend seam sealing your tent prior to camping Seam sealer may be pur chased through your local retailer or at your local sporting goods store Rev 7 01 Do not leave your tent set up for weeks at a time be aware that exposure to the ultraviolet rays of the sun can seriously damage nylon material and or cause it to become discolored WARNING KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC This tent meets the flammability requirements of CPAI 84 The fabric may burn left in continuous contact with any flame source The application of any foreign substance to the tent fabric may render the flame resistant properties ineffective THE COLEMAN CO INC 3600 N Hydraulic e Wichita Kansas 67219 1 800 835 3278 www coleman com
3. Rainfly over tent and attach S poles illus 11 Awning can be tied down over the tent door for added protection from wind and rain Awning should be rolled back or tied down in winds and rain ae illus 9 Tent shown hooks on Rainfly into holes in brace completely set up illus 6 When attaching the Brace poles to the Curved Poles make sure that the Brace poles naturally point straight down illus 5 Shown with both Center Brace Poles in position and Curved poles through both center pole sleeves Center Brace Pole illus 8 Insert Squeeze Pin into pole Awning Plastic O Ring MD Awning Pole Brace Pole with hole for Rainfly S hooks illus 11 Stake out awning poles with adjustable Guy Lines Slide the metal disc up the rope to tighten Guy Line Things You Should Know Under certain conditions cold weather high humidity etc condensation will form on the inside surfaces of your tent Condensation is caused by water vapor from your breath perspiration or any wet clothing inside your tent It is NOT LEAKAGE through the tent fabric It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent Never store tent even for a short period of time without drying it thoroughly and brushing off caked dirt Do not pack stakes or poles inside your tent Use separate stor age bag STAKES SHOULD BE
4. eeves at each end of the tent illus 4 Illus 4 Curved Roof Pole system shown inserted through pole sleeves Square end red sticker poles go into two center pole sleeves Round end blue sticker poles go into two end pole sleeves Shock corded poles J Pole Sleeves Raise Center of Tent Assemble center shock corded brace poles red sticker longer poles Pole should be initially adjusted to the inner most hole A illus 7 Insert square end of brace poles into curved roof poles and raise tent upright illus 5 6 7 Brace poles C B A illus 7 Poles should be initially adjusted to the inner most hole A should attach to squeeze pins at bottom of tent Illus 5 Raise Sides of Tent Assemble end blue sticker round ends shock corded Brace Poles Insert blue sticker Brace Poles into end roof assemblies MAKE SURE when attaching the Brace poles to the curved poles the bottom of the Brace pole naturally points down and toward the center of the tent illus 9 Brace poles should attach to squeeze pins at bottom of tent Can be adjusted to accomodate terrain Assemble Awning Poles Tie a loop on the non adjustable end of Guy Line Remove Rubber Tip insert Awning Poles into plastic O ring at end of awning and place loop of Guy Line over pole tips illus 10 Replace eran Rubber Tip Goad Stake out Guy Lines from awning corners illus 11 Drape
Download Pdf Manuals
Related Search